1997 FORD ASPIRE boot

186
*
[MC61900(ALL)01/97]
Removing the headlamp bulb
*
[MC62000(ALL)01/96]
1. Make sure that the headlamp knob is in the
OFF position.
*
[MC62100(ALL)01/96]
2. Lift the hood and find the bulb in the
headlamp socket.
[MC62200(ALL)01/96]
3. Remove the electrical connector from the
bulb housing by pushing the locking tabs on
either side and pulling out the connector.
[MC62300(ALL)01/96]
4. Remove the retaining ring by turning it 1/8
of a turn to free it from the socket. Then
slide the ring off.Keep the ring.You must
use it again to hold the new bulb in place.
[MC62400(ALL)01/96]
5. Remove the rubber boot. Save it because
you'll need it to cover the new bulb.
[MC62500(ALL)01/96]
6. Release the metal retaining clip that holds
the bulb in place.
[MC62600(ALL)01/96]
7. Carefully remove the bulb assembly from its
socket by gently pulling the assembly
rearward without turning.
File:11icmcf.ex
Update:Tue Mar 4 08:57:16 1997

188
*
[MC62900(ALL)01/97]
Installing the headlamp bulb
[MC62950(ALL)01/96]
1. Insert the glass end of the bulb assembly
into the socket.
[MC63000(ALL)01/96]
2. Secure the bulb assembly in place with the
metal retaining clip.
[MC63100(ALL)01/96]
3. Attach the rubber boot over the bulb
assembly.
[MC63200(ALL)01/96]
4. Slip the bulb retaining ring over the boot
and bulb assembly. Lock the ring into the
socket by rotating it clockwise until you feel
a ªstopº.
[MC63300(ALL)01/96]
5. Push the electrical connector into the rear of
the bulb assembly until it locks into position.
[MC63400(ALL)01/96]
6. Turn the headlamps on and make sure they
work properly. If the headlamp was
correctly aligned before you changed the
bulb, you should not need to align it again.
File:11icmcf.ex
Update:Tue Mar 4 08:57:16 1997