1997 FORD ASPIRE brake

94
*
[TO05500(ALL)01/96]
3.If you have an automatic transaxle, make
sure that the gearshift is in P (Park) and the
parking brake is set before you turn the key.
*
[TO05600(ALL)01/96]
If you have a manual transaxle, make sure
that the parking brake is fully set, push the
clutch pedal to the floor, and put the
gearshift into Neutral before you turn the
key.(Remember, the starter will operate
only if the clutch pedal is pushed all the
way to the floor.)
*
[TO05800(ALL)02/96]
Before you start your vehicle, you should test
the warning lights on the instrument panel to
make sure that they work. Refer to the
Instrumentationchapter.
%*
[TO06000(ALL)01/96]
Starting Your Engine
*
[TO06100(ALL)01/96]
To start your engine:
*
[TO06300(ALL)01/96]
1. Follow the steps underPreparing to Start
Your Vehicleat the beginning of this section.
*
[TO06320(ALL)01/96]
2. Keep your foot on the brake pedal and turn
the ignition key to the ON position.
*
[TO06330(ALL)01/96]
3. DO NOT depress the accelerator pedal when
starting your engine. DO NOT use the
accelerator while the vehicle is parked.
*
[TO06340(ALL)01/96]
4. Turn the key to the START position
(cranking) until the engine starts. Allow the
key to return to the ON position after the
engine has started.
*
[TO06400(ALL)01/96]
If you have difficulty in turning the key,
rotate the steering wheel slightly because it
may be binding.
File:08ictof.ex
Update:Tue Mar 4 08:54:32 1997

95 %
*
[TO06800(ALL)01/96]
For a cold engine:
*
[TO06810(ALL)01/96]
q
At temperatures10ÊF (-12ÊC) andbelow:If
the engine does not start infifteen (15)
secondson the first try, turn the key to OFF,
wait approximately ten (10) seconds so you
do not flood the engine, then try again.
*
[TO06820(ALL)01/96]
q
At temperaturesabove10ÊF(-12ÊC):If the
engine does not start infive (5) secondson
the first try, turn the key to OFF, wait
approximately ten (10) seconds so you do not
flood the engine, then try again.
%*
[TO06830(ALL)01/96]
For a warm engine:
*
[TO06840(ALL)01/96]
q
Do not hold the key in the START position
for more thanfive (5) secondsat a time. If
the engine does not start within five (5)
seconds on the first try, turn the key to the
OFF position. Wait a few seconds after the
starter stops, then try again.
*
[TO06843(ALL)01/96]
Whenever you start your vehicle, release the key
as soon as the engine starts. Excessive cranking
could damage the starter.
*
[TO06845(ALL)01/96]
After starting, allow the engine to idle for a few
seconds before driving away.
*
[TO06847(ALL)03/96]
NOTE: Automatic transaxle equipped vehicles
have an interlock that prevents you
from shifting out of P (Park) unless
your foot is on the brake pedal.
File:08ictof.ex
Update:Tue Mar 4 08:54:32 1997

97
*
[TO08500(ALL)01/96]
WARNING
Do not park, idle, or drive your vehicle in
dry grass or other dry ground cover. The
emission system heats up the engine
compartment and exhaust system, which
can start a fire.
%*
[TO08600(ALL)01/96]
Using the Engine Block Heater
(If equipped)
*
[TO08610(ALL)01/96]
Engine block heaters are strongly recommended
if you live in a region where temperatures reach
-10ÊF (-23ÊC) orbelow. An engine block heater
warms the engine coolant, which improves
starting, warms up the engine faster, and allows
the heater-defrost system to respond quickly.
*
[TO08620(ALL)01/96]
To turn the heater on, simply plug it into a
grounded 110-volt outlet. Ford recommends that
you use a 110-volt circuit that is protected by a
ground fault circuit interrupter.
*
[TO08650(ALL)01/96]
WARNING
To prevent electrical shock, do not use
your heater with ungrounded electrical
systems or two-pronged (cheater) adapters.
*
[TO08670(ALL)01/96]
For best results, plug the heater in at least three
hours before you start your vehicle. Using the
heater for longer than three hours will not
damage the engine, so you can plug it in at
night to start your vehicle the following
morning.
*
[TO08700(ALL)04/96]
Shift-lock System (If equipped)
*
[TO08800(ALL)04/96]
For your safety, the automatic transaxle has a
shift-lock system, which prevents shifting the
transaxle out of the P (Park) position without
depressing the brake pedal when the ignition
key is in the ON position.
File:08ictof.ex
Update:Tue Mar 4 08:54:32 1997

98
*
[TO08900(ALL)03/96]
To shift the transaxle out of the P (Park)
position:
*
[TO09000(ALL)03/96]
1. Depress and hold the brake pedal.
*
[TO09050(ALL)03/96]
2. Start the engine.
[TO09060(ALL)01/96]
3. Push in the thumb lock button and move the
gearshift lever.
[TO09070(ALL)01/96]
4. SeeEmergency Override Systemlater in this
section for more information.
*
[TO09100(ALL)03/96]
NOTE: When the ignition key is in the ACC
or LOCK position, the transaxle cannot
be shifted from the P (Park) position.
If the brake pedal is repeatedly
depressed and released when the
ignition is in the ON position and the
selector lever is in the P (Park)
position, a chattering near the gearshift
lever may be heard. This is not a
malfunction.
*
[TO09200(ALL)03/96]
NOTE: Your vehicle's gearshift lever is
securely latched in P (Park) if you
cannot move it without pushing in the
thumb button. Keep the brake pedal
depressed while moving your gearshift
lever.
*
[TO09300(ALL)03/96]
To make the system more effective, the ignition
key cannot be removed unless the gearshift
selector lever is in the P (Park) position.
File:08ictof.ex
Update:Tue Mar 4 08:54:32 1997

100
*
[TO09450(ALL)03/96]
3. Push and hold the thumb button.
*
[TO09460(ALL)01/96]
4. Move the gearshift lever.
*
[TO09470(ALL)03/96]
If you need to shift out of P (Park) by using the
alternate procedure described above, it is
possible that a fuse has blown and that your
brakelamps may also not be functional. Please
refer to the chapter titledRoadside Emergenciesin
this Owner Guide for instructions on checking
and replacing fuses.
*
[TO09480(ALL)03/96]
WARNING
DO NOT DRIVE YOUR VEHICLE UNTIL
YOU VERIFY THAT THE BRAKELAMPS
ARE WORKING.
%
*
[TO09500(ALL)01/96]
If the Engine Cranks but Does
Not Start or Does Not Start After
a Collision
[TO09520(ALL)02/96]
If the engine cranks but does not start or does
not start even after a small collision, the fuel
pump shut-off switch may have been activated.
The shut-off switch is a device intended to stop
the fuel pump when your vehicle has been
involved in a major jolt.
*
[TO09530(ALL)03/96]
Once the shut-off switch is activated, you must
reset the switch by hand before you can start
your vehicle.
[TO09540(ALL)01/96]
The reset switch on your vehicle is located in a
small compartment on the left side of the
luggage compartment.
File:08ictof.ex
Update:Tue Mar 4 08:54:32 1997

104
*
[TO30000(ALL)03/96]
Removing the Key From the
Ignition
*
[TO30100(ALL)01/96]
1. Put the gearshift selector lever in P (Park)
(automatic transaxle) or 1 (First) (manual
transaxle).
*
[TO30200(ALL)01/96]
2. Set the parking brake fully.
[TO30300(ALL)01/96]
3. Push the key in (manual transaxle) and turn
it to the LOCK position.
*
[TO30400(ALL)03/96]
4. Remove the key.
*
[TO30500(ALL)01/96]
WARNING
Always set the parking brake fully and
make sure that the gearshift is securely
latched in P (Park) (automatic transaxle) or
in 1 (First) (manual transaxle).
*
[TO30600(ALL)03/96]
WARNING
Do not leave children, unreliable adults,
or pets unattended in your vehicle.
File:08ictof.ex
Update:Tue Mar 4 08:54:32 1997

105
Driving
%*
[GF01000(ALL)05/96]
Brakes
%*
[GF01300(ALL)01/96]
Applying the Brakes
[GF01500(ALL)01/96]
Your vehicle is equipped with a power front
disc/rear drum brake system that adjusts
automatically as the brake pads and linings
wear.
[GF01700(ALL)01/96]
If power assist is lost you can still stop your
vehicle by applying greater force to the brake
pedal than you normally would. The stopping
distance, however, is longer.
[GF01800(ALL)01/96]
When the engine is not running or has stalled,
the power assist is interrupted. The reserve
brake power is partially depleted each time the
brake pedal is applied and released. Do not
pump the brake pedal when the power assist
has been interrupted, unless it is necessary to
maintain steering control on slippery surfaces.
*
[GF02000(ALL)01/96]
Apply the brake pedal gradually. Use the
ªsqueezeº technique Ð push on the brake pedal
with a steadily increasing force. This allows the
wheels to continue to roll while you are slowing
down, which lets you steer properly.
[GF02100(ALL)01/96]
Extreme braking can make the wheels lock and
slide, causing you to lose control of the steering.
If you lock the wheels, release the brake pedal
and repeat the ªsqueezeº technique.
*
[GF02200(ALL)01/96]
Do not drive with your foot resting on the brake
pedal; you will wear out the linings and increase
your vehicle's stopping distance. Brake rotor
damage may also eventually occur.
File:09icgff.ex
Update:Tue Mar 4 08:54:55 1997

106
*
[GF02300(ALL)02/96]
NOTE: If you are driving down a long or
steep hill, shift to a lower gear and do
not apply your brakes continuously. If
you apply your brakes continuously,
they may overheat and become less
effective.
[GF02400(ALL)02/97]
Occasional brake noise is normal and does not
indicate a performance concern with the vehicle's
brake system. In normal operation, automotive
brake systems may emit occasional or
intermittent squeal or groan noises when the
brakes are applied. Such noises are usually
heard during the first few brake applications in
the morning; however, they may be heard at any
time while braking and can be aggravated by
environmental conditions such as cold, heat,
moisture, road dust, salt or mud. If a
ªmetal-to-metalº or ªcontinuous grindingº sound
is present while braking, the brake linings may
be worn-out and should be inspected by a
qualified service technician.
[GF03000(ALL)01/96]Anti-lock Brake System (ABS)
(If equipped)
[GF03050(ALL)02/97]
On vehicles equipped with an antilock braking
system (ABS), a noise from the hydraulic pump
motor and pulsation in the pedal may be
observed during ABS braking events. Pedal
pulsation coupled with noise while braking
under panic conditions or on loose gravel, wet
or snowy roads is normal and indicates proper
functioning of the vehicle's antilock brake
system. If the vehicle has continuous vibration or
shudder while braking, felt mainly in the
steering wheel, the vehicle most likely needs
service.
[GF03100(ALL)01/96]
The Anti-lock Brake System (ABS) prevents the
brakes from locking up. Whenever your wheels
start to lock during maximum braking, the
File:09icgff.ex
Update:Tue Mar 4 08:54:55 1997