1997 FORD AEROSTAR ignition

51
*
[AS07035(ALL)06/96]
1. Select a band, then select a frequency.
*
[AS07037(ALL)06/96]
2. Press one of the memory preset buttons and
hold the button until the sound returns. That
station is now held in memory on that
button.
*
[AS07040(ALL)06/96]
3. Follow the two steps above for each station
memory preset button you want to set.
*
[AS07045(ALL)06/96]
NOTE: If the vehicle's battery is disconnected,
the clock and station memory preset
buttons (if programmed in auto mode)
will need to be reset.
[AS07050(ALL)05/96]
Using the Controls of Your Cassette Tape
Player (If equipped)
*
[AS07075(ALL)08/95]
How to insert a tape
*
[AS07100(ALL)08/95]
Insert a cassette (with the open edge to the
right) firmly into the tape door opening, making
sure the cassette is completely in and ªseated.º
*
[AS07125(ALL)08/95]
NOTE: A cassette tape can be loaded with the
ignition on whether or not the radio
power is on.
*
[AS07150(ALL)12/95]
How to locate a desired track on the tape
*
[AS07175(ALL)08/95]
q
Using the Automatic Music Search (ªAMSº)
[AS07200(ALL)09/95]
Press and hold the ªAMSº button (ªAMSº
will appear in the display). Then, push the
left (
h) button to rewind to the beginning
of the current selection or press the right
(
g) button to fast forward to the beginning
of the next selection.
*
[AS07225(ALL)08/95]
q
How to change the side of the tape being
played
[AS07250(ALL)09/95]
The alternate track (other side) of the tape
can be selected at any time by pushing both
fast-wind buttons (
hand
g) at the
same time.
File:04cpasa.ex
Update:Fri Jun 7 14:24:14 1996

55 [AS07775(ALL)08/95]
NOTE: Rear seat control volume can be set no
higher than current radio setting unless
speakers are turned off. See note under
How to turn the speakers on and off.
*
[AS07780(ALL)06/95]
Setting the AM or FM frequency band
*
[AS07785(ALL)06/95]
Push the ªBANDº button to change the
frequency band.
*
[AS07790(ALL)06/95]
Using the ªMEMORYº button
*
[AS07795(ALL)06/95]
Push the ªMEMORYº button to access the
station you have set into memory button 1 on
the face of the radio. Successively pushing this
button will access, numerically, all stations set
into the Station Memory Preset buttons (1
through 5).
*
[AS07800(ALL)06/95]
How to turn the speakers on and off
*
[AS07805(ALL)06/95]
When the rear seat controls are on, push the
ªSPKRS ON-OFFº button to turn all speakers
off. Push again to turn all speakers on.
[AS07810(ALL)09/95]
NOTE: Turning the ignition off then on again
will not turn the speakers back on, if
previously turned off by the ªSPKRS
ON-OFFº button on the rear seat
controls.
*
[AS07815(ALL)06/95]
Using the ªSEEKº function
[AS07820(ALL)08/95]
Press the right (
a) side of the ªSEEKº rocker
switch to seek to the next radio station. Press the
left (
b) side of the ªSEEKº rocker switch to
seek to the previous radio station.
*
[AS07825(ALL)09/95]
NOTE: When using the rear seat controls with
a High-Level Audio System, the
ªSEEKº function on the rear seat
controls will also function with
cassettes, seeking the next (ªSEEK
aº)
or previous (ª
bSEEKº) selection on
the tape.
File:04cpasa.ex
Update:Fri Jun 7 14:24:14 1996

62 % [CF00160(ALL)04/96]Air Conditioner and Heater (If equipped)
[CF00170(ALL)01/96]
The control for your air conditioner and heater
system is located near the center of the
instrument panel and operates only when the
ignition key is turned to the ON position. Your
air conditioner and heater heats or cools your
vehicle interior depending on the function and
the temperature you select. The right knob is the
SELECT knob which allows you to select heating
or cooling and determine where the air will be
directed. The TEMP knob setting determines the
temperature of the air that flows into the
vehicle.
[CF00180(ALL)01/96]
one third page art:0095031-A
Climate control knobs
[CF00190(ALL)01/96]
To turn your air conditioner and heater system
on, rotate the SELECT knob to any position
except OFF. This will turn the fan on and allows
airflow into the vehicle.
*
[CF00200(ALL)03/96]
Temperature selection
[CF00210(ALL)01/96]
The TEMP knob is the rotating knob located at
the center of the control with tapered red and
blue bands surrounding most of the knob. The
wide red part of the band (full right) is the heat
area. The wide blue area (full left) is the cooling
temperature area. Any position selected between
full right and full left will give a temperature
between the two extremes except in MAX A/C.
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

65 % [CF00380(ALL)04/96]
Standard Heater
[CF00390(ALL)01/96]
The control for your heater system is located
near the center of the instrument panel and
operates only when the ignition key is turned to
the ON position. The heater heats and/or
ventilates your vehicle interior depending on the
function and temperature you select. The right
knob is the SELECT knob which allows you to
select heating or ventilation and determine
where the air will be directed. The TEMP knob
setting determines the temperature of the air
that flows into the vehicle.
[CF00400(ALL)01/96]
one third page art:0095032-A[CF00410(ALL)01/96]
one third page art:0095033-A
Climate control knobs (heater only)
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

73 [CF01240(ALL)05/96]
two third page art:0021014-B
High-mount brakelamp
%*
[CF01250(ALL)01/96]
Illuminated Entry System (If equipped)
[CF01260(ALL)01/96]
If your vehicle is equipped with this option, the
interior courtesy lamps and dome lamp will
light when either outside front door handle is
raised. They will turn off automatically after
approximately 25 seconds or when the ignition
key is turned to ON or ACC.
*
[CF01320(ALL)01/96]
Radio
*
[CF01330(ALL)01/96]
For information about the radio in your vehicle,
refer to theElectronic Sound Systemschapter in
this Owner Guide.
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

74
*
[CF01340(ALL)01/96]
Clock Controls on Electronic
Radios
[CF01345(ALL)04/96]
The electronic radios have a built-in clock. For
complete operating instructions, refer to the
Electronic Sound Systemschapter in this Owner
Guide.
*
[CF02100(ALL)01/96]
Ignition
%*
[CF02110(ALL)01/96]
Understanding the Positions of the Ignition
*
[CF02120(ALL)01/96]
quarter page art:0020004-B
The positions of the key in the ignition lock cylinder.
%*
[CF02130(ALL)04/96]
ACCESSORY allows some of your vehicle's
electrical accessories such as the radio and the
windshield wipers to operate while the engine is
not running.
*
[CF02135(ALL)01/96]
LOCK locks the steering wheel and gearshift
lever.
*
[CF02140(ALL)01/96]
LOCK is the only position that allows you to
remove the key. The LOCK feature helps to
protect your vehicle from theft.
*
[CF02150(ALL)01/96]
If your key is stuck in the LOCK position and
will not turn, move your steering wheel left or
right until the key turns freely.
*
[CF02160(ALL)01/96]
OFF allows you to shut off the engine and all
accessories without locking the steering wheel or
the automatic transmission gearshift lever.
*
[CF02170(ALL)01/96]
ON allows you to test your vehicle's warning
lights (except the brake system warning light) to
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

76corrected as soon as possible, but make sure that
you use the accepted hand signals in the
meantime.
*
[CF03200(ALL)08/95]
High Beams and Flashing the Lamps
[CF03800(ALL)01/96]
one third page art:0095014-A
Headlamp high beam and flash-to-pass operation
%*
[CF04400(ALL)01/96]
Windshield Wipers and Washer
*
[CF04500(ALL)04/96]
To turn on the windshield wipers, the ignition
key must be turned to the ON or ACC position.
[CF04950(ALL)01/96]
one third page art:0095015-A
Interval wiper on turn signal lever Ð wiper and washer
operation
*
[CF05000(ALL)08/95]
To set the interval wipers, rotate the knob at the
end of the turn signal lever toward or away
from the instrument panel to the interval
operation you desire.
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996

80
%*
[CF07300(ALL)03/96]
Speed Control (If equipped)
[CF07700(ALL)01/96]
one third page art:0095006-A
Speed control switches on the steering wheel
%*
[CF07800(ALL)05/96]
To Turn Speed Control Off
[CF07900(ALL)03/96]
Press OFF
[CF07950(ALL)03/96]
OR
[CF08000(ALL)03/96]
Turn off the vehicle ignition.
*
[CF08100(ALL)05/96]
Once speed control is switched off, the
previously programmed set speed will be erased.
*
[CF08150(ALL)05/96]
To Turn Speed Control On
[CF08200(ALL)03/96]
Press ON
*
[CF08250(ALL)05/96]
To Set A Speed
[CF08300(ALL)03/96]
Press the SET ACCEL. For speed control to
operate, the speed control must be ON and the
vehicle speed must be greater than 30 mph
(km/h).
[CF08350(ALL)03/96]
If you drive up or down a steep hill, your
vehicle speed may vary momentarily slower or
faster than the set speed.
*
[CF08400(ALL)05/96]
Speed control cannot reduce the vehicle speed if
it increases above the set speed on a downhill. If
your vehicle speed is faster than the set speed
while driving on a downhill inj(Overdrive),
File:05cpcfa.ex
Update:Mon Jun 24 08:10:35 1996