1997 CHEVROLET TRACKER ECU

6. Find the support bar on the bottom of the seat. This
7. Pull the inner end of the support off of the seat
bar
keeps the rear seat from unfolding.
bracket and swing it down.
To unfold the seat:
Keep your hands, safety belts and other objects away
from where the seat will rest.
1.
8. Attach support bar to the floor bracket.
2.
3.
Pull the support bar out of the floor bracket and
swing it up and toward the bottom of the seat.
Push and secure the support
bar into the bracket on
the bottom
of the seat.
Slowly pull the seat down
to the floor. The seat
should latch into place. Pull up
on the bottom of the
seat to be sure it is locked into position.
1-8
ProCarManuals.com

7. Hook the strap to the floor loop to secure the folded
To raise the rear seat: rear
seat.
I. Unhook the strap from the floor loop and snap it on
the back of the passenger’s side rear seatback.
2. Slowly pull the seat down to the floor until it latches
into place. Pull up on the bottom
of the seat to be
sure it is locked into position.
seatback, pull each seatback up
and push it into
place.
Push and pull the top of the seatback to be
sure it
is locked into position.
3. While pulling the lock knob up on each rear
Safety Belts: They’re for Everyone
This part of the manual tells you how to use safety belts
properly. It also tells you some things you should not do
with safety belts.
And it explains the air bag system.
I I
/! ~km- ,,-Lv:
Don’t let anyone ride where he or she can’t wear
a safety belt properly. If you are in a crash and
you’re not wearing
a safety belt, your injuries
can be much worse. You can hit things inside the
vehicle or be ejected from it. You can be seriously
injured or killed. In the same crash, you might
not be if you are buckled up. Always fasten your
safety belt, and check that your passengers’ belts
are fastened properly too.
1-12
ProCarManuals.com

4. Push the latch plate into the buckle until it clicks.
Pull up on the latch plate to make sure it is secure.
If the belt isn’t long enough, see “Safety Belt
Extender’’ at the end of this section.
Make sure
the release button on the buckle is
positioned
so you would be able to unbuckle the
safety belt quickly if you ever had to.
5. To make the lap part tight, pull down on the buckle
end of the belt
as you pull up on the shoulder belt. The lap
part of the belt should be worn low and snug on
the hips, just touching the thighs. In
a crash, this applies
force to the strong pelvic bones. And you’d be less likely
to slide under the lap belt. If you slid under it, the belt
would apply force at your abdomen. This could cause
serious or even fatal injuries. The shoulder belt should go
over the shoulder and across the chest. These parts
of the
body are best able to take belt restraining forces.
The safety belt locks
if there’s a sudden stop or crash, or
if you pull the belt very quickly out of the retractor.
1-19
1
ProCarManuals.com

Air bags inflate with great force, faster than the
blink of an eye. If you’re too close to an inflating
air bag,
it could seriously injure you. Safety belts
help keep you in position before and during a
crash. Always wear your safety belt, even with air
bags. The driver should sit
as far back as possible
while still maintaining control of the vehicle.
A CAUTION:
An inflating air bag can seriously injure small
children. Always secure children properly in your
vehicle.
To read how, see the part of this manual
called “Children” and the caution label on the
right front passenger’s safety belt.
AIR
BAG
There is an air bag readiness
light on the instrument
panel, which
shows
AIR BAG.
The system checks the air bag electrical system for
malfunctions. The light tells you if there is an electrical
problem. See “Air
Bag Readiness Light” in the Index
for more information.
1-26
ProCarManuals.com

Lap-Shoulder Belt
The rear $&its have lap-shoulder belts. Here’s how to
wear one properly.
1. Pick up the latch plate and pull the belt across you.
Don’t let it get twisted.
The shoulder belt may lock if you pull the belt across
you very quickly.
If this happens, let the belt go back
2. Push the latch plate into the buckle until it clicks.
Pull up on the latch plate to make sure it
is secure.
When the shoulder belt is pulled out
all the way, it will
lock.
If it does, let it go back all the way and start again. If
the belt is not long enough, see “Safety Belt Extender” at
the end
of this section. Make sure the release button on
the buckle is positioned
so you would be able to unbuckle
the safety belt quickly.if you ever had to.
slightly to unlock it. Then pull the belt across you
3. To make the lap part tight, pull down on the buckle
more slowly. end
of the belt as you pull up on the shoulder part.
1-32
ProCarManuals.com

Never hold a baby in your arms while riding in a
vehicle.
A baby doesn't weigh much -- until a
crash. During a crash a baby will become
so
CAUTION: (Continued) heavy you
can't hold it. For example, in a crash
at only 25 mph (40 km/h), a 12-lb.
(5.5 kg) baby
will suddenly become
a 240-1b. (110 kg) force on
your arms. The baby would be almost impossible
to hold.
Secure the baby in an infant restraint.
ProCarManuals.com

Child Restraints
Be sure the child restraint is designed to be used in a
vehicle.
If it is, it will have a label saying that it meets
Federal Motor Vehicle Safety Standards.
Then follow the instructions for the restraint. You may
find these instructions on the restraint itself or in a
booklet, or both. These restraints use the belt system in
your vehicle, but the child also has to be secured within
the restraint to help reduce the chance of personal injury.
The instructions that come with the infant or child
restraint will show you how to do that.
Where to Put the Restraint
Accident statistics show that children are safer if they
are restrained in the rear rather than the front seat. We at
General Motors therefore recommend that you put your
child restraint in the rear seat.
Never put a rear-facing
child restraint
in the front passenger seat. Here’s why:
A child in a rear-facing child restraint can be
seriously injured if the right front passenger’s
air bag inflates. This is because the back of a
rear-facing child restraint would be very close to
the inflating air bag. Always secure
a rear-facing
child restraint in the rear seat.
You may, however, secure
a forward-facing child
restraint in the right front seat. Before you secure
a forward-facing child restraint, always move the
front passenger seat
as far back as it will go. Or,
secure the child restraint in the rear seat.
Wherever you install it, be sure to secure the child
restraint properly.
Keep in mind that an unsecured child restraint can move
around in a collision or sudden stop and injure people
in the vehicle. Be sure to properly secure any child
restraint
in your vehicle -- even when no child is in it.
1-36
ProCarManuals.com

Top Strap
If your child restraint has a top strap, it should be
anchored.
If you have a two-door model, don’t use a
restraint like that in your vehicle because the top strap
anchor cannot be installed properly.
You shouldn’t use
this type of restraint without anchoring the top strap.
If your vehicle is a four-door model and you need to
have an anchor installed, you can ask your Geo dealer to
put one in for you. If you want to install an anchor yourself, your dealer can tell you how to do it. Use the
tether hardware kit available from the dealer. The
hardware and installation instructions were specifically designed for this vehicle.
Securing a Child Restraint in a
Rear Seat Position
You’ll be using the lap-shoulder belt. See the earlier part
about the top strap if the child restraint has one.
1. ht the restraint on the seat. Follow the instructions
for the child restraint.
2. Secure the child in the child restraint as the
instructions say.
1-37
ProCarManuals.com