1997 CHEVROLET TRACKER manual transmission

LOW (L): This position gives you even more power
(but lower fuel economy) than
SECOND (2). You
can use it on very steep hills,
or in deep snow or mud.
If the selector lever is put in LOW (L), the transmission
won’t shift into low gear until the vehicle
is going
slowly enough.
NOTICE:
Don’t shift into LOW (L) at speeds above 40 mph
(65 km/h) with the transfer case in
FOUR-WHEEL LOW (4L), or you can damage
your transmission.
I
I
NOTICE:
If your rear wheels can’t rotate, don’t try to
drive. This might happen if yon were stuck in
very deep sand or mud or were up against
a solid
object. You could damage your transmission.
Also, if you stop when going uphill, don’t hold
your vehicle there with only the accelerator
pedal. This could overheat and damage the
transmission. Use your brakes to hold your
vehicle in position on
a hill.
2-13
I
ProCarManuals.com

Power Mode Selector Switch (If Equipped)
A power mode selector switch is included with the
four-speed automatic transmission. When
you need
more power for climbing hills or quicker acceleration,
press the P (POWER) switch. The POWER indicator
light on the instrument panel comes on. For normal
driving, press the
N (NORMAL) switch. The POWER
indicator light goes
off.
Overdrive Off Switch (If Equipped)
The overdrive off switch is located on the left side of the
shifter.
By operating the overdrive off switch, the
four-speed automatic transmission (three-speed plus overdrive) can be converted to a three-speed automatic
transmission. While in the three-speed mode, the
transmission will not shift into the overdrive position.
To convert the transmission to the three-speed mode,
push in the overdrive
off switch and release it. The
switch comes out and the
OD OFF indicator light on
the instrument panel comes on.
To return the transmission to the four-speed mode, push
in the overdrive
off switch again. The switch will remain
in and the
OD OFF indicator light goes off.
Please note that if the transfer lever is in the
4L position,
the four-speed automatic transmission will remain in the
three-speed mode.
Manual Transmission
5-Speed
This is your shift pattern. Here's how to operate
your transmission:
FIRST (1): Press the clutch pedal and shift into
mRST
(1). Then, slowly let up on the clutch pedal as
you press the accelerator pedal.
2-14
ProCarManuals.com

You can shift into FIRST (1) when you’re going less
than
20 mph (32 kdh). If you’ve come to a complete
stop and
it’s hard to shift into FIRST (l), put the shift
lever in NEUTRAL (N) and let up on the clutch. Press
the clutch pedal back down. Then shift into FIRST
(1).
SECOND (2): Press the clutch pedal as you let up on
the accelerator pedal and shift into SECOND (2). Then,
slowly let up on the clutch pedal as you press the
accelerator pedal.
THIRD (3), FOURTH (4), FIFTH (5): Shift into
THIRD
(3), FOURTH (4) and FIFTH (5) the same way
you do for SECOND
(2). Slowly let up on the clutch
pedal as
you press the accelerator pedal.
To stop let up on the accelerator pedal and press the
brake pedal. Just before the vehicle stops, press the
clutch pedal
and the brake pedal, and shift to
NEUTRAL (N).
NEUTRAL (N): Use this position when you start or
idle your engine.
REVERSE (R): To back up, press down the clutch
pedal and shift into REVERSE (R). Let up on the clutch
pedal slowly while pressing the accelerator pedal.
You cannot go from FIFTH
(5) into REVERSE (R). If
you try, you will be locked out. You must first shift into
NEUTRAL (N), move
the lever to the left, back to the
right, and then shift into REVERSE (R). This is a
safety feature.
I NOTICE: 1
Shift to REVERSE (R) only after your vehicle is
stopped. Shifting to REVERSE (R) while your
vehicle is moving could
damage your
transmission.
~~
Also, use REVERSE (R) along with the parking brake
for parking your vehicle.
2-15
ProCarManuals.com

Shift Speeds
I A CAUTION:
If you skip more than one gear when you
downshift, you could lose control of your vehicle.
And you could injure yourself or others. Don’t
shift from
FIFTH (5) to SECOND (2) or
FOURTH (4) to FIRST (1).
This chart shows when to shift to the next higher gear
for best fuel economy.
~ ~~
If your speed drops below 20 mph (32 km/h), or if the
engine is not running smoothly, you should downshift to
the next lower gear.
You may have to downshift two or
more gears
to keep the engine running smoothly or for
good performance.
ICE:
If you skip more than one gear when you
downshift, or if you race the engine when you
downshift, you can damage the clutch
or
transmission.
2-16
ProCarManuals.com

Automatic
With automatic freewheeling hubs, you don’t have to get
out
of the vehicle to lock or unlock the hubs.
Locking the Hubs
1. Stop your vehicle.
2. Shift the transfer case to FOUR-WHEEL
HIGH
(4H) or FOUR-WHEEL LOW (4L).
3. Drive slowly forward and the hubs will lock.
Unlocking the Hubs
1. Stop your vehicle.
2. Then, press the clutch if you have a manual
transmission, and shift the transfer case to
TWO-WHEEL HIGH (2H). The hubs will unlock.
3. Drive 7 feet (2 m) in the direction opposite to the
direction you were driving before you stopped.
2-19
ProCarManuals.com

Remember that driving in FOUR-WHEEL HIGH (4H)
or FOUR-WHEEL LOW (4L) may reduce fuel
economy. Also, driving in four-wheel drive on dry
pavement could cause your tires to wear faster and make
your transfer case harder to shift.
You can shift from TWO-WHEEL HIGH (2H) to
FOUR-WHEEL HIGH
(4H) or from FOUR-WHEEL
HIGH (4H) to TWO-WHEEL HIGH (2H) at any speed
if your hubs are locked and your wheels are straight
ahead. Your front axle will engage faster if you take
your foot off the accelerator pedal for a few seconds as
you shift.
Shifting Into or Out of FOUR-WHEEL LOW (4L)
1. Stop your vehicle and shift your transmission to
NEUTRAL (N).
2. Shift the transfer case in one continuous motion.
Don’t pause in NEUTRAL
(N) as you shift into
FOUR-WHEEL
HIGH (4H), or your gears could clash.
To set the parking brake, hold the brake pedal down and
pull
up on the parking brake lever. If the ignition is on,
the brake system warning light will come on.
2-21
ProCarManuals.com

Leaving Your Vehicle With the Engine
Running (Automatic Transmission
Models Only)
I
It can be dangerous to leave your vehicle with the
engine running. Your vehicle could move
suddenly if the shift lever is not fully in
PARK (P)
with the parking brake firmly set. If you have
four-wheel drive and your transfer case is in
NEUTRAL (N), your vehicle will be free to roll,
even if your shift lever is in
PARK (P). So be sure
the transfer case is
in a drive gear -- not in
NEUTRAL (N). And, if you leave the vehicle with
the engine running, it could overheat and even
catch fire. You or others could be injured. Don’t
leave your vehicle with the engine running unless
you have to.
Torque Lock (Automatic Transmission)
If you are parking on a hill and you don’t shift your
transmission into PARK (P) properly, the weight
of the
vehicle may put too much force
on the parking pawl in
the transmission. You may find it difficult to pull the
shift lever out
of PARK (P). This is called “torque lock.”
To prevent torque lock, set the parking brake and then
shift into PARK
(P) properly before you leave the
driver’s seat. To find out how, see “Shifting Into
PARK (P)” in the Index.
When you are ready to drive, move the shift lever out of
PARK
(P) before you release the parking brake.
If torque lock does occur, you may need to have another
vehicle push yours a little uphill to take some of the
pressure from the parking pawl in the transmission,
so
you can pull the shift lever out of PARK (P).
2-24
ProCarManuals.com

Shifting Out of PARK (P)
(Automatic Transmission)
Your Geo has a brake-transmission shift interlock. You
have to fully apply your regular brakes before you can
shift from PARK
(P) when the ignition is in the ON
position. See “Automatic Transmission” in the Index.
If you cannot shift out of PARK. (P), ease pressure on
the shift lever
-- push the shift lever all the way into
PARK (P) and release the shift lever button as you
maintain brake application. Then press the shift lever
button and move the shift lever into the gear you wish.
If you ever hold the brake pedal down but still can’t
shift out of PARK
(P), try this:
1. Apply and hold the brake until the end of Step 6.
2. If the engine is running, shut it off. Turn the key to
ON or ACC.
3. Find the access hole cover (A) on the driver’s side of
the console, near the shift lever.
4. Remove the screw (B) and cover (A).
2-25
ProCarManuals.com