1997 CHEVROLET MONTE CARLO seats

Downloaded from www.Manualslib.com manuals search engine Ventilation System
L
Adjust the direction of airflow by moving the
louvered vents.
Your vehicle’s flow-through ventilation system supplies
outside air into the vehicle when it is moving. Outside
air will also enter the vehicle when the air conditioning
fan is running.
Ventilation Tips
0
0
0
0
For mild outside temperatures when little heating or
cooling is needed,
use VENT to direct outside air
through your vehicle.
Keep the hood and front air inlet free
of ice, snow or
any other obstruction, such
as leaves. The heater and
defroster will work far better, reducing the chance
of
fogging the inside of your windows.
When you enter a vehicle in cold weather, set the
mode
to FLOOR and the fan to the highest speed for
a few moments before driving off. This helps clear
the intake ducts
of snow and moisture and reduces
the chance of fogging the inside of your windows.
Keep the air path under the front seats clear of
objects. This helps air to circulate throughout
your vehicle.
Defogging and Defrosting
Your system has two settings for clearing the front and
side windows.
To defrost the windows quickly, use
DEFROST with the temperature knob(s) all the way in
the red area.
To warm passengers while keeping the
windows clean, use
DEFOG.
3-5

Downloaded from www.Manualslib.com manuals search engine A CAUTION:
Things you put inside your vehicle can strike
and injure people
in a sudden stop or turn, or in
a crash.
0
0
e
0
0
Put things in the trunk of your vehicle. In a
trunk, put them as far forward as you can.
Try to spread the weight evenly.
Never stack heavier things, like suitcases,
inside the vehicle
so that some of them are
above the tops of the seats.
Don’t leave an unsecured child restraint in
your vehicle.
When you carry something inside the
vehicle, secure
it whenever you can.
Don’t leave
a seat folded down unless you
need to.
Towing a Trailer
A CAUTION:
I
If you don’t use the correct equipment and drive
properly, you can lose control when you pull
a
trailer. For example, if the trailer is too heavy, the
brakes may not work well
-- or even at all. You
and your passengers could be seriously injured.
Pull
a trailer only if you have followed all the
steps in this section. Ask your Chevrolet dealer
for advice and information about towing a trailer
with your vehicle.
NOTICE:
Pulling a trailer improperly can damage your
vehicle and result in costly repairs not covered
by
your warranty. To pull a trailer correctly, follow
the advice in this part, and see your Chevrolet
dealer for important information about towing a
trailer with your vehicle.

Downloaded from www.Manualslib.com manuals search engine Center High-Mounted Stoplarnp
(Shelf-Mounted)
To reach the center high-mounted stoplamp, you must
go through the trunk.
1. Open the trunk lid. Locate the stoplamp behind the
rear seats, in front
of the trunk hinges.
2. Turn the socket to the left until it stops and pull the
3. Push in the bulb, turn it to the left and pull it out of
bulb and socket out of the assembly.
the socket.
4. Push the new bulb into the socket and turn
it to the right.
5. Replace the bulb and socket in the assembly.
Center High-Mounted Stoplamp
(Spoiler-Mounted)
1. Remove the two screws from the stoplamp assembly.
2. Pull the assembly forward out of the spoiler.
3. Remove the three screws from the back of the
stoplamp assembly.
4. Pull the lamp strip out of the stoplamp assembly.
5. Remove the bulb.
6. Install the new bulb and reverse Steps 1-4.

Downloaded from www.Manualslib.com manuals search engine Fuse
1
4
5
6
10
Circuit
Breaker
C
D
Description
11
12 Power Windows
Power Seats
13
Description
CIGAR LIGHTER -- Instrument
Panel and Console Cigar Lighters
HVAC
-- WAC Control
Assembly Solenoid Box,
Mix Motor, DRL Module,
HVAC Control Head, Blower
Control Switch
HAZARD FLASHER
R.H.
SPOT LAMP (S.E.O.)
I/P ELECTRONICS BATTERY
FEED
-- Chime Module,
Electronic Brake Control Module
(EBCM), Theft-Deterrent
Module, Radio
STARTER RELAY
ANTI-THEFTPCM
--
Theft-Deterrent Module
ABS
-- Electronic Brake Control
Module (EBCM), ABS Relay