Page 224 of 358
Downloaded from www.Manualslib.com manuals search engine When you open the hood on the 3.4L DOHC (Code X) engine, you’ll see:
r
.FA
A. Engine Coolant Reservoir F. Automatic Transaxle -
B. Radiator Fill Cap
C. Power Steering Fluid Reservoir
D. Engine Oil Fill Cap
E. Engine Oil Dipstick Fluid Dipstick
G. Brake
Fluid Reservoir
H. Air Filter
I. Remote Positive
Battery Terminal
J. Windshield Washer
Fluid Reservoir
K. Battery (located under
Windshield Washer Fluid Reservoir)
6-9
Page 246 of 358

Downloaded from www.Manualslib.com manuals search engine Also, for your audio system, see “Theft-Deterrent
Feature” in the Index.
Bulb Replacement
In this section you’ll find directions for changing the
bulbs in some of the lamps on your Chevrolet. See
“Replacement Bulbs” in the Index to find the type of
bulb you should use.
Halogen Bulbs
Halogen bulbs have pressurized gas inside and
can burst
if you drop or scratch the bulb. You or
others could be injured. Be sure to read and
follow the instructions
on the bulb package.
Headlamps
1. Open the hood.
2. Press and turn the base a quarter-turn (to the left for the \
driver’s side; to
the right for the passenger’s side) and
remove it from the retaining ring by gently pulling it back
and away from the headlamp.
-
3. Remove the electrical connector from the bulb by
raising the lock tab and pulling the connector away
from the bulb’s base.
4. Install the electrical connector to the bulb.
5. Install the new bulb by inserting the smallest tab on
the bulb base into the matching notch in the retaining
ring. Turn the bulb a quarter-turn to the right until
it stops.
6. Close the hood.
Page 247 of 358
Downloaded from www.Manualslib.com manuals search engine Front Park and lbrn Signal Lamp -
2. Open the flap by lifting the snap screw.
1. Open the hood. There is one flap on each side of
the radiator.
6-32
Page 272 of 358

Downloaded from www.Manualslib.com manuals search engine Power Windows and Other Power Options
Circuit breakers in the fuse panel protect the power
windows and other power accessories. When the current
load is too heavy, the circuit breaker opens and closes,
protecting the circuit until the problem
is fixed.
Fuses and Circuit Breakers
The wiring circuits in your vehicle are protected from
short circuits by a combination of fuses, circuit breakers,
and fusible thermal links in the wiring itself. This
greatly reduces the chance of fires caused by
electrical problems.
Look at the silver-colored band inside the fuse. If the
band is broken or melted, replace the fuse. Be sure you
replace a bad fuse with a new one of the identical size
and rating.
Instrument Panel Fuse Block
Some fuses are in a fuse
block on the passenger’s
i side of the instrument panel.
Pull off the cover labeled
FUSES to expose the fuses.
Additional fuses are in the underhood electrical centers
on the right and left sides of the engine compartment.
Page 319 of 358

Downloaded from www.Manualslib.com manuals search engine At Least %ice a Year Automatic Transaxle Check
Restraint System Check
Make sure the safety belt reminder light and all your
belts, buckles, latch plates, retractors and anchorages are
working properly. Look for any other loose or damaged
safety belt system parts. If you see anything that might
keep a safety belt system from doing its job, have
it
repaired. Have any torn or frayed safety belts replaced.
Also look
for any opened or broken air bag coverings,
and have them repaired or replaced. (The air bag system
does not need regular maintenance.)
Wiper Blade Check
Inspect wiper blades for wear or cracking. Replace blade
inserts that appear worn or damaged or that streak or
miss areas of the windshield. Also see “Wiper Blades,
Cleaning” in the Index. Check the transaxle
fluid level;
add if needed. See
“Automatic Transaxle” in the Index. A fluid loss
may indicate a problem. Check the system and repair
if needed.
At Least Once a Year
Key Lock Cylinders Service
Lubricate the key lock cylinders with the lubricant
specified
in Part D.
Body Lubrication Service
Lubricate all hinges and latches, including those for the
hood, rear compartment, glove box door, console door
and any folding seat hardware. Part
D tells you what to
use. More frequent lubrication may be required when
exposed
to a corrosive environment.