1997 CHEVROLET CAMARO ABS

Downloaded from www.Manualslib.com manuals search engine 2. The aiming ring will swing open like a gate. Remove
the aiming ring from the assembly. Place it face
down, with the aim indicator up.
Be careful not to
damage the aiming bubble.
3. Pull the headlamp out of the assembly. Remove the
wiring connector from the headlamp socket by lifting
the plastic locking tabs on the connector and pulling
it from the socket.
6-44

Downloaded from www.Manualslib.com manuals search engine 4. Check the new headlamp again. The number on the
lamp must match the number
of the headlamp being
replaced. The letter
U or L must also match.
5. Plug the wiring connector into the headlamp socket.
6. Place the new headlamp in the headlamp assembly.
Snap
the locking tabs onto the socket.
The socket must be pointing in the same direction
the socket
on the burned out bulb was.
7. Insert the tabs on the aiming ring into the tabs in the
8. Hold the aiming ring closed, insert the screws at the
end
of the ring. Tighten the screws until the aiming
ring touches the plastic nuts on both the top and
bottom.
Do not overtighten. Do not damage the
vertical aiming bubble.
headlamp assembly. 9. Check the
headlamp aim indicators. The horizontal
indicator
(A) should be on 0 (zero). If the vehicle is
level, the vertical indicator
(B) should also be on
0 (zero). If the vehicle isn’t level, check the vertical
aim on a level surface as soon as you can.
If either
indicator doesn’t read
0 (zero), adjust the headlamp
aim. See “Adjusting Headlamp Aim’’ in the Index.
If your vehicle is damaged in an accident and the
headlamp aim seems to be affected, see your
Chevrolet dealer. Headlamps on damaged vehicles may
require recalibration of the horizontal aim by your
Chevrolet dealer.
6-45

Downloaded from www.Manualslib.com manuals search engine Underhood Electrical Center Fuses
The underhood electrical center fuses are located in the
engine compartment. Open the cover to expose the fuses.
AIG CRUISE 12
IIS/\MPSI
-1
I1 IONITION
EN0 SENSOR 10
9 INJECTOR
[-1[F][-Jp]
RELAY IDENTIFICATION
L HDLP DR (r5*MPB(
115/\.psI
IljAMPSI
3 R HOLP OR
2 ACTUATORS
I ABS IGN
8
$&
7 AIP FAN
6
5 ABS VALVE F]
Fuse
ABS IGN
ACTUATORS
R HDLP DR
L HDLP DR
ABS VLV
ABS BAT
AIR PUMP
Usage
Anti-Lock Brake System
Daytime Running Lamp Module,
Headlamp
Switch, Cooling
Fan Relay, Exhaust,
Gas
Recirculation, EVAP Canister
Purge Solenoid
Headlamp Door Module
Headlamp Door Module
Brake Pressure Valve
Electronic Brake Control Module
AIR Pump (V8) Relay, Bleed
Valve and Cooling Fan
6-72