Downloaded from www.Manualslib.com manuals search engine This device complies with RSS-210 of Industry and
Science Canada. Operation is subject
to the following
two conditions:
(1) this device may not cause
interference, and
(2) this device must accept any
interference received, including interference that
may cause undesired operation of
the device.
Changes or modifications
to this system by other than
an authorized service facility could void authorization to
use this equipment.
This system has a range of about
3 feet (1 m) up to
30 feet (9 m). At times you may notice a decrease in
range. This is normal for any remote lock control
system. If the transmitter does not work or if you have
to stand closer
to your vehicle for the transmitter to
work, try this:
Check to determine if battery replacement or
transmitter resynchronization is necessary. See
the instructions that follow.
Check the distance. You may be too far from your
vehicle. You may need to stand closer during rainy
or snowy weather.
Check the location. Other vehicles or objects may be
blocking
the signal. Take a few steps to the left or
right, hold the transmitter higher, and try again.
If you’re still having trouble, see your GM dealer or
a qualified technician for service. Changes
or modifications
to this system by other than an
authorized service facility could void authorization to
use this equipment.
Operation
When you press UNLOCK, the driver’s door will
unlock automatically. If
you press UNLOCK again
within five seconds, all doors will unlock. All doors
will lock when LOCK is pressed. The interior lamps
will come on whenever you lock or unlock
the doors.
See “Keyless Illumination’’
in the Index. Pressing
REAR 2X twice within three seconds, will unlock the
hatch or rear cargo doors.
Matching Transmitter(s) To Your Vehicle
Each remote keyless entry transmitter is coded to
prevent another transmitter from unlocking your vehicle.
If a transmitter
is lost or stolen, a replacement can be
purchased through your dealer. Remember to bring any
remaining transmitters with
you when you go to your
dealer. When
the dealer matches the replacement
transmitter
to your vehicle, any remaining transmitters
’ must also be matched. Once your dealer has coded the
new transmitter, the lost transmitter will not unlock your
vehicle. Each vehicle can have
only two transmitters
matched to it.
2-8
Downloaded from www.Manualslib.com manuals search engine Battery Replacement
Under normal use, the battery in your remote keyless
entry transmitter should last about two years.
You can tell the battery
is weak if the transmitter won’t
work at the normal range in any location.
If you have to
get close to your vehicle before the transmitter works,
it’s probably time to change the battery.
NOTICE:
When replacing the battery, use care not to
touch any of the circuitry. Static from your
body transferred to these surfaces may damage
the transmitter.
Use one Panasonic@ three volt, type CR2032, or
equivalent battery.
To replace the battery:
1.
2.
Your transmitter housing snaps apart for ease in
battery replacement.
3.
4.
Insert a small coin, or flathead screwdriver, to
separate the bottom of the transmitter from the top.
Remove the battery and replace
it with a new one,
making sure the positive side (+) side of the battery
is facing down.
Snap the top and bottom together.
Test the operation
of the transmitter with your
vehicle. If the transmitter does not work, try
synchronizing the transmitter with the receiver.
2-9
