1997 CADILLAC CATERA bulb

Downloaded from www.Manualslib.com manuals search engine Tilt Wheel lbrn SignaVMultifunction Lever
D
P
Tilt steering allows you to adjust the steering wheel
before you drive. Raising the steering wheel to the
highest level gives your legs more room when you enter
and exit your vehicle.
Hold the steering wheel and pull the lever toward you to
tilt
the wheel. Adjust the steering wheel to a comfortable
position and then release the lever to lock the wheel
in place.
Turn and Lane Change Signals
To signal a turn, move the lever all the way up or down.
The lever returns automatically when the
turn is complete.
This arrow on the
instrument panel will flash
in the direction
of the turn
or lane change.
Raise or lower the lever until
the arrow
starts to flash to
signal a lane change. Hold it
there until the lane change is
complete. The lever returns
when it’s released.
Arrows that flash rapidly when signaling
for a turn or
lane change may be caused by a front burned-out signal
bulb (this does not occur with a rear burned-out bulb).
Other drivers won’t see the turn signal. Replace
burned-out bulbs to help avoid possible accidents. Check the fuse (see “Fuses and Circuit Breakers” in the
Index) and for burned-out bulbs if the arrow fails to
work when signaling a turn.
2-32

Downloaded from www.Manualslib.com manuals search engine Voltmeter
I6h
VOLTS
You can read battery
voltage on the voltmeter. If
it reads
less than 12 volts or
more than 16 volts while the
engine
is running, and it
stays there, you may have a
problem with the electrical
charging system.
Have it checked right away. Driving with the voltmeter
reading in the lower warning zone could drain
or
damage the battery. Driving with the voltmeter reading
in the upper warning zone could cause bulbs
to burn out
(especially headlamp bulbs), various vehicle modules to
shut down (due to overload protection) and the
possibility of a battery acid leak. If
you idle
the engine for a while, the voltmeter reading
might move into the red zone. If the reading stays in
the
red zone while you are driving, you may have a problem
with the electrical charging system. Have it checked.
While the voltmeter reads in the red zone, the battery
may not be able
to power certain electrical accessories,
like
ABS. (If this happens, the ABS light will come on.
See “Anti-Lock Brake System Warning Light” in
this section.)
If
you must drive a short distance with the voltmeter
reading in a warning zone, turn
off all the accessories,
including the comfort controls and the audio system.

Downloaded from www.Manualslib.com manuals search engine Backing Up
Hold the bottom of the steering wheel with one hand.
Then, to move the trailer to the left, just move that hand
to the left.
To move the trailer to the right, move your
hand to the right. Always back up slowly and, if
possible, have someone guide you.
Making Turns
NOTICE:
Making very sharp turns while trailering could
cause the trailer
to come in contact with the
vehicle.
Your vehicle could be damaged. Avoid
making very sharp turns while trailering.
1
When you’re turning with a trailer, make wider turns
than normal.
Do this so your trailer won’t strike soft
shoulders, curbs, road signs, trees or other objects.
Avoid jerky or sudden maneuvers. Signal well
in advance.
lbrn Signals When Towing a Trailer
When you tow a trailer, your vehicle may need a
different turn signal flasher and/or extra wiring. Check
with your Catera dealer. The green arrows
on your
instrument panel will flash whenever you signal a turn
or lane change. Properly hooked up, the trailer lamps
will
also flash, telling other drivers you’re about to turn,
change lanes or stop.
When towing a trailer,
the green arrows on your
instrument panel will flash for turns even if the bulbs on
the trailer are burned out. Thus, you may think drivers
behind you are seeing your signal when they are not. It’s
important to check occasionally
to be sure the trailer
bulbs are still working.
Driving On Grades
Reduce speed and shift to a lower gear before you start
down a long
or steep downgrade. If you don’t shift
down, you might have to use your brakes
so much that
they would get hot and no longer work well.
On a long uphill grade, shift down and reduce your
speed to around
45 mph (70 km/h) or less to reduce the
possibility of engine and transmission overheating.
4-37

Downloaded from www.Manualslib.com manuals search engine Here you will find information about the care of your Catera. This section begins with service and fuel information,
and then
it shows how to check important fluid and lubricant levels. There is also technical information about your
vehicle, and a part devoted to its appearance care.
6-2
6-3
6-5
6-5 6-7
6- 10
6- 15 6-18
6- 19
6-24
6-25
6-29
6-29
6-37
Service
Fuel
Fuels in Foreign Countries
Filling Your Tank
Checking Things Under the Hood
Engine Oil
Air Cleaner
Automatic Transmission Fluid
Engine Coolant
Windshield Washer Fluid
Brakes
Battery Bulb Replacement
Wiper Blade Replacement Tires
Cleaning the Inside of Your Catera
Care
of Safety Belts
Cleaning the Outside
of Your Catera
Cleaning Aluminum or Chrome Wheels
Underbody Maintenance
Appearance Care Materials Chart
Vehicle Identification Number (VIN)
Electrical System Replacement Bulbs Capacities and Specifications
Air Conditioning Refrigerants
Normal Maintenance Replacement Parts
6-38
6-46
6-49
6-50
6-5 1
6-53
6-54
6-55
6-55
6-62 6-62
6-63
6-63
6-1

Downloaded from www.Manualslib.com manuals search engine Battery
Every new Catera has a Delco Freedom@ battery. You
never have to add water to one
of these. When it’s time
for a new battery, we recommend a Delco Freedom@
battery. Get one that has the replacement number shown
on the original battery’s label.
Batteries have acid that can burn you and gas
that can explode. You can be badly hurt if you
aren’t careful. See “Jump Starting” in the Index
for tips on working around a battery without
getting hurt.
Bulb Replacement
For bulb types, see “Replacement Bulbs” in the Index.
Halogen Bulbs
A CAUTION:
Halogen bulbs have pressurized gas inside and
can burst if you drop or scratch the bulb. You
or
others could be injured. Be sure to read and
follow the instructions on the bulb package.
Also, for your audio system, see “Theft-Deterrent
Feature” in
the Index.
6-29

Downloaded from www.Manualslib.com manuals search engine Exterior Front Bulbs
I
Front Turn Signal Lamp
A
I
A. Turn Signal Lamp
B, Headlamp
1. With a screwdriver, unscrew the fastener on the
headlamp cover and then remove
it to access the
turn signal lamps.
6-30

Downloaded from www.Manualslib.com manuals search engine c
2. On the outboard side of each low-beam headlamp,
you will find the turn signal bulbs. Turn the lamp
assembly clockwise to remove. 3. Twist the bulb out to replace and then reassemble.
6-31

Downloaded from www.Manualslib.com manuals search engine Headiamp
1. With a screwdriver, unscrew the fastener on the
headlamp cover and then remove the cover
to
gain access (see Step 1 under “Front Turn Signal
Lamp”). Note that the inner bulb is for the
low-beam headlamp and the outer bulb is for
the high-beam headlamp.
IF-
P
3. Remove the plug connector from the bulb.
2. Remove the black rubber cap that protects the
bulb area.
6-32