Downloaded from www.Manualslib.com manuals search engine Tires
Your new Catera comes with high-quality tires made by
a leading tire manufacturer. If you ever have questions
about your tire warranty and where
to obtain service, see
your Catera Warranty booklet for details.
I
/! CAUTION:
Poorly maintained and improperly used tires
are dangerous.
0 Overloading your tires can cause overheating
as a result of too much friction. You could
have an airout and
a serious accident. See
“Loading Your Vehicle” in the Index.
0 Underinflated tires pose the same danger as
overloaded tires. The resulting accident
could cause serious injury. Check all tires
frequently to maintain the recommended
pressure. Tire pressure should be checked
when your tires are cold.
CAUTION: (Continued)
I--
@ Overinflated tires are more likely to be
cut, punctured or broken
by a sudden
impact
-- such as when you hit a pothole.
Keep tires at the recommended pressure.
0 Worn, old tires can cause accidents. If your
tread is badly worn, or
if your tires have
been damaged, replace them.
See “Inflation
-- Tire Pressure” in this section
for inflation pressure adjustment for higher
speed driving.
Inflation -- Tire Pressure
The Tire-Loading Information label, which is located
on the rear edge of the driver’s door, shows the correct
inflation pressures for your tires when they’re cold.
“Cold” means your vehicle has been sitting for
at least
three hours or driven
no more than 1 mile (1.6 km).
6-38
Downloaded from www.Manualslib.com manuals search engine If you’ll be driving at speeds higher than 100 mph
(160 km/h) where it is legal, raise the cold inflation
pressure of each tire to
37 psi (250 ma). When you end
this very high-speed driving, reduce the cold inflation
pressures to those listed on the Tire-Loading
Information label.
I NOTICE:
Don’t let anyone tell you that underinflation or
overinflation
is all right. It’s not. If your tires
don’t have enough air (underinflation), you can
get the following:
1 Too muchflexing
’ 0 Toomuch heat
~ 0 Tire overloading
Bad wear
0 Bad handling
1 0 Bad fuel economy.
NOTICE: (Continued)
I
NOTICE: (Continued) -
If your tires have too much air (overinflation),
you can get the following:
0 Unusual wear
0 Bad handling
0 Rough ride
Needless damage from road hazar
~- . - .. ..~ ~
v
When to Check
Check your tires once a month or more.
How to Check
Use a good quality pocket-type gage to check tire
pressure.
You can’t tell if your tires are properly
inflated simply
by looking at them. Radial tires may
look properly inflated even when they’re underinflated.
Be sure to put the valve caps back on the valve
stems. They help prevent leaks by keeping
out dirt
and moisture.
6-39
Downloaded from www.Manualslib.com manuals search engine Tire Inspection and Rotation
Tires should be rotated at 5,000 miles (8 000 km) and
then every
10,000 miles ( 16 000 km) thereafter. Any
time you notice unusual wear, rotate your tires as soon
as possible and check wheel alignment.
Also check for
damaged tires or wheels.
See “When It’s Time for New
Tires” and “Wheel Replacement” later in this section for
more information.
The purpose of regular rotation is to achieve more
uniform
wear for all tires on the vehicle. The first
rotation is the most important. See “Scheduled
Maintenance Services’’ in the Maintenance Schedule
booklet for scheduled rotation intervals. When rotating your tires,
always use the correct
rotation pattern shown here.
After the tires have been rotated, adjust the front
and rear inflation pressures as shown on the
Tire-Loading Information label. Make certain that all wheel bolts are properly tightened. See “Wheel Bolt
Torque”
in the Index.
Rust or dirt on a wheel, or on the parts to which
it is fastened, can make wheel studs become loose
after a time. The wheel could come off and cause
an accident. When you change
a wheel, remove
any rust or dirt from places where the wheel
attaches to the vehicle. In an emergency, you can
use a cloth or a paper towel to do this; but be
sure to use a scraper or wire brush later, if you
need to, to get all the rust or dirt off. (See
’ “Changing a Flat Tire” in the Index.)
6-40
Downloaded from www.Manualslib.com manuals search engine When It’s Time for New Tires
One way to tell when it’s
time for new tires is to
check the treadwear
indicators, which will
appear when your tires have
only
1/16 inch (1.6 mm) or
less
of tread remaining.
You
need a new tire if any of the following statements
are true:
You can see the indicators at three or more places
around the tire.
You can see cord or fabric showing through the
tire’s rubber.
The tread or sidewall is cracked, cut or snagged
deep enough
to show cord or fabric.
0 The tire has a bump, bulge or split.
The tire has a puncture, cut or other damage that
can’t be repaired well because of the size or location
of the damage.
Buying New Tires
To find out what kind and size of tires you need, look at
the Tire-Loading Information label.
The tires installed
on your vehicle when it was new had
a Tire Performance Criteria Specification (TPC Spec)
number
on each tire’s sidewall. When you get new tires,
get ones with that same TPC Spec number. That way
your vehicle will continue to have tires that are designed
to give proper endurance, handling, speed rating,
traction, ride and other things during normal service on
your vehicle. If your tires have an all-season tread
design, the TPC number will be followed by an
“MS”
(for mud and snow).
If you ever replace your tires with those
not having a
TPC Spec number, make sure they are the same size,
load range, speed rating and construction type (bias,
bias-belted or radial) as your original tires.
6-41
Downloaded from www.Manualslib.com manuals search engine Cleaning the Outside of the
Windshield and Wiper Blades
If the windshield is not clear after using the
windshield washer, or if the wiper blade chatters
when running, wax, sap or other material may be
on the blade
or windshield.
Clean the outside
of the windshield with GM
Windshield Cleaner, Bon Ami@ Powder (non-scratching
glass cleaning powder), GM Part
No. 10500 1 1. The
windshield is clean if beads do not form when you rinse
it with water.
Grime from the windshield will stick to the wiper blades
and affect their performance. Clean the blade by wiping
vigorously with a cloth soaked in full-strength
windshield washer solvent. Then rinse the blade
with water.
Check the wiper blades and clean them as necessary;
replace blades that look worn.
Weatherstrips
’ Silicone grease on weatherstrips will make them last
longer, seal better, and not stick or squeak. Apply silicone
grease with a clean cloth at least every six months.
During very cold, damp weather more frequent
application may be required. (See “Recommended Fluids
and Lubricants” in the Maintenance Schedule booklet.)
Cleaning the Outside of Your Catera
The paint finish on your vehicle provides beauty, depth
of color, gloss retention and durability.
Washing Your Vehicle
The best way to preserve your vehicle’s finish is to keep
it clean by washing it often with lukewarm or cold water.
Don’t wash your vehicle in the direct rays of the sun.
Don’t use strong soaps or chemical detergents. Use
liquid hand, dish or car washing (mild detergent) soaps.
Don’t use cleaning agents that are petroleum based, or
that contain acid or abrasives. All cleaning agents
should be flushed promptly and not allowed
to dry on
the surface, or they could stain. Dry the finish with a
soft, clean chamois or an all-cotton towel to avoid
surface scratches and water spotting.
High pressure car washes may cause water to enter
your vehicle.
Downloaded from www.Manualslib.com manuals search engine Vehicle Identification Number (VIN)
- 1 I I. 11111.11 1.11 111 111111 II. 111111 1. 111111111111 111111111 II
1-11 SAMPLE4UXVM072675 111
ENGINEA97 ASSEMBLY
CODE MODEL YEAR
PLANT
This is the legal identifier for your Catera. It appears on
a plate in the front corner of the instrument panel, on the
driver’s side. You can see it if you look through the
windshield from outside your vehicle. The VIN also
appears on the Vehicle Certification and Service Parts
labels and the certificates of title and registration.
Engine Identification
The 8th character in your VIN is the engine code. This
code will help you identify your engine, specifications
and replacement parts.
Service Parts Identification Label
You’ll find this label behind the passenger’s side access
panel in the trunk (panel that covers the trunk mounted CD changer). It’s very helpful if you ever need to
order parts. On
this label is:
your VIN,
the model designation,
paint information and
0 a list of all production options and special equipment.
Be sure that this label is not removed from the vehicle.
Electrical System
Add-on Electrical Equipment
I
NOTICE:
Don’t add anything electrical to your Catera unless
you check with your dealer first. Some electrical
equipment can damage
your vehicle and the
damage wouldn’t
be covered by your warranty.
Some add-on electrical equipment
can keep other
components from working
as they should.
Your vehicle has an air bag system. Before attempting to
add anything electrical to your Catera, see “Servicing
Your Air Bag-Equipped Catera” in the Index.
Downloaded from www.Manualslib.com manuals search engine Headlamp Wiring
The headlamp wiring has an individual fuse which is
powered by a MaxiFuse@. An electrical overload will
cause the lamps to
go on and off, or in some cases to
remain
off. If this happens, have the headlamp wiring
checked right away.
MaxiFuseRelay Center
MaxiFuse is a registered trademark of Little
Fuse Incorporated.
Windshield Wiper Fuses
The windshield wiper motor is powered by a MaxiFuse.
If the motor overheats due to heavy snow, etc., the
wipers will stop until the motor cools.
If the overload
is caused by some electrical problem, be sure to have
it fixed.
Power Windows and Other Power Options
Circuit breakers protect the power windows and other
power accessories, When the current load is too heavy,
the circuit breaker opens and closes, protecting the
circuit until the problem
is fixed or goes away. The MaxiFuseRelay
center is attached to the engine
compartment fuse block on top of the battery. Simply
lift the lid
to open. If you have any questions about the
MaxiFuseRelay Center, consult your Catera dealer.
6-56
Downloaded from www.Manualslib.com manuals search engine Capacities
Engine Crankcase
Transmission
................. 7.0 quarts (6.6 L)
Oil Change With Filter* ...... 6.1 quarts (5.75 L)
Engine Cooling System ......... 10.6 quarts ( IO L)
Fuel Tank ................... 18 gallons (68. I L)
R- i 34a
Refrigerant,. ............. 2.9 lbs. (0.95 kg)
Wheel Base ............. 107.4 inches (272.8 cm)
Length ................... 194 inches (492.8 cm)
Height.. ................. 56.3 inches (143.1 cm)
Width ................... 70.3 inches (178.6 cm)
Front Tread
............... 59.3 inches ( 150.6 cm)
Rear Tread ................ .59.8 inches (152 cm)
Wheel Bolt Torque ............ 80 lb-ft (I 10 N-m)
Oil Change Without Filter* .... 5.8 quarts (5.5 L)
Vehicle Dimensions
* Recheck the oil level after filling. See “Engine Oil” in
the Index.
Air Conditioning Refrigerants
Normal Maintenance
Replacement Parts
Air Filter Element ................... 905093 18
Fuel Filter Element
.................. 90437575
Engine
Oil Filter .................... 93 156300
Passenger’s Compartment Air Filter
......................... 90510338
Thermostat
......................... 90502201
Windshield Wiper Blade
.......... 905 12807 (RH)
905 12808
(LH)
Spark Plugs ... 90541059 (Bosch Plug = FLR9LTE)
Not all air conditioning refrigerants are the same.
If the air conditioning system in your vehicle needs
refrigerant,
be sure the proper refrigerant is used.
If you’re not sure, ask your Catera dealer.
6-63