Press and hold the power door unlock switch. While
holding the door unlock switch, cycle the transmission
out of and back into
PARK (P). After an initial
transmission cycle, each additional cycle will toggle
the enable/disable state
of the Delayed Locking
function. During this procedure, the chime will sound,
providing you with feedback.
A single chime will be
heard if the Delayed Locking function is disabled and
two chimes will be heard if the function is enabled.
When the door unlock switch is released, the vehicle
will remain in the most recent operating mode.
The Delayed Locking function will be enabled when
your vehicle is shipped from the factory.
Disconnecting the vehicle battery for up
to a year will
not change the programmed mode of the Delayed
Locking function.
Leaving Your Vehicle
If you are leaving the vehicle, take your keys, open your
door and set the locks from inside. Then get out and
close the door. (Also see “Delayed Locking” in this
section for more information.)
Remote Keyless Entry
You can lock and unlock your doors or unlock your
trunk from about
3 feet (1 m) up to 30 feet (9 m) away
using the remote keyless entry transmitter supplied with
your vehicle.
Your remote keyless entry system operates on
a radio
frequency subject to Federal Communications Commission (FCC) Rules and with Industry and
Science Canada.
This device complies with Part 15 of the FCC Rules.
Operation is subject
to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
This device complies with RSS-210
of Industry and
Science Canada. Operation is subject
to the following
two conditions:
(1) this device may not cause
interference, and
(2) this device must accept any
interference received, including interference that may
cause undesired operation
of the device.
Changes or modifications
to this system by other than an
authorized service facility could void authorization to
use this equipment.
ProCarManuals.com
Back-up Lamp
The back-up lamps are located in the trunk lid applique.
(Refer
to the trunk lid applique removal procedure earlier
in this section for graphic and further instructions.)
1. Remove the trunk lid applique.
2. Twist and pull the back-up lamp socket from the
3. Twist and pull the bulb from the back-up
trunk
lid applique.
lamp socket.
Dome Lamp
To install the new bulb:
1. Twist and push the bulb into the back-up
lamp socket.
2. Twist and push the back-up lamp socket into
the trunk lid applique.
3. Reinstall the trunk lid applique.
1. Grasp the front center and rear center positions of the
dome lamp housing and squeeze together until the
housing releases from
the base plate. A flat-bladed
screwdriver may be necessary to pry the
assembly loose.
I
6-37
ProCarManuals.com
