20-49
Fuel level between "Tank full" and "Tank empty" must cause a resistance
value that falls between the two specified values.
If 0 or is measured
Note:
To check the resistance values for "Tank full" or "Tank empty" remove the
sender for fuel gauge ( Page 20
-50
) and swing the sensor float to the
top or bottom stop. - Measure resistance at terminals -2- and -3- on cover flange:
Sensor
Tank full
Tank empty
Sender for fuel gauge -G
40
280
There is an open or short circuit in the tank wiring.
Pa
ge 45 of 49 Fuel su
pp
ly system, servicin
g (vehicles with front wheel drive and 1.8 ltr. turbo or 2.8 ltr. en
gine
)
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.2
20-51
Note:
The fuel tank must not be filled more than
1/3
maximum.
Fuel supply unit, removing, starting Page 20
-40
.
- Carefully pull cover flange out and push to the
side with hoses connected.
- Disconnect harness connector for fuel level
display on inside of cover flange.
Note:
For clarity, surge housing illustration is shown without tank. - Pull sensor out of surge housing in fuel tank while simultaneously
pressing latching tab -arrow-.
Pa
ge 47 of 49 Fuel su
pp
ly system, servicin
g (vehicles with front wheel drive and 1.8 ltr. turbo or 2.8 ltr. en
gine
)
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE04.20.2
