Page 1 of 10
46-46
 
     
Brake pedal, removing and 
installing  
      Removing and installing vacuum servo unit with 
brake master cylinder   page 47
-34
   
    
CAUTION! 
Before disconnecting the hydraulic line, protect the plenum chamber 
from brake fluid flowing out.  -  Unbolt hydraulic line -1- for clutch master cylinder.
-  Disconnect supply hose from elbow of master cylinder.
    
-  Remove nut -1- at universal joint.
- 
Loosen eccentric by turning bolt (Torx  T50) clockwise, and remove 
bolt. 
Pa
ge 1 of 10 Brake 
pedal, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU03.46.7 
         
        
        
     
        
        Page 4 of 10
46-49
      
Installing  
     
CAUTION! 
     
Do not remove safety wire or other 
removal/installation aids from steering 
column until after the universal joint has been 
re-installed on the steering gear pinion. 
     
-  Install pedal assembly onto joint pin.
    
Note:  
Do not tighten hex socket-head bolt (arrow) for attaching pedal assembly 
to instrument panel member until after installing the brake servo unit. 
After installing:  -  Install hex socket-head bolt (arrow) for attaching pedal assembly to 
instrument panel member and tighten by hand. 
-  Attach accelerator pedal (AP) cable.
-  Install brake servo unit   page 47
-37
 .
 - Bleed brakes   page 47
-23
 .
  -  Bleed clutch   Repair Manual, Manual Transmission 012 Front 
Wheel Drive or Manual Transmission 01A All Wheel Drive, Repair 
Group 30. - 
Adjust brake light switch (   page 46
-50
 ) and CCS vent valves (   
Pa
ge 4 of 10 Brake 
pedal, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU03.46.7 
         
        
        
     
        
        Page 10 of 10
46-54
      
Cruise Control System (CCS) vent valve, 
adjusting
 
     
-  Insert vent valve into clip and push through to 
stop. 
     
-  Push back valve by pulling back brake pedal or 
clutch pedal to stop. 
     
Note:  
     Only install the valve one time, otherwise an 
adequately tight fit cannot be assured. 
     
Version with spring clip for the vent valve  
     
-  Same procedure as for the brake light switch   
page 46-53
 . 
Pa
ge 10 of 10 Brake 
pedal, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU03.46.7