48-66
Installing
WARNING!
Make sure the passenger compartment is not
occupied before connecting the battery Ground
(GND) strap. -
Unscrew Torx screws (in direction indicated by
arrow) and remove airbag unit.
- Disconnect harness connectors - 3 - and - 4 -
from airbag unit.
- Place airbag unit down with padded side facing
upward.
- Make sure harness connectors and airbag unit
engage properly (with audible click).
- Switch ignition on then connect battery Ground
(GND) strap.
Pa
ge 7 of 11
11/20/2002 file://C:\DOCUME~1\Bear\LOCALS~1\Tem
p riPOIKA.ht
m
48-69
Removing
Installing
WARNING!
Make sure the passenger compartment is not
occupied before connecting the battery Ground
(GND) strap. -
Using Torx bit socket (T30) remove bolts
mounting airbag unit.
- Disconnect harness connector - 2 -.
- Place airbag unit down with padded side facing
upward.
- Make sure harness connector - 2 - engages
properly (with audible click).
- Install airbag unit and tighten bolts to 7 Nm (62
in. lb).
- Switch ignition on and connect battery Ground
(GND) strap.
Pa
ge 10 of 1111/20/2002 file://C:\DOCUME~1\Bear\LOCALS~1\Tem
p riPOIKA.ht
m
