1997 AUDI A4 AFC Engine On Board Diagnostic Multiport Fuel Injection Workshop Manual

01-107

Output on GST and/or on VAG
1551 scan tool Possible malfunction cause

Malfunction repair
P1216 / 17624
Cyl.4-Fuel Injector Circ.
Short to B+
-----------------------
P1217 / 17625
Cyl.5-Fuel Injector Circ.
Short to B+
_______________________
P1218 / 17626
Cyl.6-Fuel Injector Circ.
Short to B+
_______________________
MIL Status:
MIL lights up immediately Wiring connection to Cylinder 4, 5,
or 6 fuel injectors faulty, or fuel
injectors -N33-, -N83- or -N84- faulty
Yes

- Check fuel injectors page 24
-29

Malfunction cause found: Yes

- Erase DTC memory, test drive and
Pa
ge 145 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

No
after test drive, check DTC memory
again

Engine Control Module (ECM) -
J192- faulty

- Replace and code engine control
module page 01
-265
erase DTC
memory and test drive check DTC
memory
Note:
If the malfunction "P1216 / 17624" and/or "P1217 / 17625" and/or "P1218 / 17626" is recognized by the engine control
module, the corresponding fuel injector is no longer triggered and the oxygen sensor control is blocked until ignition on.
Pa
ge 146 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

01-108

Output on GST and/or
on VAG 1551 scan
tool Possible malfunction
cause
Malfunction repair
P1250 / 17658
Fuel Level Too Low In addition, other
malfunctions stored in
the DTC memory?







Troubleshooting on other Diagnostic Trouble Codes (DTC) that
are stored in the DTC memory - If there are malfunctions that can be caused by fuel problems
(e.g. combustion misfiring), the malfunction "tank level too low" if
there is less than 12 liters (12.7 qt.) fuel in the tank check tank
level and fill tank if necessary
For troubleshooting
Display group 027

Pa
ge 147 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

01-109

Output on GST and/or on VAG
1551 scan tool Possible malfunction cause

Malfunction repair
P1325 / 17733
Cyl.1-Knock Control
Limit Attained
_______________________
P1326 / 17734
Cyl.2-Knock Control
Limit Attained
_______________________
P1327 / 17735
Cyl.3-Knock Control
Limit Attained
_______________________
MIL Status:
Malfunction not displayed by
MIL Has the control limit been
reached on all 6 cylinders
(P1335, P1326, P1327, P1328,
P1329, P1330) in DTC
memory?
No
Yes

- Poor fuel quality less than 91 AKI (CC) or 95
RON in tank fill tank with fuel having min. 91
AKI (CLC) or 95 RON (ROZ) - Loose subassemblies or loud noises from
subassemblies check

Malfunction cause found: Yes
Pa
ge 148 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

No
- Erase DTC memory, test drive and after test
drive, check DTC memory again

Was the control llimit
reached on 3 cylinders in one
bank? P1335, P1326, P1327 or
P1328, P1329, P1330 are in
the DTC memory.
No
Continued next page
Yes

- Knock Sensor for corresponding bank (-G61- or
-G66-) loose and/or tightening torque not OK;
check mounting of Knock Sensors (KS) 1 -G61-
and/or 2 -G66- and retighten if necessary use
insert 3247; tightening torque 20 Nm (15 ft lb) - Abnormal engine noises (e.g. subassemblies
loose) check - Open circuit/loose connection in wiring of
corresponding knock sensor or knock sensor
faulty check Knock Sensors (KS) 1 -G61- and
2 -G66- page 28
-29

Pa
ge 149 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

01-110

For troubleshooting
Display groups 011, 012,
013
Malfunction cause found: Yes
No

- Erase DTC memory, test drive and
after test drive, check DTC memory
again

Was the control limit reached on only
one cylinder? (e.g. only P1328 is in the
DTC memory)
Yes

- Abnormal engine noises (e.g.
subassemblies loose) check - Check engine for mechanical damage

Malfunction cause found: Yes


- Erase DTC memory, test drive and
after test drive, check DTC memory
again
Notes:

The malfunction "P1325 / 17733" and/or "P1326 / 17734" and/or "P1327 / 17735" is set as soon as the ignition angle is
fully retarded for longer than 180 sec during the trip.
Pa
ge 150 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

01-111

Output on GST and/or on VAG
1551 scan tool Possible malfunction cause

Malfunction repair
P1328 / 17736
Cyl.4-Knock Control
Limit Attained
_______________________
P1329 / 17737
Cyl.5-Knock Control
Limit Attained
_______________________
P1330 / 17738
Cyl.6-Knock Control
Limit Attained
_______________________
MIL Status:
Malfunction not displayed by
MIL Has the control limit been
reached on all 6 cylinders
(P1335, P1326, P1327, P1328,
P1329, P1330) in the DTC
memory?
No
Yes

- Poor fuel quality less than 91 AKI (CLC) or 95
RON in tank fill tank with fuel min. 91 AKI
(CLC) or 95 RON - Loose subassembly or loud noises from
subassemblies check

Malfunction cause found: Yes
Pa
ge 151 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1

No
- Erase DTC memory, test drive and after test
drive, check DTC memory again

Was the control limit
reached on 3 cylinders of one
bank? P1335, P1326, P1327
or P1328, P1329, P1330 in the
DTC memory.
No
Continued next page
Yes

- Knock Sensor for corresponding bank (-G61- or
-G66-) loose and/or tightening torque OK; check
mounting of Knock Sensors (KS) 1 -G61- and/or 2
-G66- and retighten if necessary use insert
3247; tightening torque 20 Nm (15 ft lb) - Abnormal engine noises (e.g. subassemblies
loose) check - Open circuit/loose connection in the wiring of the
corresponding knock sensor or knock sensor
faulty Check Knock Sensors (KS) 1 -G61- and
2 -G66- page 28
-29

Pa
ge 152 of 366 On Board Dia
gnostic
(OBD
) - Multi
port Fuel In
jection
(MFI
)
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU01.01.1