Page 6 of 29
24-148
      
Continuation  
      If the displayed values are NOT OK:  
     
-  Connect VAG 1598/22 test box to ECM harness 
connector  Page 01
-56
 . 
     
-  Check wiring for open circuit, short circuit to B+ 
or short circuit to Ground between ECM/test box 
terminal 8 and A/C control head -E87-, or 
Transmission Control Module (TCM). 
     
       Electrical Wiring Diagrams, Troubleshooting & 
Component Locations         If the wiring is OK:  
     
-  Check function of A/C control head -E87-.
     
       Repair Manual, Heating & Air Conditioning, 
Repair Group 01
   
      Or:  
     
       Repair Manual, 5 Spd. Automatic 
Pa
ge 6 of 29 Additional si
gnals
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU02.24.5 
         
        
        
     
        
        Page 20 of 29
24-156
       If the wiring is OK:  
     
-  Check multi-function Transmission Range (TR) 
program switch -F125-. 
     
       Repair Manual, 5 Spd. Automatic 
Transmission 01V, Repair Group 01
   
     
- Check readiness code   Page 01
-59
 . If 
Diagnostic Trouble Code (DTC) memory has 
been erased, or ECM was disconnected, 
generate new readiness code   Page 01
-62
 . 
Explanation of 4-digit display  
Explanation when display field is = 0  
x  
x  
x  
x  
(Display group 56)  
         0   A/C compressor off (0 = A/C compressor off / 1 = A/C compressor on)  
      0      Selector lever in P or N (0 = selector lever in P or N /1 = selector lever in 2/3/4/R/D)  
   0         Always "0"  
0            Always "0"  
Pa
ge 20 of 29 Additional si
gnals
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU02.24.5 
         
        
        
     
        
        Page 21 of 29
24-157
      
Timing control during shifting, checking
 
     
Notes:  
     
When shifting the automatic transmission, this 
signal from the Transmission Control Module 
(TCM) retards the ignition timing briefly, 
depending on vehicle speed and engine RPM 
(reduction of torque), to reduce shift pressure. 
     Because of the very brief signal to reduce 
torque, the signal is not always recognized by 
the VAG 1551 scan tool, and therefore is not 
always indicated. 
     
Required special tools and test equipment  
     VAG 1551 or VAG 1552 Scan Tool (ST) with 
VAG 1551/3 adapter cable 
     VAG 1598/22 test box 
Pa
ge 21 of 29 Additional si
gnals
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU02.24.5