39-9
Installing
Installation is the reverse order of removal, note
the following:
Note:
Carefully install drive gear onto differential
without canting. Do not use force: the drive gear
can break easily.
Installation position:
The drive peg of the drive gear -A- faces seal -B- and locks into groove in
the differential.
The retaining clips (arrows) lock in the circumferential groove in the
differential.
Tightening torques - Always replace seal -B- and circlip -C- Page 39
-3 .
- Drive in drive flange using VW295 needle bearing drift.
- Top up and check transmission fluid Page 34
-36
.
Component
Tightening torque
Drive axle to drive flange M8 40 Nm (30 ft lb)
M10 77 Nm (57 ft lb)
Heat shields over drive axles to transmission
Pa
ge 4 of 5 S
peedometer Vehicle S
peed Sensor
(VSS
) -G22- and sensor drive
gear, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.39.2
