39-15
Installing
Installation is the reverse of removal, note the
following:
CAUTION!
Install the drive gear carefully onto the
differential, without canting. Do not use force,
the drive gear can break easily.
Installation position:
The drive peg of the drive gear -A- faces seal -B- and locates in the
groove of the differential.
Retaining clips (arrows) locate in circumferential groove in differential.
Tightening torques - Always replace seal -B- and circlip -C- Page 39
-3 .
- Install drive flange using VW295 needle bearing drift.
- Top off and check transmission oil level Page 34
-38
.
Component
Tightening torque
Driveshaft to drive flange M 8 40 Nm (30 ft lb)
M10 80 Nm (59 ft lb)
Heat shields over drive axles on transmission 23 Nm (17 ft lb)
Pa
ge 4 of 4 S
peedometer Vehicle S
peed Sensor
(VSS
), removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.3
