1997 AUDI A4 ECU

30-4


12 -
Mount
Insert in mounting bracket with over-center
spring
13 -
Over-center spring Application Parts catalog microficheRemove and install together with clutch
pedal Page 30
-5
14 -
Socket-head bolt
5 Nm (44 in. lb)Secures pivot pin for clutch and brake
pedal.
15 -
Seal
16 -
Torx bolt 25 Nm (18 ft lb)Also secures brake master cylinder to
brake servo
Pa
ge 5 of 22 Clutch mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.30.1

30-6

Installing
Installation is the reverse of removal, note the
following:

- Align pivot pin so that it protrudes out of mounting bracket on clutch
pedal side (arrow).
- Hook clutch pedal into over-center spring, then install onto pivot pin.
- Connect clutch pedal to master cylinder. Clip locking pin onto clutch
pedal.

- Do not tighten bolt (arrow) until both securing clips have been installed
on pivot pin.
Pa
ge 7 of 22 Clutch mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.30.1

30-16

- Connect clutch master cylinder to clutch pedal.
Secure pin and locking plate on clutch pedal.

To install E-box in plenum chamber: - Tighten line fitting -B- to clutch master cylinder to 15 Nm (11 ft lb).
- Slide hose -A- onto brake fluid reservoir up to stop.
- Bleed hydraulic clutch system after installing clutch master cylinder
Page 30
-17
.

- Always replace seal -C-.
- Make sure seal is positioned properly, and does not cover opening or
stepped metal edge.
- Install E-box by hand and evenly tighten nuts -A- to 4 Nm (35 in. lb)
(i.e. imprint on E-box cover).
Pa
ge 18 of 22 Clutch mechanism, servicin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.30.1