1996 PONTIAC FIREBIRD engine

Starting Your 5.7 Liter LT1 Engine
1. Without pushing the accelerator pedal, turn the
ignition key to START. When the engine starts,
let
go of the key. The idle speed will go down as your
engine gets warm.
NOTICE:
Holding your key in START for longer than
15 seconds at a time will cause your battery to be
drained much sooner. And the excessive heat can
damage your starter motor.
2. If it doesn't start wihn 10 seconds, push the
accelerator pedal
all the way to the floor, while you
hold the ignition key in START. When the engine
starts, let go of the key and let up on the accelerator
pedal. Wait about
15 seconds between each try to
help avoid draining your battery.
When starting your engine in very cold weather (below
0°F or -18"C), do this:
1. With your foot off the accelerator pedal, turn the
ignition key to START and hold it there. When the
engine starts,
let go of the key. Use the accelerator pedal
to maintain engine speed, if you have to, until
your engine
has run for a while.
stops), it could be flooded with too much gasoline.
Try pushing your accelerator pedal
all the way to the
floor and holding it there as you hold the key in
START for about three seconds. If the vehicle starts
briefly but then stops again, do the same thing, but
this time keep the pedal down for five or six seconds.
This clears the extra gasoline from the engine.
2. If your engine still won't start (or starts but then
I NOTICE:
Your engine is designed to work with the
electronics in your vehicle.
If you add electrical
parts or accepsories, you could change the
way
the engine operates. Before adding electrical
equipment, check with your dealer.
If you don't,
your engine might not perform properly.
If you ever have to have your vehicle towed, see
the part of this manual that tells how to do
it
without damaging your vehicle. See 4'Towing
Your Vehicle" in the Index.
2-25
ProCarManuals.com

Engine Coolant Heater (Option)
[n very cold weather, 0°F (- 18 "C) or colder, the engine
coolant heater can help. You'll get easier starting and
better fuel economy during engine warm-up. Usually,
the coolant heater should be plugged in a minimum
of
four hours prior to starting your vehicle,
I'o Use the Coolant Heater
1. Turn off the engine.
2. Open the hood and unwrap the electrical cord.
3. Plug it into a normal, grounded 110-volt AC outlet.
P
A CAJT,,J:
Plugging the cord into an ungrounded outlet
coul'd cause an electrical shock. Also, the wrong
kind
of extension cord could overheat and cause
a
fire. You could be seriously injured. Plug the
cord into
a properly grounded three-prong
110-volt
AC outlet. If the cord won't reach, use a
heavy-duty three-prong extension cord rated for
at least 15 amps.
4. After you've used the coolant heater, be sure to
store the
cord as it was b'efore to keep it away
from moving engine
parts. If you don't, it could
be damaged.
How long should you keep the coolant heater plugged
in? The answer depends on the outside temperature,
the
kind of oil you have, and some other things. Instead of
trying to list everything here, we ask that you contact
your Pontiac dealer
in the area where you'll be puking
your vehicle. The dealer can give
you the best advice for
that particular area.
2-26
ProCarManuals.com

Automatic Transmission Operation
There are several different positions for your shift lever.
PARK (P): This locks your rear wheels. It’s the best
position
to use when you start your engine because your
vehicle can’t move easily.
-
It is dangerous to get out of your vehicle if the
shift lever
is not fully in PARK (P) with the
parking brake firmly set. Your vehicle can roII.
Don’t leave your vehicle when the engine
is
running unless you have to. If you have left the
engine running, the vehicle can move suddenly.
You
or others could be injured. To be sure your
vehicle won’t
move, even when you’re on fairly
level ground, always set your parking brake and
move the shift lever to
PARK (P).
See “Shifting Into PARK (P)’% in the Index. If
you’re pulling a trailer, see “Towing a Trailer’’ in
the Index.
2-27
ProCarManuals.com

Ensure the shift lever is fully in PARK (P) range
before starting the engine. Your Ponti’ac has
a
brake-transmission shift interlock. You have to fully
apply your regular brakes before you can shift from
PARK (P) when the ignition key is in the RUN position.
If YOU cannot shift out of PARK (P), ease pressure on
the shift lever -- push the shift lever all the way into
PARK (P) and also release the shZt lever button on floor
shift console models as you maintain brake application.
Then move
the shift lever into the gear you wish.
(Press the shift lever button before moving the shift
lever
on floor shift console models.) See “Shifting Out
of PARK” (P) in this section.
REVERSE (R): Use this gear to back up.
NOTICE:
Shifting to BEVERSE (R) while your vehicle
’is moving forward could damage your
transmission. Shift to
REVERSE (R) only
after
your vehicle is stopped,
To rock YOW vehicle back and f~~th to get out of snow, ice
or
sand without damaging your transmission, see “Stuck
In Sand, Mud, Ice or Snow, If You’re” -in the Index.
NEUTRAL (N): In this position, your engine doesn’t
connect with the wheels.
To restart when you’re
already moving, use NEUTRAL (N) only. Also, use
NEUTRAL (N) when your vehicle is being towed.
Shifting out of PARI( (B) or NEUTRAL (N) while
your engine
is “racing” (running at high speed) is
dangerous. Unless your foot is firmly on the
brake pedal,
your vehicle could move very
rapidly. You could
lose control and hit people or
objects, Don’t shift out ofPARK (P) or
NEUTBAL (N) while your engine is racing.
I NOTICE:
Damage to your transmission caused by shifting
out
of PARK (P) or NEUTRAL (N) with the
engine racing isn’t covered by your warranty.
ProCarManuals.com

AUTOMATIC OVERDRIVE (@): This position is
for normal driving.
If you need more power for passing,
and you’re:
- Going less than about 35 mph (56 km/h), push your
- Going about 35 mph (56 km/h) or more, push the
accelerator pedal about halfway down.
accelerator all the way down.
You’ll shift down to the next gear and have
more power.
THIRD (3): This position is also used for normal
driving, however, it offers more power and lower
fuel
economy than AUTOMATIC OVERDRIVE (@),
Here are some times you might choose THIRD (3)
instead of AUTOMATIC OVERDRIVE (a):
- When driving on hilly, winding roads.
- When towing a trailer, so there is less shifting
- When going down a steep hill.
between gears.
SECOND (2): This
position gives you more power but
lower fuel economy. You can use
SECOND (2) on hills.
It can help control your speed as you
go down steep
mountain roads, but then you would also want
to use
your brakes
off and on.
NOTICE:
Don’t drive in SECOND (2) for more than 25 miles
(40 km), or at speeds over 55 mph (88 km/h),
or you can damage your transmission. Use
AUTOMATIC
OVERDRIVE (a) or THIRD (3)
as much as possible.
Don’t shift into SECOND (2) unless you are going
slower than 65 mph (105 M), or you can
damage your engine.
2-29
ProCarManuals.com

FIRST.(l): This position gives you even more power
(but lower fuel economy)
than SECOND (2). You can
use it on very steep hiils,
or in deep snow or mud. If
the selector lever is put in FIRST (11, the transmission
won't
shift into first gear until the vehicle is going
slowly enough.
NOTICE:
I If your rear wheels can't rotate, don't try to, I..
NOTICE: (Continued)
Also,
if you stop when going uphill, don't hold
your vehicle there with
only the accelerator
pedal. This couEd overheat and damage the
transmission. Use your brakes
or shift into
PARK (P) to hold your vehicle in position on
a hill.
drive. This might happen if you were stuck
in- Maximum engine speed is limited to protect driveline
very deep sand or mud or were up agaht'a s&d
NOTICE: (Continued)
components from improper operation.
, object. You could damage your transmission.
2-30
ProCarManuals.com

SECOND (2): Press the clutch pedal to the floor as
you let up on the accelerator pedal and shift into
SECOND
(2). Then, slowly let up on the clutch pedal
as you press the accelerator pedal.
THIRD(3),FOURTH(4)andF'IFTH(5): Shift into
THIRD (3), FOURTH (4) and FIFTH (5) the same way
you do for SECOND (2). Slowly let up on the. clutch
pedal
as you press the accelerator pedal. ...
To Stop:Let up on the accelerator pedal and press the
brake pedal. Just before the vehicle stops, press the
clutch pedal and the brake pedal, and
shift to
NEUTRAL (N).
NEUTRAL (N): Use this position when ym start or
idle your engine.
REVERSE (R): To back up, press down the clutch
pedal and shift into REVERSE (R). Let up on the clutch
pedal slowly while
pressing the accelerator pedal.
L ~~ ~
NOTICE:
Shift to REVERSE (R) only after your vehicle is
stopped. Shifting to REVERSE (R) while your
vehicle is moving could damage your
transmission.
Also, use REVERSE (R), along with the parking brake,
for parking your vehicle.
2-32
ProCarManuals.com

6-Speed
1 3 5 R
2 4 6
This is your shift pattern.
Here’s how to operate
your transmission:
FIRST (1): Press the clutch pedal and shift into
FIRST
(1). Then, slowly let up on the clutch pedal as
you press the accelerator pedal.
You can shift into FIRST
(1) when you’re going less
than
20 mph (32 M). If you’ve come to a complete
stop and it’s hard to shift into FIRST
(1) put, the shift
THIRD(3),FOURTH(4),FIFTH(5),and SIXTH
(6): Shift into THIRD (3), FOURTH (4), FIFTH (5) and
SIXTH (6) the same way you do for SECOND (2).
Slowly let up on the clutch pedal as you press the
accelerator pedal.
To Stop: Let up on the accelerator pedal and press the
$rake pedal. Just before the vehicle stops, press the
clutch pedal and the brake pedal, and shift to neutral.
‘NEUTRAL (N): Use this position when you start or
REVERSE (R): To back up, press down the clutch
pedal and shift into REVERSE (R). Let
up on the clutch
pedal slowly while pressing the accelerator pedal.
If you
shift from SIXTH (6) into REVERSE (R) the shift lever
must be first placed in the
ITl3UTRAL (N) position
centered between
SECOND (2) and THIRD (3) prior to
shifting into REVERSE (R).
Your six-speed manual transmission has a feature that
’ ’ idle your engine.
lever in NEUTRAL
(N) and let up on the clutch. Press allows
you to safely shift into REVERSE (R) while the
the clutch pedal back down. Then shift into FIRST (1). vehicle is rolling (at less than 5 mph). You will: be
locked-out if you try to shift into REVERSE (R) while
SECOND (2): Press the clutch pedal as you let up on your vehicle is moving faster than 5 mph (8 km/h).
the accelerator pedal and shift into SECOND (2). Then,
slowly
let up on the clutch pedal as you press the If you have turned your ignition to the OFF position
accelerator pedal.
and wish to park your vehicle in, REVERSE (a), you will have to move the shift lever quickly to the right,
“crashing”through the high load spring and then into gear.
2-33
ProCarManuals.com