
brake  pedal  pushed  down.  Release  the  shift  lever  button if  you  have a  console  shift.  Then move  the  shift  lever 
out  of  PARK 
(P), being  sure to press the shift  lever 
button  if  you have a  console  shift.  See “Shifting  Out  of 
PARK  (P)” in the  Index. 
REVERSE  (R): Use  this  gear  to  back  up. 
NOTICE: 
Shifting  to REVERSE  (R)  while  your vehicle is 
moving  forward  could damage your transaxle. 
Shift  to REVERSE  (R)  only after your vehicle 
is  stopped. 
To  rock  your  vehicle  back  and  forth  to  get out  of  snow, 
ice  or sand  without  damaging  your  transaxle,  see 
“Stuck:  In  Sand,  Mud, 
Ice or Snow”  in  the  Index. 
NEUTRAL (N): In this position,  your  engine 
doesn’t  connect  with  the  wheels. 
To restart  when  you’re 
already  moving,  use  NEUTRAL 
(N) only.  Also,  use 
NEUTRAL 
(N) when  your  vehicle  is being  towed. 
I A CAUTION: 
Shifting  out of  PARK (P) or NEUTRAL  (N).while 
your  engine 
is “racing”  (running at high  speed)  is 
dangerous.  Unless  your foot 
is firmly  on the 
brake  pedal,  your vehicle  could  move  very 
rapidly.  You could  lose  control and hit people  or 
objects.  Don’t  shift out of  PARK 
(P) or 
NEUTRAL 
(N) while  your engine  is  racing. 
I NOTICE: 
Damage  to your transaxle  caused  by  shifting  out 
of  PARK  (P)  or NEUTRAL 
(N) with  the engine 
racing  isn’t  covered  by  your warranty. 
~~ 2-15  

I 
Adjusting the Speakers 
BAL: Press this knob, lightly so it extends, Tm the 
knob to move the sound  to the  left or right  speakers. Use 
the middk  position  to balance  these  speakers. 
FADE: Press  the knob  lightly--so  it 'extends.  Then  pull 
-. the knoti.all  the  way  out. T& it to move  the  sound  to 
, the front  or rear  speakers.  'Use  the middle  position  to' 
I -balance  these  speakers.' 
Push  the knob  back  in when  you're,not.using it. 
Playing a Compact  Disc 8. 
Insert  a  disc  partway  into the slot,  label  side,up. The 
player  will  pull  it in.  If the'ignition  is 
on and  the  radio  is 
off, the disc should  begin  playing. 
If you're  driving  on a very  rough  road  or if  it's  very  hot, 
the  disc  may  not  play  and 
Em, (error)  may  appear  on 
the  display.  When  things  get back  to normzil,  the disc 
should  play. 
If the  disc comes  out, it could  be  that: 
-, , 
The disc is upside  down. 
It  is  dirty,  scratched  or wet. 
It is  very  humid. (If so, wait  about  an hour  and 
try  again.) 
RCL: Press  this  button  to  see  which  track is playing. 
x Press  it again  within  five seconds  to see  how  long  it has 
been  playing. 
To change  what  is normally  shown  on  the 
display  (track  or elapsed-time),  press  the  button  until 
you  see  the  display  you  want,  then  hold  the  button  until 
the  display  flashes.  While  elapsed  time  is showing, 
EL TM  will  appear  on the  display. 
REV (1): Press  and  hold  this  button to quickly  reverse 
within  a  track  (song).  You will  hear  sound  at  a  reduced 
volume.  The display  will  show  elapsed  time. 
FWD (2): Press  and  hold  this  button  to  quickly  advance 
within  a  track  (song).  You will  hear  sound  at  a  reduced 
volume.  The display  will  show  elapsed  time. 
RDM (3): Press  this  button  to  hear  the  tracks  in random, 
rather  than  sequential,  order.  RDM  will  appear  on  the 
display  when  you  press 
this button.  Press  RDM  again  to 
turn 
off random  play. 
AM-FM: Press  this  button  to  play  the  radio  when  a  disc 
is  in  the  player. 
CD: Press  this  button  to change  to  the  disc  function 
when  the  radio  is 
on if  a  disc is already  loaded.  The.disc 
will  start  playing  at the  point  where 
it was  stopped. A 
box  will  appear  around  CD on  the  display'when  the  disc 
is active. 
3-16  

SCAN: Press this button  to listen  to each selection for a 
few seconds.  The tape  will go to the  next  selection,  stop 
for  a few  seconds,  then go on to the  next  selection. Press 
this button  again  to stop scanning.  The sound  will be 
muted,  SCAN  will appear on the  display  and  the tape 
direction arrow will  blink while scanning. 
TONE: Press this button  to select a  TONE  while 
playing a cassette. The  tone will be automatically  set 
whenever  you  play  a cassette tape. 
AM-FM: Press this button  to  play  the  radio  when  a tape 
is  in  the  player.  The  tape  will  stop  but  remain  in  the  playe\
r. 
TAPE-CD: Press this button if you  have a  disc loaded 
in  the  changer  and the radio  is playing,  to  play a 
compact disc. Press  AM-FM to return to the  radio  when 
a compact disc is playing. Press  TAPE-CD  to  switch 
between  the tape and compact disc  if both  are loaded. 
The  inactive  tape or CD-  will remain safely  inside  the 
radio  for  future  listening. 
EJECT Press this button  to remove  the tape. The 
radio will  play. EJECT  may  be  activated  with either the 
ignition or radio  off. Cassettes  may  be  loaded  with  the 
radio  and ignition 
off if this  button  is pressed first. 
CLN: This message  may  appear  on  the display.  If it 
does,  your cassette tape  player  needs  to  be cleaned. It 
will still  play tapes,  but  you  should  clean  it as  soon  as 
possible  to prevent damage  to your  tapes  and  player. 
See  “Care  of  Your  Cassette  Tape  Player”  in  the Index. 
After  you clean  the player,  press  and  hold  EJECT for 
five  seconds  to  reset the CLN  indicator.  The radio  will 
display 
--- to  show  the indicator  was reset. 
Playing  a  Compact Disc 
The CD  player  will  play  either normal-size  discs  or the 
smaller 
8 cm  discs  without  an adapter. 
With  the ignition  on,  insert a disc  partway  into the slot, 
label  side up. The  player  will  pull 
it in and  the  disc 
should  begin  playing. 
Note  that when  the disc  is inserted,  CD  will  be 
displayed.  When the disc is playing, a 
box will appear 
around  CD  on  the display. 
If you  select a  tone setting  for 
your  CD,  it will  be  activated  each time you  play a CD. 
As  each  new  track  starts to  play,  the track  number  will 
appear  in the  display. 
3-21  

SCAN: Press this button  to listen to each selection  for a 
few  seconds.  The disc will 
go to the  next  selection, stop 
for  a few  seconds,  then go on  to  the next  selection. Press 
this button  again  to stop scanning.  The sound  will  be 
muted,  SCAN  will  appear on  the display  and  the disc 
direction arrow will blink while scanning. 
TONE: Press  this button  to select a  TONE  while 
playing a compact disc.  The tone  will  be automatically 
set  whenever  you  play  a compact disc. 
TAPE  CD: Press this button  to change  to the tape or 
disc function  when the radio  is on  and  either a tape or 
CD is inserted. Press  AM-FM to return  to the  radio 
while 
a CD or tape  is playing.  The inactive tape or CD 
will  remain  safely inside  the radio  for  future  listening. 
EJECT Press this button  to remove the compact disc or 
cassette tape.  The item  with the box  around it  on the 
display  will eject  and the radio will  play. EJECT  may be 
activated  with either  the ignition 
or radio off. Cassettes 
and  compact discs  may  be loaded with the radio  and 
ignition 
off if  this  button is  pressed first. 
Theft-Deterrent  Feature 
THEFTLOCK"  is designed  to  discourage theft of your 
radio. It  works by using  a secret code  to disable all radio 
functions  whenever  battery  power  is removed. 
The  THEFTLOCK  feature for the  radio  may be used  or 
ignored. 
If ignored,  the system  plays  normally  and  the 
radio is  not  protected  by  the feature. 
If THEFTLOCK is 
activated,  your radio  will  not  operate 
if stolen. 
When  THEFTLOCK  is activated, the  radio  will  display 
LOC  to  indicate a  locked condition anytime  battery 
power  is removed.  If your  battery  loses power  for any 
reason,  you  must  unlock  the  radio with the secret code 
before  it  will operate. 
Activating  the  Theft-Deterrent  Feature 
The instructions  which follow  explain  how  to  enter your 
secret code to activate  the  THEFTLOCK system. It is 
recommended  that  you  read  through  all nine steps 
before starting  the procedure. 
NOTE: 
If you  allow  more  than 15 seconds  to elapse 
between  any  steps, the radio automatically reverts to 
time  and  you  must  start the procedure  over at Step 4. 
3-23