Page 70 of 388

Trunk Security Override
The Remote Lock Control transmitter will open the
trunk even if the override switch is
in the OFF position.
It can be dangerous to drive with the trunk lid
open because carbon monoxide (CO) gas can
come into your vehicle. You can’t see or smell
CO. It can cause unconsciousness and even death.
If you must drive with the trunk lid open or if
electrical wiring or other cable connections must
pass through the seal between the body and the
trunk lid:
0 Make sure all windows are shut.
Turn the fan on your heating or cooling
system to its highest speed with the setting
on on any airflow selection except RECIRC.
That
will force outside air into your vehicle.
See “Comfort Controls” in the Index.
If you have air outlets on or under the
instrument panel, open them all the way.
See “Engine Exhaust’’ in the Index.
Theft
Vehicle theft is big business, especially in some cities.
Although your Aurora has a number
of theft-deterrent
features, we know that nothing we put on it can make it
impossible to steal. However, there are ways you can help.
Key in the Ignition
If you leave your vehicle with the keys inside, it’s an
easy target for joy riders or professional thieves
-- so
don’t do it.
With the ignition
OFF and the driver’s door open, you’ll
hear a chime reminding you to remove your key from
the ignition and take it with you. Always do this.
Your
steering wheel will be locked, and so will your ignition
and transaxle. And remember to lock the doors.
ProCarManuals.com
Page 108 of 388
Ashtrays and Cigarette Lighter
Push and release the cover to reveal the front ashtray,
lighter and accessory power outlet.
NOTICE:
Don’t put papers and other things that burn
into your ashtrays.
If you do, cigarettes or other
smoking materials could set them on fire, causing
damage.
To open either rear ashtray, press and release the cover.
To clean an ashtray, make sure the cover is open fully,
then lift out the ashtray by pulling on the snuffer.
To use a lighter, just push it in all the way and let go.
When it’s ready,
it will pop back by itself.
I NOTICE:
Don’t hold a cigarette lighter in with your hand
while it is heating. If you
do, it won’t be able to
back away from the heating element when it’s
ready. That can make it overheat, damaging the
lighter and the heating element.
2-52
ProCarManuals.com
Page 124 of 388
Xkaction Control System Active Light
TRACTION ACTIVE
When your traction control
system is limiting wheel
spin, this light will come on.
Slippery road conditions
may exist if the traction
control system active light
comes on,
so adjust your
driving accordingly.
Engine Coolant Temperature Gage
This gage shows the engine
coolant temperature.
The light will stay on for a few seconds after the traction
control system stops limiting wheel spin. If
the gage pointer moves into the red warning zone,
your engine is hot. To prevent engine overheating, the
air conditioning compressor will turn off automatically,
a fast-pulsed chime will sound, and the message
ENGINE
HOT ... A/C OFF will appear in the information
center.
As the engine cools down, the air conditioning
compressor will automatically turn back on.
ProCarManuals.com
Page 125 of 388

If the coolant temperature is over 261 OF ( 127 O C), the
message HOT
... STOP ENGINE will appear. It means
that your engine coolant has overheated. If you have
been operating your vehicle under normal driving
conditions, you should pull off the road, stop your
vehicle and turn off the engine as soon as possible.
In “Problems on the Road,” this manual shows what to
do, See “Engine Overheating” in the Index.
If your coolant level is low, the message LOW ENGINE
COOLANT will appear on the Driver Information
Center. Check your coolant level as soon as possible.
See “Engine Coolant” in the Index.
Malfunction Indicator Lamp
(Service Engine Soon Light)
SERVICE
ENGINE SOON
Your Aurora is equipped
with a computer which
monitors operation of the
fuel, ignition and emission
control systems.
This system is called
OBD I1 (&-Board
Diagnostics-Second Generation) and is intended to
assure that emissions are at acceptable levels for the life
of the vehicle, helping to produce a cleaner
environment. (In Canada,
OBD I1 is replaced by
Enhanced Diagnostics.) The SERVICE ENGINE SOON
light comes on
to indicate that there is a problem and
service is required. Malfunctions often will
be indicated
by the system before any problem is apparent, which
may prevent more serious damage
to your vehicle. This
system is also designed
to assist your service technician
in correctly diagnosing any malfunction.
ProCarManuals.com
Page 144 of 388

Heating
In cold weather, if the automatic mode is selected
(AUTO-PUSH knob indicator light is on), the system
will automatically direct the airflow out
of the lower
floor outlets and the temperature door will be positioned
at the full hot position. You can choose the extreme
comfort setting of
90°F (32°C) but the system will
not warm up
any faster by selecting the extreme
comfort setting.
In cold weather, the system will delay turning on the
fan to avoid blowing cold air. The length
of the delay
depends on the engine coolant temperature and the
outside temperature. The fan speed will increase as the
temperature
of the engine coolant increases. Rotating the
AUTO
FAN knob will override this delay by turning
off the automatic
fan control mode and changing the
fan speed.
t
Ventilation System
Your Aurora’s flow-through ventilation system always
allows outside air to flow through your vehicle when
it
is moving, even when the system is in the OFF position. The
direction
of the air can be controlled by adjusting or
closing the outlets in the instrument panel. Rotate the
control between the front outlets upward to open the
outlets and downward to close the outlets. Adjust the
direction
of airflow from side to side with the controls in
each outlet.
ProCarManuals.com
Page 148 of 388

Steering Wheel Controls for Climate
Control
Some heating and cooling
controls can be adjusted at
the steering wheel. Other
touch controls also operate some audio controls. See
“Steering Wheel Controls
for Audio System” later in
this section.
Press the upper part of the fan symbol button
to override
the automatic fan control and increase the fan speed.
Press the lower part
of the fan symbol button to override
the automatic fan control and reduce the fan speed. Press
either arrow on the TEMP button once to display
your current comfort setting in the digital display. Press
the upper part
of the TEMP button again to provide a
warmer comfort setting or press the lower part of the
TEMP button again to provide
a cooler comfort setting.
Audio Systems
Your Delco@ audio system has been designed to operate
easily and give years
of listening pleasure. You will get
the most enjoyment out of it if you acquaint yourself
with it first. Find out what your Delco system can do
and
how to operate all its controls, to be sure you’re
getting the most out of the advanced engineering that
went into it.
Setting the Clock
Press and hold HR until the correct hour appears. The
letter
A or P may appear on the display for AM or PM.
Then, press and hold
MN until the correct minute appears.
The clock may be set with the ignition on or
OFF.
ProCarManuals.com
Page 222 of 388

Attach a separate safety
chain around the outboard
end
of each lower control
arm.
Engine Overh -. hg
You will find a coolant temperature gage on your
Aurora’s instrument panel.
Your information center will
also display messages about engine overheating. See
“Coolant Temperature Gage” in the Index.
Overheated Engine Protection Operating
Mode
Should a low coolant condition exist and the message
HOT STOP ENGINE is displayed, an overheat
protection mode which alternates firing groups of four
cylinders helps prevent engine damage. This operating
mode allows your vehicle to be driven to a safe place in
an emergency; you may drive up to
50 miles (80 km).
Towing a trailer in the overheat protection mode should
be avoided.
Y
NOTICE:
After driving in the overheated engine protection
operating mode, to avoid engine damage, allow
the engine
to cool before attempting any repair.
The engine oil may be severely degraded. Change
the oil and reset the oil life indicator. See “Engine
Oil, When to Change” in the Index.
ProCarManuals.com
Page 226 of 388
The coolant level should be indicated by a CHECK
COOLANT
LEVEL message on the Driver Information
Center.
If it isn’t, you may have a leak in the radiator
hoses, heater hoses, radiator, water pump or somewhere
else in the cooling system.
A C,’ UT’O’‘:
~ Heater and radiator hoses, and other engine
parts, can be very hot. Don’t touch them.
If you
do, you can be burned.
Don’t run the engine if there is a leak.
If you run
the engine, it could lose all coolant. That could
cause an engine fire, and you could be burned.
Get any leak fixed before you drive the vehicle.
I NOTICE:
Engine damage if you keep running your engine
without coolant isn’t covered by your warranty.
See “Overheated Engine Protection Operating
Mode” in the Index.
If there seems to be no leak, with the engine on, check to
see if the electric engine fan(s) are running. If the engine
is overheating, both fan(s) should be running.
If they
aren’t, your vehicle needs service.
5-18
ProCarManuals.com