1996 Mercury Villager oil dipstick

Servicing Your Villager
311
[SV15500(ALL)02/94]
10-1/2 pica
art:0040196-B
Selecting the right viscosity for your climate
%*
[SV15575(ALL)03/95]
Synthetic engine oils which are CERTIFIED and of the preferred
viscosity may be used in your engine. The engine oil and oil
filter must still be changed according to the maintenance
schedule.
%*
[SV15600(ALL)01/95]
Checking and Adding Engine Oil
*
[SV15700(ALL)03/95]
Since the proper amount of engine oil is important for safe
engine operation, check the oil using the dipstick each time you
put fuel in your vehicle. Remember the engine must be off, the
oil must be warm and the vehicle must be parked on level
ground.
%*
[SV15800(ALL)03/95]
Checking the engine oil level:
*
[SV15900(ALL)02/95]1.
Turn the engine off after it has warmed up and allow a few
minutes for the engine oil to drain back into the oil pan.
[SV16000(ALL)07/95]2.
Set the parking brake fully and make sure that the gearshift
is securely latched in P (Park).
*
[SV16100(ALL)02/95]3.
Open the hood. Protect yourself from engine heat.
*
[SV16200(ALL)03/95]4.
Locate the engine oil dipstick (highlighted in yellow) and
carefully pull it out of the engine.
File:15vxsvn.ex
Update:Wed Jun 5 12:25:18 1996

312
*
[SV16300(ALL)01/95]5.
Wipe the dipstick clean and put it back into position, making
sure it is fully seated.
[SV16400(ALL)05/93]
7-1/2 pica art:0040218-A
Engine oil dipstick
[SV16500(ALL)05/94]6.
Carefully pull the dipstick out again. If the oil level is below
the ªLº line, add engine oil as necessary. If the oil level is
beyond the letter ªH,º engine damage or high oil
consumption may occur and some oil must be removed from
the engine.
*
[SV16600(ALL)01/95]7.
Put the dipstick back in and make sure it is fully seated.
%*
[SV16650(ALL)03/95]
Adding engine oil
*
[SV16700(ALL)01/95]
It may be necessary to add some oil between oil changes. Make
sure you use a CERTIFIED engine oil of the preferred viscosity.
Your vehicle's warranty coverage may not apply if engine
damage is caused by the use of improper engine oil.
*
[SV16800(ALL)03/95]
Add engine oil through the oil filler cap highlighted in yellow.
To add oil, remove the filler cap and use a funnel to pour oil
into the opening. Be careful not to overfill the engine. Recheck
the oil level after you finish adding oil.
File:15vxsvn.ex
Update:Wed Jun 5 12:25:18 1996

389
Index
Coolant (see Engine coolant)
checking and adding................ 314
drain and flush................... 318
preparing for storage................ 370
specifications.................... 368
temperature gauge................ 78,82
warnings...................... 314
Cooling fan...................... 296
Cruise control (see Speed control)............ 128
Customer Assistance Centre, Ford of Canada....... 282
D
Dashboard (see Instrument panel)............. 89
Daytime running light system............. 114
Defrost, windshield................... 91
Dipstick
automatic transaxle fluid............... 331
engine oil..................... 311
power steering fluid................. 335
Disabled vehicle (see Towing).............. 273
Dispute Settlement Board................ 278
Doors
door ajar warning light................ 74
lubricant specifications................ 368
Driving under special conditions
bad weather.................... 240
heavy load..................... 241
high speed..................... 240
high water..................... 241
slippery roads................... 240
tips for safe driving................. 239
towing a trailer................... 242
File:vxixn.ex
Update:Fri Jun 7 09:28:47 1996

391
Index
Engine coolant (continued)
preparing for storage................ 370
proper solution................... 333
recovery reservoir................300, 314
specifications.................... 368
temperature gauge................ 78,82
Engine coolant temperature gauge
description.................... 78,82
mechanical.................... 78,82
Engine coolant temperature guage:electronic...... 78,82
Engine fan...................... 296
Engine:idle speed control................. 62
Engine oil
changing oil and oil filter............311, 313
checking and adding................ 311
dipstick...................... 311
disposal....................296, 333
engine oil pressure warning light............ 73
filter, specifications................. 367
specifications.................... 310
synthetic oil.................... 310
ªbreak-inº oils.................... 5
viscosity...................... 310
Entry system, illuminated............... 120
Exhaust fumes...................... 64
F
Fan, engine fan, avoiding injury............. 296
Federal Communications Commission.......... 228
Flashers, hazard.................... 112
Flashing the lamps................... 124
Flat tire........................ 259
Ford Dispute Settlement Board............. 278
Ford Motor Company of Canada............ 282
File:vxixn.ex
Update:Fri Jun 7 09:28:47 1996

397
Index
O
Octane rating..................... 305
Odometer
description...................... 79
trip odometer..................... 80
Oil filter....................... 313
Oil (see Engine oil).................. 310
Oil viscosity...................... 310
On-board diagnostic (OBD II) system.......... 364
Overdrive....................... 231
Overseas offices.................... 284
P
Parking brake
operation...................... 237
warning light..................... 69
Parts (see Motorcraft Parts)............... 367
PCV valve, specifications................ 367
Power door locks................... 140
Power features
door locks..................... 140
mirrors....................... 169
windows...................... 155
Power steering
dipstick...................... 335
driving with power steering............. 234
fluid, checking and adding.............. 335
fluid, specifications................. 368
servicing...................... 234
Prop rod, hood.................... 298
File:vxixn.ex
Update:Fri Jun 7 09:28:47 1996