1996 Mercury Sable radio

177
*
[AS15400(ALL)04/95]
3. Rounded off frequencies
*
[AS15450(ALL)02/95]
Some FM radio stations advertise a
ªrounded-offº frequency which is not the
frequency they actually broadcast on. For
example, a radio station that is assigned a
frequency of 98.7 MHz may call itself ªRadio 99º
even though 99.0 MHz is not an allowable FM
broadcast frequency.
*
[AS15600(ALL)02/95]
Using the Controls of Your Cassette Tape
Player
[AS15700(ALL)04/95]
NOTE: Radio power must be on to use the
cassette tape player.
[AS15800(ALL)04/95]
NOTE: Adjust the volume, treble, bass, balance
and fade controls in the same manner
as for radio stations.
*
[AS15900(ALL)02/95]
How to insert a tape
[AS16025(ALL)04/95]
Your cassette player is equipped with power
loading. Once you insert a tape and push
slightly (with theopen edge to the right), the
loading mechanism draws the tape the rest of
the way in and play will begin after a
momentary tape tightening process. Display
indicates ªTAPEº while tape is playing. If the
ªTAPEº button is pressed when the cassette tape
player is empty, ªNOº and ªTAPEº will flash in
the display and radio play will continue.
[AS16050(ALL)02/95]
NOTE: A cassette tape can be loaded with the
ignition on whether the radio is on or
off. However, if the radio is off, the
cassette tape will be loaded and stored.
*
[AS16300(ALL)02/95]
How to locate a desired track on the tape
*
[AS16350(ALL)02/95]
There are four ways to quickly locate a desired
selection on the tape. You can use the fast
forward, rewind, ªSEEKº or ªSCANº function.
Following are brief descriptions of each.
File:fcass.ex
Update:Wed Dec 20 09:30:38 1995

178
*
[AS16400(ALL)02/95]
q
Fast forwarding the tape
[AS16525(ALL)04/95]
To fast forward the tape, press the ªFFº
button. The radio will automatically begin
playing until fast forward is manually
stopped (by pressing the ªTAPEº, ªEJº,
ªREWº or ªFFº button) or the end of the
tape is reached. The display will show a
flashing
Xto indicate fast forward.
*
[AS16535(ALL)01/95]
At the end of the tape, the direction
automatically reverses and plays the other
side of the tape.
*
[AS16600(ALL)02/95]
q
Rewinding the tape
[AS16725(ALL)04/95]
To rewind the tape, press the ªREWº button.
The radio will automatically begin playing
until rewind is manually stopped (by
pressing the ªTAPEº, ªEJº, ªREWº or ªFFº
button) or the beginning of the tape is
reached. The display will show a flashing
X
to indicate rewind.
*
[AS17000(ALL)01/95]
q
Using the ªSEEKº function with your cassette
tape player
[AS17125(ALL)04/95]
While in the tape mode, press the right (
a)
side of the ªSEEKº button to seek forward to
the next selection on the tape (display
indicates ªSEEKº). Press the left (
b) side to
seek the previous tape selection.
*
[AS17135(ALL)03/95]
NOTE: If you want to restart a currently
playing tape selection, press the left
(
b) side of the ªSEEKº button after
approximately three seconds into the
current selection.
File:fcass.ex
Update:Wed Dec 20 09:30:38 1995

179
*
[AS17200(ALL)01/95]
q
Using the ªSCANº function with your
cassette tape player
[AS17325(ALL)02/95]
Press the ªSCANº button to begin the
forward scan mode on the tape currently
playing, stopping on each tape selection for
approximately an eight-second sampling
(display flashes ªSCANº).
[AS17345(ALL)04/95]
To stop the scan mode on the presently
sampled tape selection press ªSCANº a
second time.
[AS17348(ALL)02/95]
How to change the side of the tape being
played
[AS17350(ALL)02/95]
The alternate side of the tape can be selected at
any time by pressing the ªSIDE 1-2º button.
*
[AS17400(ALL)02/95]
How to eject the tape
[AS17525(ALL)04/95]
To stop the tape and eject the cassette, press the
ªEJº button. The radio will resume playing if the
power is on. The tape cartridge can be ejected
with radio power (and/or ignition) on or off.
*
[AS17550(ALL)01/95]
How to store the tape
[AS17575(ALL)04/95]
Press the ªAMº or ªFMº button (or ªCDº, if
equipped) to stop the tape player and resume
radio play (or CD-DJ).
*
[AS17600(ALL)02/95]
Using the DolbyHB noise reduction feature
*
[AS17700(ALL)02/95]
NOTE: Noise reduction system manufactured
under license from Dolby Labs
Licensing Corporation. ªDolbyº and
double-D symbol are trademarks of
Dolby Laboratories Licensing
Corporation.
*
[AS17825(ALL)04/95]
Push thekbutton to activate Dolby B Noise
Reduction. Push again to deactivate.
File:fcass.ex
Update:Wed Dec 20 09:30:38 1995

180
*
[AS18260(ALL)01/95]
Tape error messages
*
[AS18280(ALL)01/95]
Your cassette tape player is equipped to
diagnose certain problems you may experience.
Error codes are as follows:
[AS18325(ALL)04/95]
TD E1 Ð Possible problem tape cartridge. The
cassette player will automatically eject the tape.
Insert the tape again. If the same error code
appears in the display, try a different tape. If the
problem persists, refer the problem to qualified
personnel for service.
[AS18330(ALL)04/95]
TD E2 Ð Radio cannot eject tape. If tape is not
ejected when the ªEJº button is pressed, refer
the problem to qualified personnel for service.
[AS18350(ALL)12/95]
TD E3 Ð Radio cannot insert tape properly. The
cassette player will automatically eject the tape.
Insert tape again. If the same error code appears
in the display, try a different tape. If the
problem persists, refer the problem to qualified
personnel for service.
*
[AS18500(ALL)02/95]
Tips on Caring for the Cassette Player and
Tapes
*
[AS18600(ALL)02/95]
In order to keep your cassette tape player
performing the way it was meant to, read and
follow these simple precautions:
*
[AS18700(ALL)02/95]
q
Using a Ford Cassette Cleaning Cartridge to
clean the tape player head after 10-12 hours
of play will help maintain the best playback
sound and proper tape operation.
*
[AS18800(ALL)02/95]
q
Only cassettes that are 90 minutes long or
less should be used. Tapes longer than 90
minutes are thinner and subject to breakage
or may jam the tape player mechanism.
*
[AS18900(ALL)02/95]
q
Protect cassettes from exposure to direct
sunlight, high humidity and extreme heat or
cold. If they are exposed to extreme
conditions, allow them to reach a moderate
temperature before playing.
File:fcass.ex
Update:Wed Dec 20 09:30:38 1995

183 [AS29800(ALL)02/95]
4. Insert loaded disc magazine into changer
unit with the arrow on top of the disc
magazine pointing toward the changer
(Figure 4). Make sure magazine is fully
inserted into changer.
[AS29850(ALL)04/95]
quarter page art:0001467-A
Figure 4
[AS29950(ALL)02/95]
5. Close unit by sliding changer panel door to
the rear (sedan) or front (wagon).
[AS30001(ALL)02/95]
The Compact Disc Changer unit is now ready to
play using the controls of your audio system.
*
[AS30050(ALL)02/95]
How to Operate the Ford 6-CD Changer
Using the Controls on the Radio
[AS30101(ALL)02/95]
If your vehicle is equipped with the Ford 6-CD
Changer System, you can operate it through the
controls of your audio system.
*
[AS30150(ALL)02/95]
Several of the controls on the radio operate in
the same manner in CD mode as they do in
radio or cassette mode: turning the power on,
volume control and adjusting the bass, treble,
speaker balance or fade.
*
[AS30201(ALL)02/95]
How to begin CD Changer play
*
[AS30250(ALL)02/95]
NOTE: Radio power must be on to operate the
Compact Disc Changer.
File:fcass.ex
Update:Wed Dec 20 09:30:38 1995

184 [AS30301(ALL)04/95]Push the ªCDº button to begin CD play. If the
disc magazine has just been installed, the CD
Changer will automatically begin playing the
first track (selection) of the first disc loaded in
the unit. After that, the CD Changer will start
on the disc and track where it was stopped. The
display will indicate ªCD-##º for disc number,
then display ªTR-##º for track number, then
ªDD-TTº for disc number and track number.
[AS30325(ALL)04/95]
If the CD Changer is empty, ªNOº and ªCDº
will flash in the display and radio play will
continue.
*
[AS30350(ALL)02/95]
How to change the disc being played
[AS30401(ALL)02/95]
When in the CD mode, you can change discs by
pressing the right (
a) side of the ªTUNE/DISCº
button (to select the next disc) or the left (
b)
side of the ªTUNE/DISCº button (to select the
previous disc). Play will begin on the first track
of the selected disc.
*
[AS30450(ALL)02/95]
When either side of the button is pressed and
held, the CD changer will continue
fast-forwarding or reversing through the discs in
the disc magazine. During these functions, the
display will indicate the disc number.
*
[AS30501(ALL)02/95]
How to change the track being played
*
[AS30550(ALL)02/95]
Press the right (
a) side of the ªSEEKº button to
seek forward to the next track of current disc.
After the last track has been completed, the CD
player automatically wraps back to the first track
of the current disc.
*
[AS30601(ALL)02/95]
Press the left (
b) side of the SEEK button to
seek in reverse to the previous track on the
current disc. If a selection has been playing for
three seconds or more and you press the left
(
b) side of the SEEK button, the CD Changer
will replay that selection from the beginning.
File:fcass.ex
Update:Wed Dec 20 09:30:38 1995

186 [AS31130(ALL)04/95]To turn the compression on, press the ªCOMPº
button. When the compression feature is
activated, the display will indicate ªCº. Press
again to deactivate.
*
[AS31150(ALL)02/95]
How to stop CD play
[AS31200(ALL)04/95]
While in CD Changer mode, press the ªAMº or
ªFMº button to stop CD play and resume radio
play. Loading a cassette into the cassette deck
(or pressing ªTAPEº if a cassette is already
loaded) will stop CD play and begin cassette
play.
%*
[AS32310(ALL)03/95]
How To Take Care of and Clean Your CD
Player and Discs
*
[AS32312(ALL)03/95]
To ensure the continued performance of your
Ford Compact Disc Player, carefully read the
following precautions:
*
[AS32314(ALL)03/95]
q
Always handle the disc by its edge. Never
touch the playing surface.
*
[AS32316(ALL)04/95]
q
Before playing, inspect the disc for any
contamination. If needed, clean the disc with
an approved disc cleaner, such as the
DiscwasherHCompact Disc Cleaner or the
Allsop 3HCompact Disc Cleaner, by wiping
from the center out to the edges.Do not use
a circular motion to clean.
File:fcass.ex
Update:Wed Dec 20 09:30:38 1995

189
*
[AS32344(ALL)03/95]
If play does not begin after the CD button is
pushed:
*
[AS32345(ALL)03/95]
q
The radio is not on.
[AS32346(ALL)02/95]
q
The disc magazine is not fully seated in
changer.
*
[AS32348(ALL)03/95]
q
Moisture may have condensed on the lenses
within the unit. If this occurs, remove the CD
magazine and wait approximately an hour
until the moisture evaporates.
*
[AS32350(ALL)03/95]
If the sound skips:
*
[AS32352(ALL)03/95]
q
Badly scratched discs or extremely rough
roads will cause the sound to skip. Skipping
will not damage the disc player or scratch the
discs.
*
[AS32400(ALL)02/95]
CD Error Messages
[AS32500(ALL)02/95]
Your system is equipped to diagnose certain
problems you may experience. The displayed
error codes are:
[AS32600(ALL)02/95]
NO then CDÐ Empty slot or magazine,
mechanical error, disc(s) unreadable, or
mechanism focus error. Check all discs in the
magazine for scratches and proper insertion. If
problem persists, refer problem to qualified
personnel for service.
[AS32700(ALL)02/95]
NO then DJÐ CD Changer not connected or
not communicating to audio system. Refer
problem to qualified personnel for service.
[AS32800(ALL)04/95]
TOO then HOTÐ The changer's internal
temperature is above140ÊF (60ÊC).Allow the
player to cool before operating.
File:fcass.ex
Update:Wed Dec 20 09:30:38 1995