1996 Mercury Sable engine

286
[SV23716(ALL)04/95]
MicronAirHAir Filter
Replacement
*
[SV23719(ALL)04/95]
In your climate control system, you may have a
filter that cleans the air before it enters the
interior of the vehicle. This filter should be
replaced at the intervals in theMaintenance
Schedule and Recordbooklet.
[SV23723(ALL)04/95]
To replace the MicronAirHair filter:
[SV23725(ALL)04/95]
1. Open the hood. Move the vacuum hose at
the rear passenger side of the engine
compartment by pulling the hose clips off
the leaf screen and removing the loose clip.
With a coin or screwdriver, turn the four
retainers on the leaf screen 90Ê and pull
them straight out. Remove the leaf screen.
[SV23730(ALL)04/95]
one third page art:0001387-A
Removing the vacuum hose clips
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

296
*
[SV28975(ALL)08/94]
q
Do not drive faster than 30 mph (50 km/h)
or the chain manufacturer's recommended
speed limit, whichever is lower. Avoid
bumps, holes and sharp turns. If you can
hear the chains rub or bang against your
vehicle, remove the chains to prevent damage
to your vehicle.
*
[SV29025(ALL)11/94]
q
Tire chains may affect vehicle handling. Drive
carefully and avoid hard braking.
*
[SV29050(ALL)11/94]
q
Do not use chains on temporary spare tires.
They may damage the vehicle and the tire.
*
[SV29150(ALL)05/94]
q
Remove tire chains at the first opportunity
after using them on snow and ice. Do not use
the chains on dry roads.
%*
[SV29160(ALL)04/95]
Cleaning the Wheels
*
[SV29170(ALL)04/95]
Wash the wheels with the same detergent you
use to wash your vehicle's body. Do not use
acid based wheel cleaners, steel wool, abrasives,
fuel, or strong detergents. These substances will
damage the protective coatings. Use tar and road
oil remover to remove grease and tar.
*
[SV29180(ALL)04/95]
NOTE: Before going to a car wash, find out if
the brushes are abrasive.
*
[SV29220(ALL)04/95]
Air Filter
[SV29240(ALL)02/95]
To replace the engine air filter, unclip the two
latches, separate the housing and remove the old
filter. Wipe the interior of the housing clean
before inserting the new filter. Lock the two
latches.
[SV29260(ALL)04/95]
NOTE: Do not use oil-impregnated air filters.
Filters other than the ones specified in
this Owner Guide can cause engine
damage. Your warranties may not
apply if your vehicle is damaged
because you used the wrong air filter.
SeeMotorcraft partsin the Index.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

297
%*
[SV29300(ALL)03/01]
Automatic Transaxle Fluid
*
[SV29310(ALL)03/95]
Under normal circumstances, you do not need to
check the fluid level of the transaxle, since your
vehicle does not use up transaxle fluid. Refer to
theMaintenance Schedule and Recordbooklet for
replacement intervals. However, if the transaxle
is not working properly Ð for instance, the
transaxle may slip or shift slowly, or you may
notice some sign of fluid leakage Ð the fluid
level should be checked.
%*
[SV29340(ALL)02/93]
Checking the Automatic Transaxle Fluid
*
[SV29350(ALL)02/95]
With the vehicle on a level surface and the brake
pedal fully applied, start the engine and move
the gearshift selector through all of the gears.
Allow sufficient time for each position to engage.
Securely latch the gearshift selector in the P
(Park) position. Fully set the parking brake and
leave the engine running.
*
[SV29370(ALL)01/95]
Wipe off the dipstick cap and pull the dipstick
out. Wipe the indicator end clean. Put the
dipstick back into the filler tube and make sure
it is fully seated. Pull the dipstick out and read
the fluid level.
[SV29380(ALL)04/95]
one inch art:0000717-E
Automatic overdrive transaxle fluid dipstick
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

299
*
[SV29425(ALL)04/95]
NOTE: Always dispose of used automotive
fluids in a responsible manner. Follow
your community's standards for
disposing of these types of fluids. Call
your local recycling center to find out
about recycling automotive fluids.
%
*
[SV30200(ALL)03/95]
Brake Fluid
*
[SV30300(ALL)04/95]
Under normal circumstances, your vehicle
should not use up brake fluid rapidly. However,
expect the level of the brake fluid to slowly fall
as you put more mileage on your vehicle and
the brake lining wears.
%*
[SV30400(ALL)06/93]
You should check the brake fluid at every
scheduled engine oil change, but be sure to
check it at least once a year. You can do this by
looking at the fluid level in the plastic reservoir
on the master cylinder. (SeeThe Engine Typesin
this chapter to locate the master cylinder.) The
fluid level should be at or near the MAX mark.
*
[SV30450(ALL)01/95]
RWARNING
Brake fluid contains polyglycol ethers
and polyglycols. Avoid contact with
eyes. Wash hands thoroughly after
handling. If brake fluid contacts eyes,
flush eyes with running water for 15
minutes. Get medical attention if
irritation persists. If taken internally,
drink water and induce vomiting.
Get medical attention immediately.
*
[SV30500(ALL)03/95]
If the fluid is low, carefully clean and remove
the cap from the reservoir. Fill the reservoir to
the MAX line with Ford High Performance DOT
3 Brake Fluid C6AZ-19542-AA or equivalent
DOT 3 fluid meeting Ford specification
ESA-M6C25-A.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

301
%*
[SV31200(ALL)03/95]
Power Steering Fluid
*
[SV31300(ALL)01/95]
Check the level of the power steering fluid at
least twice a year (i.e., every Spring and Fall).
%*
[SV31400(ALL)03/95]
Checking and Adding Power Steering
Fluid
*
[SV31500(ALL)02/95]
1. Start the engine and let it run until the
power steering fluid reaches normal
operating temperature. The power steering
fluid will be at the right temperature when
the engine coolant temperature gauge in the
instrument cluster is near the center of the
NORMAL operating temperature range.
*
[SV31600(ALL)01/95]
2. While the engine idles, turn the steering
wheel back and forth several times. Make
sure that the cap assembly is installed at this
time.
*
[SV31700(ALL)01/95]
3. Then turn the engine off.
[SV31800(ALL)04/95]
3.0L Vulcan engine:
%*
[SV31900(ALL)03/94]
4. Check the fluid level on the dipstick (which
is highlighted in yellow in your vehicle). The
fluid level should be between the arrows in
the FULL HOT range, which is marked on
the side of the dipstick, opposite the side
marked FULL COLD. Do not add fluid if the
level is within the FULL HOT range.
*
[SV32100(ALL)07/94]
5. If the power steering fluid is low, add fluid
in small amounts, continuously checking the
level, until you reach the FULL HOT range.
Do not overfill.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

302 [SV32150(ALL)02/95]
half page art:0000311-CDipstick for power steering fluid (3.0L Vulcan)
*
[SV32175(ALL)03/95]
6. When you are finished, put the dipstick back
in and make sure that it fits snugly.
[SV32225(ALL)04/95]
3.0L Duratec engine:
*
[SV32250(ALL)11/94]
4. Check the fluid level in the power steering
fluid reservoir. The fluid level should be
between the MIN and MAX lines on the side
of the reservoir.
*
[SV32300(ALL)11/94]
5. If the power steering fluid is below the MIN
mark, add fluid in small amounts until the
level is between the MIN and MAX lines on
the side of the reservoir.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

324
%*
[SV41000(ALL)03/95]
Emission Control System
*
[SV41100(ALL)03/95]
Your vehicle is equipped with a catalytic
converter which enables your vehicle to comply
with applicable exhaust emissions requirements.
*
[SV41200(ALL)01/95]
RWARNING
It is important for your safety and
the efficient operation of your
vehicle that the engine and exhaust
system operate properly. Exhaust
leaks may result in the entry of
harmful and potentially lethal fumes,
particularly carbon monoxide, into
the passenger compartment. In
addition, malfunctions in the engine
or exhaust system can result in
excessive exhaust system
temperatures. Under extreme
conditions (for example, towing a
trailer up a steep hill on a very hot
day with a malfunctioning engine or
exhaust system), excessive exhaust
temperatures could damage the fuel
system, the interior floor covering, or
other vehicle components, possibly
causing a fire and resulting in
personal injury.
*
[SV41300(ALL)01/95]
To make sure that the catalytic converter and the
other emissions control parts continue to work
properly:
*
[SV41400(ALL)01/95]
q
Use only unleaded fuel.
*
[SV41500(ALL)01/95]
q
Avoid running out of fuel.
*
[SV41600(ALL)01/95]
q
Do not turn off the ignition while your
vehicle is moving, especially at high speeds.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995

325
*
[SV41700(ALL)03/95]
q
Have the services listed in yourMaintenance
Schedule and Recordbooklet performed
according to the specified schedule.
*
[SV41710(ALL)03/95]
The Scheduled Maintenance Services listed in the
Maintenance Schedule and Recordbooklet are
required because they are considered essential to
the life and performance of your vehicle and to
its emissions system.
%*
[SV41720(ALL)03/95]
Ford strongly recommends the use of genuine
Ford replacement parts. If other than Ford or
Motorcraft parts or Ford authorized
remanufactured parts are used for maintenance
replacements or for the service of components
affecting emissions control, such non-Ford parts
should be equivalent to genuine Ford Motor
Company parts in performance and durability. It
is the owner's responsibility to determine the
equivalency of such parts. Please consult your
warranty booklet for complete warranty
information.
*
[SV41800(ALL)03/95]
RWARNING
Do not park, idle, or drive your
vehicle in dry grass or other dry
ground cover. The emissions system
heats up the engine compartment and
exhaust system, which can start a
fire.
File:fcsvs.ex
Update:Wed Dec 20 09:36:55 1995