CHASSIS
200
SPECIFICATIONS
± AUTOMATIC TRANSMISSION
Fluid capacity
Drain and refill1.9 L (2.0 qt., 1.7 Imp. qt.)
Fluid typeAutomatic transmission fluid Type T ± II or equivalent
± DIFFERENTIAL
Oil capacity
1.3 L (1.4 qt., 1.1 Imp. qt.)
Oil typeHypoid gear oil API GL±5
Oil viscosityAbove ±18C (0F): SAE 90
Below ±18C (0F): SAE 80W or SAE 80W±90
± BRAKES
Pedal clearance
70 mm (2.8 in.) Min. *1
Pedal freeplay1 ± 6 mm (0.04 ± 0.24 in.)
Brake pad wear limitFront: 3.0 mm (0.12 in.)
Rear: 2.5 mm (0.10 in.)
Parking brake lining wear limit1.0 mm (0.04 in.)
Parking brake adjustment5 ± 7 clicks *2
Fluid typeSAE J1703 or FMVSS No. 116 DOT 3
*1: Minimum pedal clearance when depressed with the pressure of 490 N (50 kgf, 110 lbf.) with the engine running
*2: Parking brake adjustment when depressed with the pressure of 294 N (30 kgf, 66.1 lbf.)
CHASSIS
203
CHECKING POWER STEERING
FLUID
Check the fluid level on the dipstick. If necessary, add
automatic transmission fluid DEXRON II or III.
If the vehicle has been driven around 80 km/h (50 mph) for
20 minutes (a little more in frigid temperatures), the fluid is
hot (60C±80C or 140F±175F). You may also check the
level when the fluid is cold (about room temperature,
10C±30C or 50F±85F) if engine has not been run for
about five hours.
If cold O.K.If hot O.K.Add fluid
1. Clean all dirt off the reservoir.
2. Remove the filler cap by turning it counterclockwise and
wipe the dipstick clean.
3. Reinstall the filler cap.
4. Remove the filler cap again and look at the fluid level. If
the fluid is cold, the level should be in the ªCOLDº range on
the dipstick. Similarly, if it is hot, the fluid level should be in
the ªHOTº range. If the level is at the low side of either range,
add automatic transmission fluid DEXRON
II or III to bring
the level within the range.
5. After replacing the filler cap, visually check the steering
box case, vane pump and hose connections for leaks or
damage.
