1996 HONDA CIVIC Oi pump

CD player dimensions cabin filter check engine light fuse diagram fuse box diagram

Page 1856 of 2189

HONDA CIVIC 1996 6.G Workshop Manual Power Distribution
- From Fuse to Relays and Components (contd)
From Batteryon page 10.
i,
FUSE 62ABS +8204
UNDER-HOODABSFUSE/RELAYBOXFUSE 61PUUP MOTOR
I contact I
tl
ABS PUMPMOTOR RELAYPage 44-1
To F

Page 1866 of 2189

$HONDA CIVIC 1996 6.G Workshop Manual _t 89c559 Wrth. - - MilrorFUEL , DetoggerTANKUNIT RIGHTpaoes 74 ; POWERanj sr -r , MIBRORPHofo 103 | Page 141-2 i-l : i-l I ltl I ,,:lit{; FUELTANKFUEL INTERNALPUMP SOLENOIDPaqe 23-1 VALVEor1q: Pag$

Page 1870 of 2189

HONDA CIVIC 1996 6.G Workshop Manual - Gl, G2, G3, and G403
BATTERY
tl
tl
ABSPUMPMOTORSTEERINGPUMPBRACKET
I
I
TRANS-MtsstoN
I
I
PagePHOTO
I
44-5
I
IJ
I
I
T3PHOTO 20
I
I
r4Ptlofo 13
IL
BFI{
1
PHO|O 20G3PHOTO 13
c360
!. c403G1
- G751, G771

Page 1881 of 2189

HONDA CIVIC 1996 6.G Workshop Manual NOT-E: Fu^se.31 is HO-f-with lgnition Switch in START (tD and clutch pedat depressed orA"iT Gear Selector in PARK (P) or NEUTRAL (N), see Siarting Systeni, page 2i or 21-2.
See Int€oratedControl Jni

Page 1895 of 2189

HONDA CIVIC 1996 6.G Workshop Manual PGM-FI (All 99-00 Models except Dl6Y5 with M/T and Dt685)
@r-T-------r UNDER.DASHI t FUSE ro IFUSE/RELAYI FUEL PUMP I BOX
i { {"rl"t* i PHarc 58
! | see Power II H Distribution. I
I I page 1o-2. IL

Page 1896 of 2189

HONDA CIVIC 1996 6.G Workshop Manual NOTE: Fuse 3l is HOT with lgnition Switch in START (lll) and clutch pedal depressed or
A/T Gear Selector in PARK (P) or NEUTRAL (N), see Starting System, page 21 or 21-2.
FUSE 31SIAilEfi SIGT{AL7.fi

Page 1943 of 2189

HONDA CIVIC 1996 6.G Workshop Manual UNDER-HOODABS FUSE/RELAY BOX
r------1
c356
FUSE 63MTNCHECK7.54
c357 2
FUSE 61PUIiPolon
c356
ABSPUMPMOTOR
i-.t_____l
*fitr
3
YEURED
A19
(PMR) (MCK) IPump Motor Icomm6n motdr check IRight rear ABS Leftf

Page 1986 of 2189

HONDA CIVIC 1996 6.G Workshop Manual Front WiperMasher (contd)
- How the Circuit Works
When the ignition switch is in ON (ll) or START (lll),
battery voltage is applied to lhe combination wiper
switch. and the windshield wiDer motor.
Lo

Front WiperMasher (cont'd)
- How the Circuit Works
When the ignition switch is in ON (ll) or START (lll),
battery voltage is applied to lhe combination wiper
switch. and the windshield wiDer motor.
Low Speed
When you turn the wiper switch to LO, the wiper
motor's low speed winding is grounded through the
BLU wire and the LO speed contacts of the wip€r
switch at G401, and the wipers run at low speed.
ParUOfl
When you turn the wiper switch OFF, the integrated
control unit (PARK input) grounds the wiper motor
through the BLUMHT wire. The cam switch on the
motor signals the integrated control unit that the
wipers are in the PARK position; the control unit
then removes ground from the motor, and the
wipers stop in the PARK position.
High Speed
When the wiper switch is in Hl, the high speed
windings of the windshield wiper motor are
grounded through the BLUIrEL wire and the Hl
contacts of the wiper switch at G401, and the
wipers run at high speed.
Intermittent
When the wiper switch is in lNT, battery voltage is
applied through the YEUBLU wire to the integrated
control unit (lntermittent wiper ON input). The
integrated control unit (lnt€rmittenvPark Wiper
Control) grounds the low speed windings of the
wiper motor and the wipers make a single sweep
every few seconds (See Low Speed above). When
the wiper retums to the PARK position, the park
switch applies battery voltage through the
BLUMHT wire to the integrated control unit (PARK
input), and the wipers stop in the PARK position.
Mist
When you pull the wiper switch down to MIST
position, the high speed windings ot the wiper motor
are grounded through the BLU^/EL wire and the
closed contacts ot the mist switch at G401, and the
wipers make one pass across the windshield at high
speed. The ParUOff function then takes over and
the wipers stop in the PARK position.
Washel
When you pull the wiper switch toward you to turn
on the washer switch, battery vollage is applied to
the washer motor. The motor pumps fluid onto the
windshield until you release the lever; on '98r99
models, the integrated control unit (windshield
washer ON input) s€nses power at the WHT/BLK
wire terminal and runs the wipers whenever the
washer motor runs.
Refer lo the Service Manual (Seclion 23, Electrical)
for specific tests or troubleshooting procedures.
91-2

Load next 8 pages

Page: < prev 1-10 ... 161-168 169-176 177-184 185-192 193-200 201-208 next >

charging open hood fuel tank removal service interval reset android auto adblue