1996 FORD TAURUS ABS

55 [SR28550(ALL)12/95]
9. Pull the shoulder belts out to ensure that the
crotch safety belt buckle is securely fastened
and the retractor is locked. Refer to Figure 8.
[SR28575(ALL)12/95]
half page art:0001455-B
Figure 8: Checking for securely latched buckle and locked
retractor
[SR28600(ALL)12/95]
10. If the belts become too tight, unbuckle the
crotch safety belt buckle, allow belts to
retract, then reinsert both belt tongues.
*
[SR28650(ALL)08/95]
To remove the child from the built-in child
seat:
[SR28700(ALL)12/95]
1. Squeeze the tabs on the top and bottom of
the chest clip and pull the halves apart to
open the chest clip. Refer back to Figure 7.
*
[SR28750(ALL)08/95]
2. Press the release button on the crotch safety
belt buckle.
[SR28800(ALL)12/95]
3. Slide the shoulder belts off the child's
shoulders and remove the child. Refer back
to Figure 5.
File:03fcsrt.ex
Update:Mon Jan 22 15:46:18 1996
ProCarManuals.com

180
*
[AS17400(ALL)08/95]
How to eject the tape
[AS17525(ALL)04/95]
To stop the tape and eject the cassette, press the
ªEJº button. The radio will resume playing if the
power is on. The tape cartridge can be ejected
with radio power (and/or ignition) on or off.
*
[AS17550(ALL)08/95]
How to store the tape
[AS17575(ALL)04/95]
Press the ªAMº or ªFMº button (or ªCDº, if
equipped) to stop the tape player and resume
radio play (or CD-DJ).
*
[AS17600(ALL)08/95]
Using the DolbyHB noise reduction feature
*
[AS17700(ALL)08/95]
NOTE: Noise reduction system manufactured
under license from Dolby Labs
Licensing Corporation. ªDolbyº and
double-D symbol are trademarks of
Dolby Laboratories Licensing
Corporation.
*
[AS17825(ALL)04/95]
Push thekbutton to activate Dolby B Noise
Reduction. Push again to deactivate.
*
[AS18260(ALL)08/95]
Tape error messages
*
[AS18280(ALL)08/95]
Your cassette tape player is equipped to
diagnose certain problems you may experience.
Error codes are as follows:
[AS18325(ALL)04/95]
TD E1 Ð Possible problem tape cartridge. The
cassette player will automatically eject the tape.
Insert the tape again. If the same error code
appears in the display, try a different tape. If the
problem persists, refer the problem to qualified
personnel for service.
[AS18330(ALL)04/95]
TD E2 Ð Radio cannot eject tape. If tape is not
ejected when the ªEJº button is pressed, refer
the problem to qualified personnel for service.
File:09fcast.ex
Update:Mon Jan 22 15:58:04 1996
ProCarManuals.com

202
[DR16170( T)10/95]
Semi-Active Ride Control
(SHO only)
[DR16190( T)12/95]
Your vehicle is equipped with a semi-active ride
control suspension system. Ride and handling is
enhanced by firm shock absorber performance
during certain road conditions and handling
maneuvers. The shock absorber is returned to a
softer performance when driver or road surface
induced motion ceases. This system is automatic
with no direct driver input required.
%
*
[DR16200(ALL)03/95]
Brakes
%*
[DR16300(ALL)01/95]
Applying the Brakes
*
[DR16450(ALL)05/95]
Your vehicle may have four-wheel power
anti-lock disc brakes which adjust automatically
through everyday use.
*
[DR16500(ALL)05/95]
Some models have power front disc brakes and
rear drum brakes which automatically adjust as
the brake pads and linings wear down.
*
[DR16700(ALL)05/95]
If your vehicle does not have anti-lock brakes,
apply the brake pedal gradually. Use the
ªsqueezeº technique Ð push on the brake pedal
with a steadily increasing force. This allows the
wheels to continue to roll while you are slowing
down, which lets you steer properly.
*
[DR16800(ALL)05/95]
If your vehicle does not have anti-lock brakes,
extreme braking can make the wheels lock and
slide, causing you to lose control of the steering.
If the wheels lock, release the brake pedal and
repeat the ªsqueezeº technique.
*
[DR16900(ALL)05/95]
Do not drive with your foot resting on the brake
pedal; you will wear out the linings and increase
your vehicle's stopping distance. Brake rotor
damage may also eventually occur.
File:10fcdrt.ex
Update:Mon Jan 22 15:59:33 1996
ProCarManuals.com

203
*
[DR17000(ALL)09/95]
NOTE: If you are driving down a long or
steep hill, shift to a lower gear and do
not apply your brakes continuously. If
you apply your brakes continuously,
they may overheat and become less
effective.
%*
[DR17100(ALL)10/95]
Occasional brake squeal during light to moderate
stops does not affect the function of the brake
system and is normal. However, if the squeal
becomes louder or more frequent, have your
brakes inspected by your dealer or a qualified
service technician.
% [DR17350(ALL)02/95]
Anti-lock Brake System (ABS)
(If equipped)
*
[DR17450(ALL)05/95]
If your vehicle is equipped with the anti-lock
brake system (ABS), the wheels will not lock and
slide when you press down hard on the brake
pedal. The ABS automatically starts releasing
and reapplying the front brakes independently
and the rear brakes together whenever your
vehicle's wheels start to lock. When this
happens, you will feel the brake pedal pulsate.
This is an indication that the ABS is working
correctly and is normal.
*
[DR17500(ALL)05/95]
If the brake pedal is applied while the vehicle is
driven over uneven road surfaces, the ABS may
cycle and the driver may sense a pulsation in
the brake pedal, accompanied by a slight up and
down movement of the pedal height and a
clicking sound. This may also happen when
driving on an inclined surface such as a
driveway while making a sharp turn. This is a
normal condition.
File:10fcdrt.ex
Update:Mon Jan 22 15:59:33 1996
ProCarManuals.com

204
*
[DR17600(ALL)05/95]
Each time you turn the ignition key to the ON
position, the ABS will function through one test
cycle. When this happens, the ABS light will
come on for up to five seconds. If the light stays
on longer than five seconds, shut off the engine
and restart. If it remains on, it means the ABS is
disabled and should be serviced immediately to
restore the benefits of the anti-lock feature.
Normal braking is not affected unless the red
BRAKE system warning light is also lit.
*
[DR17650(ALL)05/95]
ABS has self-check capabilities. As described
above, the system turns on the ABS light each
time you start your engine. After the engine is
started and the ABS light turns off, the system
performs another test the first time the vehicle
reaches 4-9 mph (6-15 km/h). The system turns
on the ABS pump motor for approximately 1/2
second. At this time, a mechanical noise may be
heard. This is a normal part of the self-check
feature. If a malfunction is found during this
check the ABS light will come on.
[DR17675(ALL)02/95]
Vehicles with ABS are identified with a label on
the front door pillar.
*
[DR17700(ALL)08/95]
Ford Motor Company has not found any
negative effects of mobile radio transmitting
equipment installed on vehicles with the ABS
system providing that the radio is installed
according to the radio manufacturer's
instructions. However, if you have had a mobile
radio transmitter installed and the ABS light
comes on (at any time other than immediately
after turning the key to the ON position) have
your mobile radio dealer inspect the radio
installation. Also, if the ABS system is activated
other than during maximum braking, have your
mobile radio installation checked.
File:10fcdrt.ex
Update:Mon Jan 22 15:59:33 1996
ProCarManuals.com

265 [SV06850(ALL)04/95]
RWARNING
The fuel system may be under pressure. If
the fuel cap is venting vapor or if you
hear a hissing sound, wait until it stops
before completely removing the cap.
Otherwise, fuel may spray out and injure
you or others.
*
[SV06900(ALL)05/95]
2. Make sure that you pump unleaded fuel and
put the nozzle all the way inside the fuel
filler pipe.
[SV06950(ALL)09/95]
NOTE: To help reduce early nozzle shutoffs
and fuel spillage, park your vehicle so
that the fuel filler door is not
downhill. Do not tilt or turn the nozzle
upside down when filling. Avoid
excessively fast fuel dispensing rates
(over 10 gallons [38 liters] per minute).
*
[SV07150(ALL)08/95]
NOTE: If you spill any fuel on the body of
your vehicle, clean it off immediately.
The fuel may dull or soften the paint
if you do not wash it off.
[SV07200(ALL)10/95]
3. To replace the fuel cap, align the tabs on the
cap with the notches on the filler pipe. Turn
it clockwise until it stops.
*
[SV07250(ALL)10/95]
4. Push the fuel door closed.
[SV07275(ALL)04/95]
If the Service Engine Soon warning light comes
on and stays on when you start the engine, the
fuel cap may not be properly seated. Turn off
the engine, remove the fuel cap and replace it,
being careful to align the cap properly. For more
information, seeWarning lightsin the Index.
*
[SV07290(ALL)07/95]
If you lose the fuel cap, replace it with an
authorized Motorcraft or equivalent part.
File:15fcsvt.ex
Update:Tue Jan 23 13:58:51 1996
ProCarManuals.com

268 %
*
[SV10185(ALL)06/95]
Safety Information Relating to Automotive
Fuels
*
[SV10195(ALL)05/95]
RWARNING
Automotive fuels can cause serious injury
or death if misused or mishandled.
*
[SV10200(ALL)08/95]
Gasoline and other automotive fuels are
extremely flammable. Turn your vehicle off and
do not smoke while refueling your vehicle. Keep
sparks and other sources of ignition away from
fuels.
[SV10205(ALL)08/95]
Automotive fuels can be harmful or fatal if
swallowed.Never attempt to siphon any fuel
by mouth.
*
[SV10210(ALL)08/95]
If any fuel is swallowed, call a physician or
poison control center immediately.Do not delay
calling a physician merely because no adverse
effects are noticed at first; the toxic effects of
fuels may not become apparent for many
hours.
*
[SV10213(ALL)08/95]
If gasoline is swallowed, do not induce
vomiting. If a gasoline-methanol blend is
swallowed, induce vomiting under the direction
of a physician or poison control center.
*
[SV10215(ALL)08/95]
Gasoline and gasoline blends may contain small
amounts of carcinogens, such as benzene.
Long-term exposure to unleaded gasoline vapors
has caused cancer in laboratory animals.
*
[SV10220(ALL)08/95]
Fuels can also be harmful if absorbed through
the skin. Be careful not to splash fuel on
yourself or your clothing. If fuel is splashed on
the skin, promptly remove contaminated clothing
and wash the skin thoroughly with soap and
water.
File:15fcsvt.ex
Update:Tue Jan 23 13:58:51 1996
ProCarManuals.com

315
*
[SV39501(ALL)02/95]
4. Remove the bulb retaining ring by rotating it
counterclockwise (when viewed from the
rear) about an eighth of a turn to free it
from the bulb socket, and by sliding the ring
off the plastic base. Keep the ring. It is to be
used again to retain the new bulb.
[SV39550(ALL)02/95]
5. Carefully remove the bulb from its socket by
gently pulling it straight back out of the
socket. Do not turn the bulb while you
remove it.
*
[SV39601(ALL)03/95]
To install a bulb:
*
[SV39650(ALL)02/95]
1. With the flat side of the bulb's plastic base
facing upward, insert the glass end of the
bulb into the socket. You may need to turn
the bulb left or right to line up the grooves
in the plastic base with the tabs in the
socket. When the grooves are aligned, push
the bulb into the socket until the plastic base
contacts the rear of the socket.
*
[SV39701(ALL)08/95]
2. Slip the bulb retaining ring over the plastic
base until it contacts the rear of the socket.
Lock the ring into the socket by rotating it
clockwise until you feel a ªstop.º
*
[SV39750(ALL)02/95]
3. Push the electrical connector into the rear of
the plastic base until it snaps, locking it into
position.
*
[SV39800(ALL)02/95]
4. Turn the headlamps on and make sure that
they work properly. If the headlamp was
correctly aligned before you changed the
bulb, you should not need to align it again.
File:15fcsvt.ex
Update:Tue Jan 23 13:58:51 1996
ProCarManuals.com