1996 FORD TAURUS lock

163 [FV39000(ALL)04/95]
one third page art:0001471-A
The cargo cover
% [FV39200(ALL)11/94]
Luggage Rack
[FV39300(ALL)02/95]
You can move the rear luggage crossbar on top
of the vehicle to fit the item you need to carry.
The front crossbar does not move.
[FV39400(ALL)10/90]
To adjust the luggage rack:
[FV39500(ALL)02/95]
1. Load your luggage close to the front
crossbar. Do not carry more than 100 pounds
(45 kg) or cause the vehicle to exceed the
gross vehicle weight rating (GVWR), which
is shown on the Safety Compliance
Certification Label.
[FV39600(ALL)02/95]
2. Loosen the adjusting levers on the rear
crossbar by pushing them toward the center
of the vehicle.
[FV39700(ALL)10/90]
3. Slide the rear crossbar forward to hold your
luggage securely in place.
[FV39800(ALL)02/95]
4. Clamp the adjusting levers again by pulling
them toward the outside of the vehicle.
[FV39825(ALL)00/95]
Make sure that the rear crossbar pins are locked
in slots by pulling forward and back on each of
the outside supports. If the crossbar slides, push
or pull until you hear it click and feel it lock
into position.
File:08fcfvt.ex
Update:Mon Jan 22 15:57:12 1996
ProCarManuals.com

165 [FV40500(ALL)05/95]
To raise the seatback:
[FV40700(ALL)02/95]
1. Lift the seatback rearward until it is in the
upright position. Push the center of the seat
until you hear it latch.
[FV40750(ALL)05/95]
2. Make sure the seatback is locked in position
by pushing forward and backward on it.
*
[FV40775(ALL)05/95]
RWARNING
Securely latch the seatback in the upright
position to prevent the seatback or objects
from being thrown forward during a
sudden stop or collision.
[FV40800(ALL)11/94]
The Third Seat
[FV40900(ALL)04/95]
The third seat faces the back of the wagon. For
height and weight limits, see the label on the
seat cushion. When the seat is down, the back
part of your wagon has a flat surface for
carrying cargo.
[FV41000(ALL)03/92]
To open up the seat:
[FV41100(ALL)04/95]
1. Unlock the floor panel with the key.
[FV41200(ALL)11/94]
2. Use the handle to fold the floor panel
toward the front of the car.
File:08fcfvt.ex
Update:Mon Jan 22 15:57:12 1996
ProCarManuals.com

167 [FV41350(ALL)04/95]
3.Remove the cargo cover.The cargo cover
must be removed or the seatback cannot be
locked in the upright position.
[FV41450(ALL)11/94]
4. Lift the remote latch release on the left side
of the well and fold the remaining floor
panel toward the front of the car until it
latches. Make sure the seatback is locked in
the upright position by pushing forward and
backward on it.
[FV41500(ALL)03/92]
To close the seat:
[FV41600(ALL)02/95]
1. Ensure that the third row safety belts are
fully stowed, and belts located in notches.
[FV41700(ALL)11/94]
2. Lift the remote latch release and push the
seat down until it latches.
[FV41800(ALL)04/95]
3. Pull up on the handle and push the floor
panel into place.
[FV41850(ALL)05/95]
RWARNING
Be sure to keep the floor panel closed and
locked at all times. Unattended children
could possibly become trapped inside or
loose items could be thrown around.
File:08fcfvt.ex
Update:Mon Jan 22 15:57:12 1996
ProCarManuals.com

192 %
*
[DR03800(ALL)01/95]
Putting Your Vehicle in Gear
*
[DR04001(ALL)05/95]
RWARNING
Hold the brake pedal down while you
move the gearshift lever from position to
position. If you do not hold the brake
pedal down, your vehicle may move
unexpectedly and injure someone.
*
[DR04050(ALL)03/95]
To operate:
*
[DR04101(ALL)01/95]
1. Start the engine.
*
[DR04150(ALL)01/95]
2. Depress and hold the brake pedal.
*
[DR04201(ALL)01/95]
3. Move the gearshift lever out of P (Park).
%*
[DR04250(ALL)04/95]
Your vehicle is equipped with a Brake Shift
Interlock safety feature. This feature prevents the
gearshift from being moved from the P (Park)
position until the brake pedal is depressed. This
feature is active when the ignition is in the ON
position. If the gearshift lever CANNOT be
moved from P (Park) with the brake pedal
depressed:
*
[DR04300(ALL)01/95]
1. Turn the engine off and remove the ignition
key.
[DR04350(ALL)11/94]
2. Reinsert the ignition key and turn clockwise
to the first position (OFF).
[DR04400(ALL)11/94]
3. Depress the brake pedal, move the gearshift
lever to N (Neutral) and start the engine.
*
[DR04425(ALL)07/95]
If you need to shift out of P (Park) by using the
alternate procedure described above, it is
possible that a fuse has blown and that your
brakelamps may also not be functional. Please
refer to the chapter titledServicing Your Taurus
in this Owner Guide for instructions on checking
and replacing fuses.
File:10fcdrt.ex
Update:Mon Jan 22 15:59:33 1996
ProCarManuals.com

194 %
*
[DR05300(ALL)01/95]
Driving
%*
[DR05400(ALL)04/95]
When to usej(Overdrive)
*
[DR05500(ALL)04/95]
j(Overdrive) is the usual driving position for
an automatic overdrive transaxle. It works the
same way D (Drive) works, automatically
upshifting or downshifting as the vehicle speeds
or slows.
*
[DR05600(ALL)04/95]
However,j(Overdrive) also shifts into a fourth
gear Ð an overdrive gear Ð when your vehicle
cruises at a consistent speed for any length of
time. This fourth gear will increase your fuel
economy when you travel at cruising speeds.
*
[DR05800(ALL)06/95]
When to use D (Drive)
[DR06000(ALL)12/95]
D (Drive) eliminates the excessive shifting
between third and fourth gears that your vehicle
sometimes does when you are traveling through
hilly terrain inj(Overdrive). It also provides
more engine braking thanj(Overdrive) for
descending hills or city driving.
*
[DR06100(ALL)06/95]
When to use 1 (First)
*
[DR06200(ALL)11/94]
Use 1 (First) when added engine braking is
desired when descending steep hills.
*
[DR06220(ALL)11/94]
The automatic transaxle will shift to the proper
gear to ascend any grade without any need to
shift to 1 (First).
[DR06300(ALL)04/95]
Do not go faster than 38 mph (61 km/h) in this
gear. You can upshift from 1 (First) to D (Drive)
or from 1 (First) toj(Overdrive) at any speed.
*
[DR06400(ALL)01/95]
P (Park)
*
[DR06500(ALL)11/94]
Always come to a complete stop before you shift
into P (Park). Make sure that the gearshift is
securely latched in P (Park). This locks the
transaxle and prevents the front wheels from
rotating.
File:10fcdrt.ex
Update:Mon Jan 22 15:59:33 1996
ProCarManuals.com

195
*
[DR06600(ALL)06/95]
RWARNING
Always set the parking brake fully and
make sure the gearshift is securely latched
in P (Park).
*
[DR06625(ALL)06/95]
RWARNING
Never leave your vehicle unattended
while it is running.
[DR06700(ALL)11/94]
You can tell a column-mounted gearshift is
securely latched in P (Park) if you cannot move
it without pulling it toward you and rotating it
downward.
% [DR06705(ALL)04/95]Driving with an Automatic
Overdrive Transaxle (Column or
Console Gearshift with O/D OFF
Switch)
[DR06710(ALL)02/95]
Your automatic overdrive transaxle provides
fully automatic operation in either D (Overdrive)
or with the O/D OFF Switch depressed. Driving
with the shift selector in D (Overdrive) gives the
best fuel economy for normal driving conditions.
For manual control, start in 1 (First) and then
shift manually.
%*
[DR06730(ALL)01/95]
Putting Your Vehicle in Gear
[DR06735(ALL)04/95]
You must push in the thumb button to move the
console-mounted gearshift to the position you
choose.
[DR06740(ALL)02/95]
To move the gearshift out of P (Park), the
ignition must be turned from the locked position
to either the OFF or the ON position.
File:10fcdrt.ex
Update:Mon Jan 22 15:59:33 1996
ProCarManuals.com

196
*
[DR06745(ALL)03/95]
To operate:
*
[DR06750(ALL)01/95]
1. Start the engine.
*
[DR06755(ALL)01/95]
2. Depress and hold the brake pedal.
*
[DR06760(ALL)01/95]
3. Move the gearshift lever out of P (Park).
%*
[DR06765(ALL)04/95]
Your vehicle is equipped with a Brake Shift
Interlock safety feature. This feature prevents the
gearshift from being moved from the P (Park)
position until the brake pedal is depressed. This
feature is active when the ignition is in the ON
position. If the gearshift lever CANNOT be
moved from P (Park) with the brake pedal
depressed:
*
[DR06770(ALL)01/95]
1. Turn the engine off and remove the ignition
key.
[DR06775(ALL)11/94]
2. Reinsert the ignition key and turn clockwise
to the first position (OFF).
[DR06780(ALL)11/94]
3. Depress the brake pedal, move the gearshift
lever to N (Neutral) and start the engine.
*
[DR06781(ALL)07/95]
If you need to shift out of P (Park) by using the
alternate procedure described above, it is
possible that a fuse has blown and that your
brakelamps may also not be functional. Please
refer to the chapter titledServicing Your Taurus
in this Owner Guide for instructions on checking
and replacing fuses.
*
[DR06783(ALL)09/95]
RWARNING
DO NOT DRIVE YOUR VEHICLE UNTIL
YOU VERIFY THAT THE BRAKELAMPS
ARE WORKING.
File:10fcdrt.ex
Update:Mon Jan 22 15:59:33 1996
ProCarManuals.com

198 [DR06789(ALL)04/95]If your gearshift is on the console, you can use
any of the following positions:
% [DR06790(ALL)04/95]
half page art:0001028-D
The console-mounted gearshift
*
[DR06791(ALL)04/95]
The console-mounted gearshift will lock when
you turn the key to the LOCK position. When
the gearshift is in any position except P (Park),
the ignition key cannot be turned to LOCK or
removed from the steering column. TO
REMOVE THE KEY, the gearshift levermustbe
in P (Park).
*
[DR06793(ALL)11/94]
Once the gearshift is secure in the desired
position, release the brake pedal and use the
accelerator as necessary.
%*
[DR06795(ALL)01/95]
R (Reverse)
*
[DR06800(ALL)08/95]
With the gearshift in the R (Reverse) position,
the vehicle will move backward. You should
always come to a complete stop before shifting
into or out of R (Reverse).
File:10fcdrt.ex
Update:Mon Jan 22 15:59:33 1996
ProCarManuals.com