Page 85 of 298
85 [SC04220(ALL)11/91]
Interval Wipers (If equipped)
[SC04240(ALL)08/91]
In addition to two speed wipers, your vehicle
may have wipers that you can set to operate at
varying intervals. For example, you can set the
interval so they wipe less often when it drizzles
and more often in heavier rain.
[SC04260(ALL)01/92]
quarter page art:0032035-B
Variable interval wiper control
[SC04280(ALL)11/91]
To set the interval wipers, pull the lever down
to the first position. Turn the ring on the lever
to the frequency of wiper operation you desire.
*
[SC04300(ALL)05/95]
Windshield Washer
[SC04425(ALL)01/92]
To clean the windshield, pull the wiper lever
toward you. Washer fluid sprays until the lever
is released.
[SC04450(ALL)01/92]
quarter page art:0032057-B
Windshield washer/control
File:prscp.ex
Update:Fri Jun 23 19:37:07 1995
Page 86 of 298
86 [SC04550(ALL)05/95]If the washer does not work, check the washer
fluid level visually and fill if needed. See
Servicing Your Probelater in this owner guide. If
there is fluid in the reservoir, and your washer
doesn't work, consult your Ford or
Lincoln-Mercury dealer.
*
[SC04700(ALL)01/95]
Do not try to clean the windshield when the
washer fluid container is empty or activate the
washers at any time for more than 15 seconds
continuously. This could damage the washer
pump system.
*
[SC04800(ALL)01/93]
RWARNING
In freezing weather, the washer solution
may freeze on the windshield and obscure
your vision. Always warm up the
windshield with the defroster before you
use the washer fluid. If you cannot see
through the windshield clearly, it can
increase the risk of being involved in a
collision.
File:prscp.ex
Update:Fri Jun 23 19:37:07 1995
Page 207 of 298
![FORD PROBE 1996 2.G Owners Manual 210 %
*
[SV05600(ALL)04/95]
Cleaning the Engine
*
[SV05610(ALL)04/95]
A clean engine is more efficient because the
engine is able to cool properly. A build up of
grease and dirt acts as an insulator, FORD PROBE 1996 2.G Owners Manual 210 %
*
[SV05600(ALL)04/95]
Cleaning the Engine
*
[SV05610(ALL)04/95]
A clean engine is more efficient because the
engine is able to cool properly. A build up of
grease and dirt acts as an insulator,](/manual-img/11/5320/w960_5320-206.png)
210 %
*
[SV05600(ALL)04/95]
Cleaning the Engine
*
[SV05610(ALL)04/95]
A clean engine is more efficient because the
engine is able to cool properly. A build up of
grease and dirt acts as an insulator, keeping the
engine warmer than normal.
*
[SV05620(ALL)05/95]
q
Extreme care must be used if a power washer
is used to clean the engine. The high pressure
fluid could penetrate sealed parts and
assemblies causing damage or malfunctions.
*
[SV05630(ALL)04/95]
q
In order to avoid possible cracking of the
engine block or fuel injection pump, do not
spray a hot engine or injection pump with
cold water.
*
[SV05640(ALL)06/95]
q
The alternator, distributor and air intake must
be covered. Covering these components will
help prevent water damage.
*
[SV05650(ALL)04/95]
Never wash or rinse the engine while it is
running. Water getting into the engine may
cause internal damage.
*
[SV06100(ALL)03/95]
Filling the Fuel Tank
[SV06200(ALL)03/90]
Fuel filler door release lever
[SV06300(ALL)11/91]
Your vehicle is equipped with a fuel filler door
release. To open the fuel filler door, pull up on
the release lever which is located in front of the
driver's seat and near the door.
[SV06350(ALL)01/94]
Remote Fuel Filler-Lid Release Override
[SV06410(ALL)01/95]
If the release does not operate, open the
hatchback, remove the trim on the left rear side,
reach into the opening and pull the latch toward
the rear (see the service manual for trim
removal). You should wear gloves to protect
your hands from any sharp edges when you use
the fuel filler-lid release override.
File:prsvp.ex
Update:Fri Jun 23 19:33:26 1995
Page 219 of 298
222 [SV18200(ALL)01/92]
half page art:0032038-BEngine coolant recovery reservoir and dipstick
*
[SV18500(ALL)01/95]
Adding engine coolant
*
[SV18600(ALL)05/95]
RWARNING
Do not put engine coolant in the container
for the windshield washer fluid.
*
[SV18610(ALL)06/95]
If sprayed to clean the glass, engine coolant or
antifreeze could make it difficult to see through
the windshield.
[SV18650(ALL)02/95]
Add engine coolant only to the recovery
reservoir Ð not to the radiator.If the coolant
level is low, add to the engine coolant recovery
reservoir container a 50/50 mixture of water and
the type of coolant that Ford specifies. Check the
coolant level again the next few times you drive
your vehicle.
File:prsvp.ex
Update:Fri Jun 23 19:33:26 1995
Page 226 of 298
![FORD PROBE 1996 2.G Owners Manual 229 [SV22035(ALL)02/92]
4. Replace the radiator breather cap and the
coolant system cap and tighten to the first
stop.
[SV22050(ALL)02/92]
5. Start and idle the engine until the radiator
upper hose is FORD PROBE 1996 2.G Owners Manual 229 [SV22035(ALL)02/92]
4. Replace the radiator breather cap and the
coolant system cap and tighten to the first
stop.
[SV22050(ALL)02/92]
5. Start and idle the engine until the radiator
upper hose is](/manual-img/11/5320/w960_5320-225.png)
229 [SV22035(ALL)02/92]
4. Replace the radiator breather cap and the
coolant system cap and tighten to the first
stop.
[SV22050(ALL)02/92]
5. Start and idle the engine until the radiator
upper hose is warm. The warm hose
indicates the thermostat is open and the
engine coolant is flowing through the entire
system.
[SV22060(ALL)02/92]
6. Shut the engine off and check the fluid level
in the radiator through the coolant system
cap opening. Add more fluid if necessary.
[SV22070(ALL)02/92]
7. When the radiator is filled to the proper
level, replace the coolant system cap and
tighten both caps completely.
%*
[SV22100(ALL)11/94]
Checking hoses
*
[SV22200(ALL)01/89]
Check all engine and heater system hoses and
hose connections for deterioration, leaks, and
loose hose clamps as specified in the
maintenance schedule. Repair or replace with
Motorcraft hoses or equivalent as necessary.
%
*
[SV22300(ALL)03/95]
Windshield Washer Fluid and
Wipers
*
[SV22350(ALL)03/95]
Washer Fluid
[SV22500(ALL)01/95]
Check the level of the windshield washer fluid
every time you stop for fuel. The reservoir for
the windshield washer fluid is located in the
engine compartment. Visual inspection can
determine if the washer fluid is adequate. Do
not operate the washer when the reservoir is
empty.
File:prsvp.ex
Update:Fri Jun 23 19:33:26 1995
Page 227 of 298
230 [SV22600(ALL)05/95]
half page art:0032082-AWindshield washer fluid reservoir
*
[SV23000(ALL)05/95]
RWARNING
Do not put windshield washer fluid in the
container for the engine coolant.
%*
[SV23100(ALL)01/95]
Use specially formulated windshield washer
fluid rather than plain water, because specially
formulated washer fluids contain additives that
dissolve road grime. For safety reasons, washer
fluids containing an appropriate antifreeze such
as methanol should be used in freezing weather
(temperatures below32ÊF [0ÊC]).State or local
regulations on Volatile Organic Compounds
(VOC's) may restrict use of the most common
antifreeze, methanol. Washer fluids containing
non-methanol antifreeze agents should be used
only if they provide cold weather protection
without damaging the vehicle's paint finish,
wiper blades, and windshield washer system.
File:prsvp.ex
Update:Fri Jun 23 19:33:26 1995
Page 297 of 298
306 Index
Washer fluid
reservoir............... 229
windshield.............. 229
Weight limits (GAWR, GVWR)...... 164
Wheel and tire matching......... 235
Wheel dollies (see Towing)........ 181
Wheels
cleaning............... 239
covers................ 177
inspection and maintenance...... 232
lug nuts............... 175
replacement............. 235
Windows................ 101
one-touch down............ 101
power windows, operating....... 101
Windshield washer fluid and wipers
checking and adding fluid....... 229
operation................ 84
reservoir............... 229
specifications............. 230
Windshield wipers and washer....... 84
Wrecker towing............. 181
File:prixp.ex
Update:Fri Jun 23 19:30:26 1995