1996 FORD PROBE coolant

226 %
*
[SV20600(ALL)01/95]
Use Ford Premium Cooling System Fluid or an
equivalent engine coolant that meets Ford
Specification ESE-M97B44-A. Do not use alcohol
or methanol antifreeze and do not use engine
coolant mixed with alcohol or methanol
antifreeze. If you do not use the proper coolant,
the aluminum radiator on your vehicle will
corrode.
*
[SV20700(ALL)04/93]
Leave the engine coolant in all year. Make sure
that the coolant will not freeze at the
temperature level in which you drive during
winter months. Keep an engine coolant in your
engine that has a protection rating of at least
-20ÊF (-29ÊC), orwhatever protection rating is
appropriate for the climate in which you live.
*
[SV20800(ALL)03/95]
To find out how much engine coolant mixture
your vehicle's coolant system can hold, seeRefill
capacities for fluidsin the Index.
*
[SV20900(ALL)02/95]
You may add water by itself only in an
emergency, but you should replace it with a
50/50 mixture as soon as possible.
*
[SV21000(ALL)01/95]
Have your dealer check the engine cooling
system for leaks if you have to add a quart
(liter) of engine coolant more than once a month.
*
[SV21200(ALL)05/95]
Engine coolant drain and flush
*
[SV21300(ALL)05/94]
The proper procedures to completely drain and
flush the engine cooling system can be found in
the Service Manual for your vehicle or you can
see your dealer. See the order form located
before this chapter. Follow these recommended
procedures to ensure that your vehicle has the
specified engine level and 50/50 mixture of
cooling system fluid and water.
File:prsvp.ex
Update:Fri Jun 23 19:33:26 1995

227 [SV21450(ALL)05/95]
Refilling the engine coolant Ð 2.0L engine
*
[SV21500(ALL)03/95]
When the entire engine cooling system is to be
drained and refilled, use the following
procedure:
*
[SV21600(ALL)01/89]
1. Remove the radiator cap.
*
[SV21700(ALL)06/89]
2. With the engine off and cool, add a 50/50
mixture of recommended engine cooling
system fluid and water until the radiator is
full.
*
[SV21800(ALL)07/93]
3. Replace and fully tighten the radiator cap,
then unscrew the cap to the first stop.
*
[SV21900(ALL)06/89]
4. Start and idle the engine until the radiator
upper hose is warm (this indicates the
thermostat is open and engine coolant is
flowing through the entire system).
[SV22000(ALL)04/95]
5. Shut the engine off and check the fluid level
in the radiator. Add more fluid if necessary.
[SV22005(ALL)03/94]
6. When the radiator is filled to the proper
level, replace the coolant system cap and
tighten both caps completely.
[SV22010(ALL)01/92]
Refilling the engine coolant Ð 2.5L engine
[SV22015(ALL)04/95]
When the entire cooling system is to be drained
and refilled, use the following procedure:
[SV22020(ALL)04/93]
1. Locate the radiator breather cap and the
coolant system cap in your engine
compartment. The cap on your right
(driver's side) is the radiator breather cap.
The cap on your left (passenger's side) is the
coolant system cap.
File:prsvp.ex
Update:Fri Jun 23 19:33:26 1995

228 [SV22025(ALL)04/95]
three fourths page art:0032104-BLocation of coolant system caps and coolant reservoir Ð
2.5L engine
[SV22028(ALL)02/92]
2. Remove the radiator breather cap and the
coolant system cap.
[SV22030(ALL)02/92]
3. With the engine off and cool, add a 50/50
mixture of recommended engine coolant
fluid and water to the radiator, using the
coolant system cap opening, until the
radiator is full. You should be able to see the
fluid through the radiator breather cap
opening.
File:prsvp.ex
Update:Fri Jun 23 19:33:26 1995

229 [SV22035(ALL)02/92]
4. Replace the radiator breather cap and the
coolant system cap and tighten to the first
stop.
[SV22050(ALL)02/92]
5. Start and idle the engine until the radiator
upper hose is warm. The warm hose
indicates the thermostat is open and the
engine coolant is flowing through the entire
system.
[SV22060(ALL)02/92]
6. Shut the engine off and check the fluid level
in the radiator through the coolant system
cap opening. Add more fluid if necessary.
[SV22070(ALL)02/92]
7. When the radiator is filled to the proper
level, replace the coolant system cap and
tighten both caps completely.
%*
[SV22100(ALL)11/94]
Checking hoses
*
[SV22200(ALL)01/89]
Check all engine and heater system hoses and
hose connections for deterioration, leaks, and
loose hose clamps as specified in the
maintenance schedule. Repair or replace with
Motorcraft hoses or equivalent as necessary.
%
*
[SV22300(ALL)03/95]
Windshield Washer Fluid and
Wipers
*
[SV22350(ALL)03/95]
Washer Fluid
[SV22500(ALL)01/95]
Check the level of the windshield washer fluid
every time you stop for fuel. The reservoir for
the windshield washer fluid is located in the
engine compartment. Visual inspection can
determine if the washer fluid is adequate. Do
not operate the washer when the reservoir is
empty.
File:prsvp.ex
Update:Fri Jun 23 19:33:26 1995

230 [SV22600(ALL)05/95]
half page art:0032082-AWindshield washer fluid reservoir
*
[SV23000(ALL)05/95]
RWARNING
Do not put windshield washer fluid in the
container for the engine coolant.
%*
[SV23100(ALL)01/95]
Use specially formulated windshield washer
fluid rather than plain water, because specially
formulated washer fluids contain additives that
dissolve road grime. For safety reasons, washer
fluids containing an appropriate antifreeze such
as methanol should be used in freezing weather
(temperatures below32ÊF [0ÊC]).State or local
regulations on Volatile Organic Compounds
(VOC's) may restrict use of the most common
antifreeze, methanol. Washer fluids containing
non-methanol antifreeze agents should be used
only if they provide cold weather protection
without damaging the vehicle's paint finish,
wiper blades, and windshield washer system.
File:prsvp.ex
Update:Fri Jun 23 19:33:26 1995

247
*
[SV32800(ALL)03/95]
Power Steering Fluid
*
[SV32900(ALL)01/95]
Check the level of the power steering fluid at
least twice a year (i.e., every Spring and Fall).
*
[SV33000(ALL)03/95]
Checking and Adding Power Steering
Fluid
*
[SV33100(ALL)02/95]
1. Start the engine and let it run until the
power steering fluid reaches normal
operating temperature. The power steering
fluid will be at the right temperature when
the engine coolant temperature gauge in the
instrument cluster is near the center of the
NORMAL operating temperature range.
*
[SV33200(ALL)01/95]
2. While the engine idles, turn the steering
wheel back and forth several times. Make
sure that the cap assembly is installed at this
time.
*
[SV33300(ALL)01/95]
3. Turn the engine off and check the level on
the power steering reservoir.
[SV33550(ALL)08/91]
one third page art:0032043-A
Where to check for power steering fluid
File:prsvp.ex
Update:Fri Jun 23 19:33:26 1995

Index 291
Index
A
ABS warning light
(see Anti-lock brake system)....... 57
Additives, engine oil.......... 218
Air bag supplemental
restraint system........... 17,25
and child safety seats....... 17,24±25
description............... 18
disposal................ 22
driver air bag............. 18
indicator light............. 55
operation............... 18
passenger air bag............ 18
proper seating............. 16
tone generator............. 22
wearing safety belts........... 15
Air cleaner filter, specifications...... 268
Air conditioning, electronic automatic
temperature control system....... 65
Alcohol, in fuel............. 214
Aluminum wheels............ 238
Antenna, radio
(see Electronic sound system) . 75, 121, 143
Antifreeze (see Engine coolant)...... 221
Antifreeze (see Engine coolant)...... 221
Anti-lock brake system (ABS)
description.............. 157
see also Brake............ 157
warning light.............. 57
Appeals (see Dispute settlement board) . . 188
Assistance (see Customer assistance) . . . 185
Audio system
(see Electronic sound system)..... 121
File:prixp.ex
Update:Fri Jun 23 19:30:26 1995

294 Index
Cleaning your vehicle (continued)
wheels................ 239
windows................ 72
Clock................127, 143
Clutch
operation while driving........ 153
recommended shift speeds....... 156
shifting the gears........... 154
Cold engine starting............ 43
Combination lap and shoulder belts..... 9
Compact disc player
(see Electronic sound system) . . . 122, 128
Compact disc radio
(see Electronic sound system)..... 122
Console, description........... 114
Controls
instrument panel............ 63
mirrors................ 113
steering column............. 77
Coolant (see Engine coolant)
checking and adding......... 221
drain and flush............ 226
preparing for storage......... 272
specifications............. 226
temperature gauge........... 61
Cooling fan............... 204
Crankcase emission filter......... 268
Cruise control (see Speed control)...... 89
Customer Assistance Center,
Ford (U.S.).............. 187
Customer Assistance Centre,
Ford of Canada............ 192
D
Dashboard (see Instrument panel)...... 63
Daytime running light system....... 78
Defects, reporting............ 192
Dipstick
engine oil.............. 218
power steering fluid.......... 247
Disabled vehicle (see Towing)...... 181
File:prixp.ex
Update:Fri Jun 23 19:30:26 1995