Page 48 of 401
![FORD F150 1996 10.G Owners Manual 45 [SR16440(BEF )04/95]
Installing a Child Safety Seat at the Rear
Center Seating Position with Locking
Adjustable Lap Belt
[SR16450(BEF )04/95]
1. Lengthen the lap belt. To lengthen the belt,
hold th FORD F150 1996 10.G Owners Manual 45 [SR16440(BEF )04/95]
Installing a Child Safety Seat at the Rear
Center Seating Position with Locking
Adjustable Lap Belt
[SR16450(BEF )04/95]
1. Lengthen the lap belt. To lengthen the belt,
hold th](/manual-img/11/5014/w960_5014-47.png)
45 [SR16440(BEF )04/95]
Installing a Child Safety Seat at the Rear
Center Seating Position with Locking
Adjustable Lap Belt
[SR16450(BEF )04/95]
1. Lengthen the lap belt. To lengthen the belt,
hold the tongue so that its bottom is
perpendicular to the direction of webbing
while sliding the tongue up the webbing.
[SR16455(BEF )04/95]
2. Place the child safety seat in the center
seating position.
[SR16460(BEF )04/95]
3. Route the tongue and webbing through the
child seat according to the child seat
manufacturer's instructions.
[SR16465(BEF )04/95]
4. Insert the belt tongue into the proper buckle
for the center seating position until you hear
a snap and feel it latch. Make sure the
tongue is securely fastened to the buckle by
pulling on tongue.
[SR16470(BEF )04/95]
5. Push down on the child seat while pulling
on the loose end of the lap belt webbing to
tighten the belt.
[SR16475(BEF )04/95]
6. Before placing the child into child seat,
forcibly tilt the child seat from side-to-side
and in forward directions to ensure that the
seat is held securely in place. If the child
seat moves excessively, repeat steps 5
through 6, or properly install the child seat
in a different seating position.
File:ltsrf.ex
Update:Thu May 9 15:26:26 1996
Page 49 of 401
![FORD F150 1996 10.G Owners Manual 46
*
[SR18400(BEF )04/95]
Attaching Safety Seats With Tether Straps
*
[SR18410(BEF )03/01]
General Instructions
[SR18413(BEF )02/95]
Some manufacturers make safety seats that
include an upper tether s FORD F150 1996 10.G Owners Manual 46
*
[SR18400(BEF )04/95]
Attaching Safety Seats With Tether Straps
*
[SR18410(BEF )03/01]
General Instructions
[SR18413(BEF )02/95]
Some manufacturers make safety seats that
include an upper tether s](/manual-img/11/5014/w960_5014-48.png)
46
*
[SR18400(BEF )04/95]
Attaching Safety Seats With Tether Straps
*
[SR18410(BEF )03/01]
General Instructions
[SR18413(BEF )02/95]
Some manufacturers make safety seats that
include an upper tether strap that goes over the
seatback and attaches to an anchoring point.
Other manufacturers offer the tether strap as an
accessory. Contact the manufacturer of your
child safety seat for information about ordering
a tether strap.
[SR18415( F )02/95]
You can install a tether strap anchor bracket to
the cab inner back panel by using a tether
anchor bracket kit (613D74) available at no
charge from any Ford dealer.
*
[SR18420(BEF )03/91]
Read and follow the instructions provided with
the kit carefully for installation of the child
tether strap anchor.
*
[SR18501(BEF )03/91]
Follow the child seat manufacturer's instructions
to attach the tether strap to the tether bracket.
[SR18800( F )05/95]
Ford recommends placement of tethered safety
seats in a rear seating position (Crew Cab and
Super Cab with forward facing rear seat only)
with the tether strap installed to the tether
anchoring point as shown in the instructions
provided with the child tether strap anchor kit.
*
[SR18950(BEF )05/95]
RWARNING
Only use the tether attachment hole
locations shown in the illustrations. The
tether anchor may not perform properly if
the wrong mounting location is used.
File:ltsrf.ex
Update:Thu May 9 15:26:26 1996
Page 50 of 401
![FORD F150 1996 10.G Owners Manual 47
*
[SR19100( F )12/91]
If a tethered seat is installed in the front seat,
Ford recommends placement of the tethered
safety seat in the center front seating position,
with the tether strap secured to FORD F150 1996 10.G Owners Manual 47
*
[SR19100( F )12/91]
If a tethered seat is installed in the front seat,
Ford recommends placement of the tethered
safety seat in the center front seating position,
with the tether strap secured to](/manual-img/11/5014/w960_5014-49.png)
47
*
[SR19100( F )12/91]
If a tethered seat is installed in the front seat,
Ford recommends placement of the tethered
safety seat in the center front seating position,
with the tether strap secured to the center rear
lap belt tongue or to the webbing of the buckled
center rear lap belt behind the child safety seat.
*
[SR19400(B F )04/95]
The rear lap/shoulder safety belts should not be
used to secure the tether strap of a safety seat
located in the front seat.
*
[SR19500(BEF )05/95]
RWARNING
Failure to follow these precautions could
increase the chance of injury in an
accident.
[SR19575( F )05/95]
In SuperCabs equipped with center facing jump
seats, the tether strap anchor bracket should be
installed only at the center of the cab's back
panel with the child seat in the front center
seating position. Installing an anchor bracket at
the right rear of the cab may increase risk of
injury to an occupant of the right rear center
facing jump seat in the event of a collision or
sudden stop. If a tethered child seat is installed
in the right front seating position, secure the
tether strap to the webbing of the buckled right
rear lap belt.
*
[SR19600( F )05/95]
RWARNING
Do not install a child seat in a center
facing jump seat.
File:ltsrf.ex
Update:Thu May 9 15:26:26 1996
Page 121 of 401
119
*
[FV26001(BEF )05/95]
RWARNING
Never adjust the driver's seat or seatback
when the vehicle is moving.
*
[FV26100(BEF )05/95]
RWARNING
Do not pile cargo higher than the
seatbacks to avoid injuring people in a
collision or sudden stop.
*
[FV26200(BEF )05/95]
RWARNING
To reduce the risk of serious injury in a
collision, always drive and ride with your
seatback upright and the lap belt snug
and low across the hips.
*
[FV26300(BEF )05/95]
RWARNING
To reduce the risk of serious injury in a
collision, children should always ride with
the seatback upright.
File:ltfvf.ex
Update:Thu May 9 15:20:08 1996
Page 126 of 401
124
*
[FV39501( F )01/95]
Center Facing Jump Seat Ð SuperCab
Only
*
[FV39701( F )01/89]
The center facing jump seat should be kept in
the stored position for easy access to the rear
cab area. To open the seat:
*
[FV40001( F )01/89]
1. Unsnap the retaining strap holding the seat
in its stored position.
*
[FV40101( F )01/89]
2. Swing the seat support away from the seat
bottom while lowering the seat to a
horizontal position.
*
[FV40201( F )01/89]
3. Raise the seat back to the upright position.
*
[FV40301( F )05/95]
RWARNING
Do not install a child seat in a center
facing jump seat.
*
[FV40401( F )01/89]
one third page art:0020233-A
Opening the center facing jump seat
*
[FV40501( F )05/90]
To restore the seat to a stored position:
*
[FV40601( F )05/94]
1. Lift the cushion to upright position.
*
[FV40701( F )05/94]
2. Snap retaining strap.
*
[FV40801( F )05/94]
3. Clip support.
File:ltfvf.ex
Update:Thu May 9 15:20:08 1996
Page:
< prev 1-8 9-16 17-24