250
*
[DR10500(ALL)01/95]
P (Park)
*
[DR10600(ALL)03/94]
Always come to a complete stop before you shift into P (Park).
This position locks the transmission and prevents the rear
wheels from turning. To securely latch the gearshift in the P
(Park) position, pull it toward you, push it completely
counterclockwise against the stop, and then push it toward the
instrument panel.
*
[DR10650(ALL)03/94]
The gearshift is securely latched in P (Park) if you cannot rotate
it in a clockwise direction without lifting it toward you.
*
[DR10700(ALL)06/95]
RWARNING
Always set the parking brake fully and make sure the
gearshift is securely latched in P (Park).
*
[DR10800(ALL)06/95]
RWARNING
Never leave your vehicle unattended while it is running.
*
[DR11100(ALL)06/94]
Forced Downshifts
*
[DR11200(ALL)04/95]
To gain extra acceleration injOverdrive or Drive (O/D OFF),
push the accelerator to the floor. The transmission will
automatically downshift to the appropriate gear: third, second
or first.
*
[DR11235(ALL)03/94]
Power Braking
*
[DR11275(ALL)03/94]
Increasing the engine speed above idle without vehicle
movement (such as holding the brake) in a forward or reverse
gear causes transmission stall.
*
[DR11285(ALL)09/95]
NOTE: Continued operation in the stall condition can result
in transmission overheat, malfunction or fluid
expulsion.
File:10undrx.ex
Update:Thu Feb 29 09:12:36 1996
258
[DR18230( X)10/94]
Toshiftfrom4WDAUTOor2WDto4WDLOW:
[DR18290( X)01/95]
Stop the vehicle, depress the brake and place the automatic
transmission in N (Neutral) or depress the clutch on vehicles
with a manual transmission. Rotate the 4WD switch on the
instrument panel to 4WD LOW. Both the 4WD and 4WD LOW
lights are now lit.
[DR18293( X)06/95]
For Explorers equipped with Automatic Ride Control:
[DR18294( X)06/95]
After shifting to 4WD LOW, wait about 90 seconds. This will
improve ground clearance and off-road handling. Refer to
Automatic Ride Controlin the Features chapter.
[DR18320( X)08/94]
To shift from 4WD LOW to 4WD AUTO or 2WD:
[DR18400( X)01/95]
Stop the vehicle, depress the brake and place the automatic
transmission into N (Neutral) or depress the clutch on vehicles
with a manual transmission. Rotate the 4WD switch on the
instrument panel to 4WD AUTO or 2WD.
[DR18500(ALL)03/95]
It is not recommended to operate the vehicle in the 4WD modes
with a temporary spare. If 4WD operation is necessary, do not
operate at speeds above 10 mph or for distances above 50 miles.
Extended operation in 4WD with a temporary spare may result
in damage to drivetrain components.
[DR18600( X)12/95]
All-Wheel Drive System (If equipped)
[DR18620( X)12/95]
If your vehicle is equipped with All-Wheel Drive (AWD), power
is constantly supplied to all four wheels through a transfer case.
The AWD system is full-time and has no external controls.
[DR18630( X)12/95]
The AWD transfer case utilizes a viscous clutch that distributes
torque to the front and rear differentials (approximately 35%
front and 65% rear). The viscous clutch is filled with a
high-viscosity fluid, see
Lubricant Specifications
in the
Servicing
Your Explorer
chapter for more information.
File:10undrx.ex
Update:Thu Feb 29 09:12:36 1996
Servicing Your Explorer
373
*
[SV33200(ALL)01/95]
RWARNING
Batteries normally produce explosive gases which can
cause personal injury. Therefore, do not allow flames,
sparks or lit tobacco to come near the battery. When
charging or working near a battery, always cover your
face and protect your eyes, and also provide ventilation.
%*
[SV33300(ALL)07/95]
RWARNING
Batteries contain sulfuric acid which burns skin, eyes,
and clothing.
*
[SV33310(ALL)07/95]
If the acid touches someone's skin, eyes, or clothing,
immediately flush the area with water for at least 15 minutes. If
someone swallows the acid, have him or her drink lots of milk
or water first, then Milk of Magnesia, a beaten egg, or vegetable
oil. Call a doctor immediately.
%*
[SV33400(ALL)06/95]
RWARNING
Applying too much pressure on the ends when lifting a
battery could cause acid to spill. Lift the battery with a
carrier or with your hands on the opposite corners.
%*
[SV33500(ALL)01/95]
Automatic Transmission Fluid
*
[SV33601(ALL)06/95]
Under normal driving conditions automatic transmission fluid
should be changed every 30,000 miles (48,000 km) or 21,000
miles (34,000 km) if under severe duty conditions. However, if
the transmission is not working properly, for instance, the
transmission may slip or shift slowly, or you may notice some
sign of fluid leakage, the fluid level should be checked.
*
[SV33701(ALL)05/95]
It is preferable to check the transmission fluid level at normal
operating temperature, after approximately 20 miles (30 km) of
driving. However, if necessary, you can check the fluid level
File:15unsvx.ex
Update:Thu Feb 29 09:20:34 1996
374without having to drive 20 miles to obtain a normal operating
temperature if outside temperatures are above50ÊF (10ÊC).
*
[SV33801(ALL)01/95]
NOTE: If the vehicle has been operated for an extended
period at high speeds or in city traffic during hot
weather, or pulling a trailer, the vehicle should be
turned off for about 30 minutes to allow the fluid to
cool before checking.
%*
[SV33901(ALL)02/95]
Checking the Automatic Transmission Fluid
*
[SV33910(ALL)06/95]
With the vehicle on a level surface, start the engine and move
the transmission shift selector through all of the gear ranges
allowing sufficient time for each position to engage. Securely
latch the transmission shift selector in the P (Park) position,
fully set the parking brake and leave the engine running.
*
[SV33930(ALL)10/89]
RWARNING
Your vehicle should not be driven if the fluid level is
below the bottom hole on the dipstick and outside
temperatures are above50ÊF (10ÊC).
*
[SV33940(ALL)08/95]
Wipe off the dipstick cap (located on the passenger's side of the
engine), pull the dipstick out and wipe the indicator end clean.
Put the dipstick back into the filler tube and make sure it is
fully seated. Pull the dipstick out and read the fluid level.
*
[SV33950(ALL)03/90]
When checking fluid at normal operating temperature, the fluid
level should be within the crosshatched area on the dipstick.
When the vehicle has not been driven, and outside temperature
is above50ÊF (10ÊC), thefluid level should be between the holes
on the dipstick.
File:15unsvx.ex
Update:Thu Feb 29 09:20:34 1996
Servicing Your Explorer
375
%*
[SV33960(ALL)08/95]
Adding Automatic Transmission Fluid
*
[SV33970(ALL)03/94]
The fluid type is stamped on the dipstick.Before adding any
fluid, be sure that the correct type will be used.
*
[SV33980(ALL)10/89]
Add fluid in 1/2 pint (.25L) increments through the filler tube
to bring the level to the correct area on the dipstick. If an
overfill occurs, excess fluid should be removed by a qualified
technician.
%*
[SV33990(ALL)09/95]
NOTE: Always dispose of used automotive fluids in a
responsible manner. Follow your community's
standards for disposing of these types of fluids. Call
your local recycling center to find out about recycling
automotive fluids.
[SV34000(ALL)04/94]
7-1/2 pica art:0021193-A
Automatic transmission dipstick
File:15unsvx.ex
Update:Thu Feb 29 09:20:34 1996
376
%*
[SV34400(ALL)06/95]
Manual Transmission and Transfer Case
Fluid
*
[SV34600(ALL)01/95]
Checking the Manual Transmission Fluid
*
[SV34700(ALL)12/91]
Clean the filler plug on the side of the case. Remove the filler
plug. The fluid level should be up to the bottom of the filler
plug hole.
*
[SV34800(ALL)03/91]
If additional fluid is required:
*
[SV34900(ALL)01/95]1.
Add enough fluid through the filler plug hole to bring the
level up to the bottom of the hole. Use only fluid certified to
meet Ford Motor Company lubricant specification as listed
underRefill Capacities, Motorcraft Parts, and Lubricant
Specifications, later in this chapter.
*
[SV35000(ALL)03/91]2.
Replace the filler plug in its original position, making sure it
is fully seated.
%*
[SV35100(ALL)02/95]
The Clutch
*
[SV35200(ALL)03/91]
The clutch on your vehicle is automatically self-adjusting and
should not require any routine service.
*
[SV35301(ALL)03/91]
During normal operation the fluid level in the clutch reservoir
will slowly rise. If for any reason the fluid level drops, maintain
the fluid level at the step in the reservoir body.
%*
[SV35400(ALL)03/94]
If it becomes necessary to remove the reservoir cap, thoroughly
clean the reservoir cap before removing it to prevent dirt or
water from entering the reservoir. Remove the internal
diaphragm and then add only a DOT 3 brake fluid such as Ford
High Performance DOT 3 Brake Fluid, meeting Ford
specification ESA-M6C25-A.
File:15unsvx.ex
Update:Thu Feb 29 09:20:34 1996
380
[SV38250(ALL)04/94]
10-1/2 pica
art:0021195-A
Power steering dipstick
[SV38550(ALL)07/95]
10-1/2 pica
art:0090155-A
Power steering dipstick location
*
[SV38800(ALL)07/94]5.
If the power steering fluid is low, add fluid in small
amounts, continuously checking the level, until you reach the
FULL HOT range. Do not overfill.
*
[SV38850(ALL)03/95]6.
When you are finished, put the dipstick back in and make
sure that it fits snugly.
[SV38900(ALL)05/95]
Use only power steering fluid that meets Ford specification such
as MERCONHAutomatic Transmission Fluid (or equivalent).
File:15unsvx.ex
Update:Thu Feb 29 09:20:34 1996
422
Anti-theft system (continued)
triggering..................... 167
warning light..................... 88
Appeals (see Dispute settlement board)......... 319
Assistance (see Customer assistance).......... 317
Audio system (see Electronic sound system)....... 207
Autolamp system (see Headlamps).........128, 132
Autolock (see Keyless entry).............. 159
Automatic transaxle, fluid, specification......... 406
Automatic transmission
driving an automatic overdrive............ 248
fluid, adding.................... 375
fluid, checking................... 374
fluid, specification.................. 406
Axle
lubricant specifications................ 406
traction lok...................269, 363
B
Backing up...................... 248
Basic vehicle warranty.................. 3
Battery
acid, treating emergencies..........295, 372±373
battery saver.................... 166
charging system warning light............. 87
disconnecting.................... 298
how to service................... 371
jumping a disabled battery.............. 295
maintenance-free.................. 371
proper disposal, recycling.............. 372
replacement, specifications.............. 405
servicing...................... 371
voltage gauge.................. 87,89
when storing your vehicle.............. 410
File:unixx.ex
Update:Thu Feb 29 09:21:09 1996