1996 FORD EXPLORER window

Instrument Panel Controls
121
[IP06900( X)03/95]
10-1/2 pica
art:0090127-A*
[IP07000( X)01/95]
Manual override buttons
[IP07100( X)03/95]
Your EATC has six buttons which allow you to make special
selections. The buttons are located along the bottom edge of the
EATC Control and allow you to determine where the air will be
discharged. Pressing any override button changes the air
discharge location only. It does not affect the ability of the
system to control temperature or the fan speed. Return to fully
automatic operation by pushing the AUTOMATIC button.
[IP07200( X)07/94]
MAX A/C Button
[IP07300( X)03/95]
MAX A/C allows for faster cooling because air is drawn from
inside the vehicle. Using inside air causes the fan to sound
louder which is normal for this selection. The display window
will change to indicate60ÊF (16ÊC) and MAXA/C. The fan will
run at high speed and the air flow will be from the instrument
panel registers. To exit and return to the previous temperature,
push AUTOMATIC or any of the other 5 override buttons.
File:06unipx.ex
Update:Thu Feb 29 09:05:45 1996

122
[IP07400( X)07/94]
VENT Button
[IP07500( X)03/95]
Push this button to select outside air through the instrument
panel registers. The display window will show the set
temperature and VENT to the lower right of the temperature.
Your EATC will heat the air if the temperature you have
selected is warmer than the outside air coming into the vehicle.
However, the air willNOTbe cooled regardless of the
temperature setting. Airflow will be from the instrument panel
registers.
[IP07600( X)03/95]
PNL & FLR Button
*
[IP07700( X)03/95]
Push this button to get air from the floor and instrument panel
registers at the same time. The display will show the set
temperature and the words PNL and FLR. Depending on the
selected temperature, the air will be automatically heated or
cooled.
[IP07800( X)07/94]
FLOOR Button
[IP07900( X)03/95]
Airflow will be to the floor when the FLOOR button is pressed.
The display window will show the set temperature and FLR to
the left of the temperature. The air cannot be cooled in the
FLOOR position, only heated. Fan speed will be automatic
unless manually controlled. If you override the fan speed and
wish to return to automatic fan control, push AUTOMATIC.
Then, again select FLOOR for airflow to the floor.
[IP08000( X)07/94]
FLR & DEF Button
[IP08100( X)03/95]
Push this button to get air to the floor and windshield
defrosters at the same time. The display will show the set
temperature, FLR andVsymbol to indicate FLR & DEF has
been selected. If the outside temperature is about50ÊF (10ÊC) or
warmer, the air will be dehumidified to remove moisture. This
will help to prevent fogging in humid weather.
File:06unipx.ex
Update:Thu Feb 29 09:05:45 1996

Instrument Panel Controls
123
[IP08200( X)04/95]
DEFVButton
[IP08300( X)03/95]
Press the defrost button to obtain maximum airflow to the
windshield. Adjust the temperature setting as required for
defrosting. The display window will show the temperature
setting andVsymbol to the left of the temperature. When the
outside temperature is about50ÊF (10ÊC) orwarmer, the air will
be dehumidified to remove moisture.
[IP08400( X)07/94]
REAR FAN OFF Button
[IP08500( X)03/95]
Press this button once to turn on the rear fan circuit. Press the
button again to turn the rear fan off. REAR FAN OFF will be
shown in the display window above the set temperature.
[IP08600( X)03/95]
10-1/2 pica
art:0090128-A*
[IP08700( X)04/95]
Operating tips
*
[IP08800( X)04/95]
The following tips will help you to get the most satisfaction
from your Electronic Automatic Temperature Control system.
*
[IP08900( X)07/95]
n
In humid weather, select DEFVbefore starting your
engine. This will help to prevent windshield fogging. After a
few minutes of operation, switch to AUTOMATIC or an
override selection of your choice.
File:06unipx.ex
Update:Thu Feb 29 09:05:45 1996

126
%*
[IP12300( X)06/95]
Rear Window Defroster (If equipped)
*
[IP12400( X)12/91]
The defroster for the rear window clears frost, fog, or thin ice
from both the inside and outside of the rear window.
[IP12500( X)10/94]
The control switch is located on the instrument panel to the
right of the radio.
[IP12700( X)08/94]
7-1/2 pica art:0020110-H
Rear window defroster switch
*
[IP12800( X)02/95]
To defrost the rear window:
*
[IP12900( X)02/95]1.
Clear any snow from the rear window.
*
[IP13000( X)09/93]2.
Get in your vehicle and start the engine.
[IP13200( X)06/94]3.
Push the switch and release. The indicator light turns on.
Push switch again to turn off.
*
[IP13300( X)02/05]
The defroster turns off automatically after approximately 10
minutes. If the window is not clear, turn on the defroster again.
It will also automatically shut off any time the engine is shut
off.
%*
[IP13400( X)09/95]
NOTE: Never use sharp instruments or window cleaners with
abrasives to clean the inside of your rear window. If
you do, you may damage the heating elements that
are bonded to the inside of the rear window and
cause damage to the rear window defroster.
File:06unipx.ex
Update:Thu Feb 29 09:05:45 1996

134
[IP19875( X)09/95]
10-1/2 pica
art:0020975-B
Map lamps (if equipped)
%*
[IP19900( X)10/94]
High-mount Brakelamp
[IP19910( X)10/94]
The high-mount brakelamp is located outside the vehicle,
directly over the rear window.
[IP19920( X)10/94]
10-1/2 pica art:0021015-E
High-mount brakelamp
*
[IP20300(ALL)04/95]
Clock Controls on Electronic Radios
[IP20400(ALL)10/94]
The electronic radios have a built-in clock. For complete
operating instructions, refer toElectronic Sound Systemsin this
Owner Guide.
File:06unipx.ex
Update:Thu Feb 29 09:05:45 1996

150
[FV04900( X)08/94]
Liftgate Handle and Locks
[FV05000( X)10/94]
10-1/2 pica art:0020550-F
Liftgate handle and locks
[FV05100( X)11/89]
You can unlock the liftgate by using the key. To open the
liftgate, rotate the handle clockwise and to open the liftgate
window, rotate the handle counterclockwise.
[FV05200( X)05/95]
You can lock the liftgate by using the key, pushing the lock
button down, or using the power door lock switch on the left
side of the cargo area.
*
[FV05300( X)10/89]
Make certain that you close the liftgate door and window before
driving your vehicle. If you do not, possible damage may occur
to the liftgate door lift cylinders and attaching hardware.
*
[FV05400( X)08/95]
RWARNING
When driving your vehicle make sure that the liftgate
door and window are closed to prevent exhaust fumes
from being drawn into the vehicle. This will also prevent
cargo from falling out.
*
[FV05900( X)12/93]
The liftgate area is only intended for cargo, not passengers. You
can open and close the liftgate from outside the vehicle. It
cannot be opened from inside the cargo area.
File:08unfvx.ex
Update:Thu Feb 29 13:56:40 1996

152
[FV12400( X)10/94]
17-1/2 pica art:0020547-F
The cargo shade
*
[FV12600( X)05/91]
The shade is a wind-up type, just like a window shade. Over
time the shade may lose its spring tension. If this happens, you
can easily rewind the shade with the help of another person.
*
[FV12700( X)05/91]
To rewind the shade:
[FV12800( X)06/94]1.
Remove the shade from its side anchor slots by compressing
telescoping tube.
*
[FV12900( X)05/91]2.
Extend the shade fully. Make sure the smooth grain side is
facing you (see Figure 1).
*
[FV13000( X)05/91]3.
Wrap the vinyl around the roller tube two times in the
direction shown in Figure 1.
*
[FV13100( X)05/91]4.
Tuck the edges of the vinyl inside the end cap with each
wrap.
File:08unfvx.ex
Update:Thu Feb 29 13:56:40 1996

Features
159
% [FV15350( X)02/95]
Autolock (With automatic transmission vehicles only)
*
[FV15351( X)02/95]
The Autolock feature is part of your remote keyless entry
system and is enabled at the factory. With the Autolock feature
enabled, all of the doors will automatically lock when:
[FV15353( X)02/95]
n
the vehicle doors, liftgate and liftgate window are fully
closed
*
[FV15355( X)09/95]
n
the ignition key is turned to the ON position
*
[FV15356( X)02/95]
n
the brake pedal is pressed
*
[FV15358( X)02/95]
n
you shift through (Reverse)
*
[FV15359( X)02/95]
n
the brake pedal is released
*
[FV15360( X)09/95]
The Autolock feature will repeat when:
[FV15361( X)02/95]
n
a door is opened and then all doors, liftgate and liftgate
window are closed
*
[FV15362( X)02/95]
n
the brake pedal is released
*
[FV15363( X)04/95]
You can deactivate the system by using the buttons for the
keyless entry system if you don't want to use the Autolock
feature.
*
[FV15364( X)02/95]
The doors may not lock automatically at the correct time if the
driver:
*
[FV15365( X)02/95]
n
shifts through gears without pressing the brake
*
[FV15366( X)02/95]
n
shifts through gears quickly after starting the vehicle
*
[FV15367( X)02/95]
n
releases their foot from the brake while someone has stepped
out of the vehicle for a moment
*
[FV15368( X)05/95]
To deactivate the Autolock system:
*
[FV15369( X)06/95]1.
Enter your permanent five-digit entry code (not the personal
code you may have set).
*
[FV15370( X)09/95]2.
Within 5 seconds, press and hold 7/8.
File:08unfvx.ex
Update:Thu Feb 29 13:56:40 1996