1996 FORD ESCORT brake

111
*
[ST09800(ALL)05/95]
NOTE: If your vehicle is equipped with an
automatic transaxle, your vehicle has
an interlock that prevents you from
shifting out of P (Park) unless your
foot is on the brake pedal.
%*
[ST09860(ALL)04/95]
If the engine does not start after two attempts:
*
[ST09880(ALL)03/95]
1. Turn the key to the OFF position and wait
about two minutes.
*
[ST09890(ALL)04/95]
2. Press the accelerator all the way to the floor
and hold it.
*
[ST09900(ALL)04/95]
3. Turn the ignition key to the START position.
*
[ST09910(ALL)04/95]
4. Release the ignition key when the engine
starts.
*
[ST09920(ALL)04/95]
5. Release the accelerator gradually as the
engine speeds up. Then drive away in the
normal manner.
*
[ST09930(ALL)04/95]
If the engine still does not start, the fuel pump
shut-off switch may have been triggered. For
directions on how to reset the switch seeFuel
Pump Shut-Off Switchlater in this chapter.
[ST10200(ALL)06/93]
A computer system controls the engine's idle
RPM. When you start your vehicle, the engine's
idling RPM normally runs higher than when
warm. The engine idle control system should
only be serviced by a qualified technician.
*
[ST10290(ALL)07/95]
If the engine idle speed does not slow down
automatically, do not allow your vehicle to idle
for more than 10 minutes. Have the vehicle
checked.
File:04ctste.ex
Update:Tue Sep 19 14:42:54 1995

120 [LG02549(E )06/94]Safety Belt Warning Light/Chime
(Canadian vehicles equipped with
combination lap and shoulder belts)
[LG02550(E )09/95]
This warning light and chime remind you in two
ways to fasten your safety belt. If you do not
fasten the safety belt before you turn the ignition
key to ON, the chime sounds for four (4) to
eight (8) seconds. Also, each time you turn the
ignition key to ON, the warning light comes on
for one to two minutes to remind you to fasten
your combination lap and shoulder belt.
[LG02700(ALL)03/91]
one inch art:0070005-A
The safety belt light
[LG02750(ALL)08/95]
Brake Warning Light
*
[LG02900(ALL)03/95]
The warning light for the brakes can show two
things Ð that the parking brake is not fully
released, or that the brake fluid level is low in
the master cylinder reservoir. If the fluid level is
low, the brake system should be checked by
your dealer or a qualified service technician.
[LG03500(ALL)12/89]
This light comes on when you turn the ignition
key to START, but it normally goes off shortly
after the engine starts and you release the
parking brake. If the light stays on or comes on
after you have released the parking brake fully,
have the hydraulic brake system serviced.
File:05ctlge.ex
Update:Tue Sep 19 14:44:43 1995

121 [LG03550(ALL)08/95]
one inch art:0000837-A
The brake system and parking brake light
*
[LG03600(ALL)05/95]
RWARNING
The BRAKE light indicates that the brakes
may not be working properly. Have the
brakes checked immediately.
%*
[LG03800(ALL)01/95]
Charging System Light
*
[LG03900(ALL)03/95]
This light indicates that your battery is not being
charged and that you need to have the electrical
system checked.
*
[LG04300(ALL)07/95]
This light comes on every time you turn the
ignition to the ON or START position (engine
off). The light should go off when the engine
starts and the alternator begins to charge.
*
[LG04400(ALL)01/95]
If the light stays on or comes on when the
engine is running, have the electrical system
checked as soon as possible.
[LG04500(ALL)12/89]
one inch art:0000838-A
The charging system light
File:05ctlge.ex
Update:Tue Sep 19 14:44:43 1995

127 %
*
[LG10355(ALL)05/95]
Turn Signal Indicator Lights
*
[LG10360(ALL)05/95]
When you push the turn signal lever up before
making a right turn, the right side arrow on the
instrument panel flashes.
*
[LG10365(ALL)05/95]
When you push the turn signal lever down
before making a left turn, the left side arrow on
the instrument panel flashes.
[LG10370(ALL)08/93]
Usually, the turn signals turn off automatically
after you turn your vehicle. If the turn signal
continues to flash after you have made the turn,
pull the lever back to OFF.
%*
[LG10390(ALL)02/95]
Anti-lock Brake System Warning Light
(If equipped)
[LG10400(ALL)03/95]
Your vehicle may have an Anti-lock Brake
System (ABS) feature. If it does, check the
Anti-lock Brake System (ABS) light each time
you start the engine. If it stays on longer than
six seconds, shut off the engine and restart. If it
stays on, that means the Anti-lock Brake feature
isn't working and should be serviced
immediately to restore the benefits of the
anti-lock brake feature. Normal braking is not
affected unless the brake warning light is also lit.
[LG10410(ALL)07/93]
The Anti-lock Brake System has self-check
capabilities. As described above, the system
turns on the anti-lock light each time you start
your engine. After the engine is started and the
anti-lock light turns off, the system performs
another test the first time the vehicle reaches
7 mph (11 km/h). The system turns on the ABS
pump motor for approximately 1/2 second. At
this time, a mechanical noise may be heard. This
is a normal part of the self-check feature. If a
malfunction is found during this check the
anti-lock light will come on.
File:05ctlge.ex
Update:Tue Sep 19 14:44:43 1995

128 [LG10450(ALL)02/94]
one inch art:0070205-AThe anti-lock brake system light
%*
[LG20000(ALL)02/95]
Engine Oil Pressure Warning Light
[LG20025(ALL)06/95]
This light indicates low oil pressure,not low oil
level. However, if your engine's oil level is low,
it could affect the oil pressure. This light comes
on every time your ignition key is turned to ON
or START. The light should turn off after a few
seconds. If the light stays on when the engine is
running, you have lost oil pressure and
continued operation will cause severe engine
damage.
[LG20050(ALL)03/93]
one inch art:0000839-A
The engine oil pressure light
*
[LG20100(ALL)03/95]
1. Pull off the road as soon as safely possible.
*
[LG20125(ALL)11/94]
2. Shut off the engine immediately. If you do
not stop the engine as soon as safely
possible, severe engine damage could result.
*
[LG20150(ALL)11/94]
3. Check the engine's oil level, following the
instructions on checking and adding engine
oil in this Owner Guide. (SeeEngine oilin
the Index.) If you do not follow these
instructions, you or others could be injured.
To ensure an accurate reading, your vehicle
should be on level ground.
File:05ctlge.ex
Update:Tue Sep 19 14:44:43 1995

152 %
*
[IP25605(ALL)01/95]
Daytime Running Light System
*
[IP25610(ALL)03/95]
(Canadian vehicles only)
*
[IP25615(ALL)03/95]
The Daytime Running Light (DRL) system turns
the high beam headlamps on, with a reduced
light output, when:
*
[IP25619(ALL)03/95]
q
The headlamp system is in the OFF position,
and
*
[IP25620(ALL)03/95]
q
The vehicle is running, and
*
[IP25625(ALL)01/95]
q
The vehicle has a fully released parking
brake.
*
[IP25630(ALL)05/95]
The high beam indicator light on the instrument
cluster will not be on.
*
[IP25640(ALL)05/95]
RWARNING
The Daytime Running Light (DRL) system
will not illuminate the tail lamps and
parking lamps. Turn on your headlamps
at dusk. Failure to do so may result in a
collision.
File:06ctipe.ex
Update:Tue Sep 19 14:46:28 1995

155 %
*
[IP31550(ALL)04/95]
Cleaning the Interior Lamps
*
[IP31560(ALL)04/95]
Your interior dome lamps and map lamps are
plastic and should be cleaned with a mild
detergent diluted in water. Rinse them with clear
water.
[IP31750(ALL)02/95]
High-Mount Brakelamp
[IP32000(ALL)06/93]
Your vehicle is equipped with a high-mount
brakelamp. The high-mount brakelamp
illuminates whenever you apply the brakes.
[IP32410(E )12/89]
On 4-door hatchback, 2-door hatchback and
wagon models, the high-mount brakelamp is
mounted on the liftgate at the base of the rear
window.
[IP32450(E )12/91]
On the 4-door LX model, the high-mount
brakelamp is mounted on the base of the rear
window.
[IP32500(E )04/94]
On the Sport and GT, the high-mount brakelamp
is located between the spoiler and the trunk lid.
File:06ctipe.ex
Update:Tue Sep 19 14:46:28 1995

224 %
*
[DR03800(ALL)01/95]
Putting Your Vehicle in Gear
*
[DR04001(ALL)05/95]
RWARNING
Hold the brake pedal down while you
move the gearshift lever from position to
position. If you do not hold the brake
pedal down, your vehicle may move
unexpectedly and injure someone.
*
[DR04025(ALL)07/93]
Using a Console-Mounted Gearshift
[DR04050(ALL)08/95]
Since your vehicle has a console-mounted
gearshift, you must depress the brake pedal,
then push in the thumb button to move the
gearshift to the position you choose.
*
[DR04900(ALL)11/94]
Once the gearshift is secure in the desired
position, release the brake pedal and use the
accelerator as necessary.
[DR04950(ALL)06/94]
one third page art:0070193-C
The automatic console-mounted gearshift lever
[DR05010(ALL)08/95]
To move the gearshift out of P (Park), the
ignition must be turned to the ON position and
the brake pedal must be depressed. When the
gearshift is in any other position except P (Park),
the ignition key cannot be turned to LOCK or be
removed from the steering column. To remove
the key, the gearshiftmustbe in P (Park).
File:10ctdre.ex
Update:Tue Sep 19 14:53:34 1995