1996 FORD E SERIES lock

122
*
[FV19139( E )06/95]
NOTE: Be sure to close all doors completely. If
not, the alarm indicator light will
remain on. Remember, your anti-theft
system is armed only after the alarm
indicator light remains on steadily for
approximately 30 seconds after the last
door is closed, and then goes out.
*
[FV19154( E )04/95]
The anti-theft system is designed to work with
the factory installed remote entry system. It may
not work with other remote entry systems.
%*
[FV19157( E )05/95]
Disarming an untriggered anti-theft system
[FV19160( E )03/93]
You can disarm the system by unlocking either
front door or the rear door with your door key.
Turn the key all the way to the end of travel or
the system will not disarm.
*
[FV19163( E )04/95]
You can also disarm the system by unlocking
the driver's door by using the UNLOCK button
of the remote entry transmitter.
*
[FV19166( E )04/95]
If the system is armed and you remain in your
vehicle, simply insert the key into the ignition
and turn it to ON. This disarms the system and
allows you to open the door and exit without
triggering the system.
%*
[FV19187( E )05/95]
Disarming a triggered system
*
[FV19190( E )05/95]
The alarm can be disarmed by:
*
[FV19196( E )04/95]
q
unlocking any door with the key, or
*
[FV19199( E )05/95]
q
using the UNLOCK button of the remote
entry transmitter
*
[FV19202( E )05/95]
NOTE: The flashing lights and honking horn
will shut off automatically within 2
minutes 45 seconds after the system is
triggered. It will trigger again if
another intrusion occurs. However, the
starter circuit remains disabled until
the system is disarmed.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

123
*
[FV19250(BEF )02/95]
Windows
[FV19800( E )02/91]
Side, cargo door and rear door window
controls (If equipped)
[FV19900( E )04/89]
To open, press down on the window latches.
Then depress the levers on each side of the latch
and pull the latch upward. Move the latch out
and depress into the open position. To close,
depress the levers on each side of the latch. Lift
the latch and pull inward, then press down on
the latch to lock the levers.
[FV20000( E )04/89]
quarter page art:0020216-A
Window latch
[FV20100( E )05/95]
RWARNING
Rear doors, rear door flipper windows,
and van conversion windows, should be
closed while driving. This will prevent
exhaust fumes from being drawn into
your vehicle.
[FV20200( E )03/95]
If you can't avoid leaving one or all of the
above windows open, you should pay careful
attention to the following precautions:
[FV20300( E )03/95]
q
Adjust your climate control system to force
outside air into your vehicle.
[FV20400( E )03/95]
q
Completely open the outside air vents, if your
vehicle is so equipped.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

124
*
[FV22901(BEF )03/91]
Using the Power Windows (If equipped)
*
[FV23001(BEF )06/95]
Each door has a power control that opens and
closes the window on that door. The driver's
door has a master control switch that operates
both front door windows. You must place the
ignition switch in the ON or ACC position to
use your power window controls.
*
[FV23501(BEF )05/95]
RWARNING
Do not let children play with the power
windows. They may seriously hurt
themselves. Make sure occupants are clear
of the window(s) before closing.
*
[FV23800(BEF )05/95]
quarter page art:0020203-C
Master control switch
*
[FV24101(BEF )01/95]
Seats
%*
[FV24801(BEF )05/90]
Adjusting the Front Seat Manually
*
[FV24901(BEF )06/95]
To move the front seat forward or rearward:
*
[FV25001(BEF )06/95]
1. Find the adjustment lever at the lower left
corner of the front seat.
*
[FV25101(BEF )06/95]
2. Push the lever to the left to unlatch the seat.
*
[FV25201(BEF )06/95]
3. Move the seat to the desired position.
*
[FV25301(BEF )06/95]
4. Release the lever to latch the seat in its new
position. Make sure the seat locks securely in
place.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

125
*
[FV26001(BEF )05/95]
RWARNING
Never adjust the driver's seat or seatback
when the vehicle is moving.
*
[FV26100(BEF )05/95]
RWARNING
Do not pile cargo higher than the
seatbacks to avoid injuring people in a
collision or sudden stop.
*
[FV26200(BEF )06/95]
RWARNING
To reduce the risk of serious injury in a
collision, always drive and ride with your
seatback upright and the lap belt snug
and low across the hips.
*
[FV26300(BEF )05/95]
RWARNING
To reduce the risk of serious injury in a
collision, children should always ride with
the seatback upright.
%*
[FV26400(BEF )06/95]
Reclining Bucket Seats
*
[FV27301(BEF )02/92]
You can tilt the seat back of your bucket seats
backward.
[FV27450( E )03/93]
1. On the right hand side of the seat, lift the
recliner handle up and hold it in place.
*
[FV27501(BEF )10/89]
2. Lean against the back of the seat and adjust
it to the position you want.
*
[FV27601(BEF )10/89]
3. Release the handle to lock the seat back in
place.
*
[FV27701(BEF )10/89]
4. To return the seat back upright, lift the
handle and lean forward.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

127 [FV32101( E )12/91]
3. Remove the seat from the vehicle.
*
[FV32200( E )12/91]
To install the rear bucket seat:
[FV32400( E )12/91]
1. Lift the seat assembly into the vehicle and
position the seat to the floor mount.
[FV32600( E )02/92]
2. Engage the four seat pins into their
respective floor mount holes and push the
seat toward the left hand side of the vehicle
to fully engage.
[FV32700( E )02/92]
one third page art:0020916-B
Installing the quick release rear captains chair
[FV33001( E )12/91]
3. Push the seat latch handle downward to a
full stop. This locks the seat in position.
[FV33101( E )12/91]
4. Before you engage the safety belt, be sure it
is not twisted. Remove any twist, then insert
the tongue end of the detachable anchor into
the detachable anchor until you hear a
ªsnapº and feel the latch engage.
*
[FV33201( E )05/95]
RWARNING
Check to see that the seat is latched
securely in position. Keep floor area free
of objects that would prevent proper seat
engagement. Never attempt to adjust the
seat latch while the vehicle is in motion.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

133 [FV36801( E )05/95]
two third page art:0020857-B
Rear seat shoulder safety belt Ð stowage (with seat
removed)
[FV36900( E )03/91]
2. Lift and rotate the LH/RH seat latch handles
rearward.
[FV37000( E )06/92]
3. Lift the LH/RH latch rod hook ends out of
the locking holes in the front strikers.
[FV37101( E )06/92]
4. Move (slide) the seat rearward and lift the
seat's rear stanchion hooks away from the
rear latch strikers in the floor prior to lifting
the front stanchion hooks out from the front
latch strikers in the floor. Refer to the
illustration.
[FV37201( E )03/91]
5. Remove the seat assembly from vehicle.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

134
*
[FV37301( E )05/89]
To install the seat assembly:
[FV37401( E )06/92]
1. Place the seat assembly in the vehicle.
[FV37501( E )06/92]
2. Align the front stanchion hooks to the front
latch strikers in the floor prior to lowering
the seat's rear stanchion hooks and aligning
them with the rear latch strikers in the floor.
[FV37601( E )06/92]
3. Engage the LH/RH latch rod hook ends in
the front striker locking holes.
[FV37701( E )06/92]
4. Rotate the LH/RH latch handles forward,
and at the same time, slide the seat assembly
forward to engage the floor strikers.
Continue forward movement until it reaches
the end of its travel.
[FV37801( E )06/92]
5. Before you engage the lap/shoulder safety
belt to the seat, make sure the belt is not
twisted. A twisted belt may cause the
retractor to not work properly. Remove any
twist, then insert the tongue end of the
detachable anchor into the detachable anchor
until you hear a ªsnapº and feel the latch
engage. Refer to the previous illustration.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

136 [FV38001( E )02/92]
two third page art:0020917-BQuick seat release Ð bed seat
[FV38101( E )01/89]
RWARNING
Keep striker area free of foreign objects
that would prevent front and rear
retainers from engaging the strikers
properly.
*
[FV38201( E )05/93]
RWARNING
Before using the seat, make sure that the
latch hooks are securely locked around the
floor pins.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996