1996 FORD E SERIES ignition

101
*
[SC03800( ALL)05/95]
one third page art:0020074-B
Headlamp high beam switch and turn signal lever
*
[SC04200( ALL)05/95]
Flashing the Lights
*
[SC04300( ALL)06/95]
To flash the headlamps, pull the lever toward
you for a moment and then release it. The
headlamps will flash whether the headlamp
knob is in the on or off position.
*
[SC04400( ALL)03/95]
Windshield Wipers and Washer
*
[SC04500( ALL)03/95]
To turn on the windshield wipers, the ignition
key must be turned to the ON or ACC position.
*
[SC04600( ALL)05/95]
Turn the knob on the end of the turn signal
lever toward the front of the vehicle. You can
turn it to either the LO or HI speed position.
File:07ltsce.ex
Update:Wed Apr 17 08:47:45 1996

117
*
[FV15700(BEF )02/95]
The remote entry features only operate with the
ignition in the OFF position.
*
[FV15800(BEF )04/94]
quarter page art:0020788-A
The remote entry transmitter
%*
[FV15901(BEF )02/95]
Unlocking the doors with the remote entry
system
*
[FV16001(BEF )02/95]
To unlock the driver's door, press the UNLOCK
button.
*
[FV16101(BEF )02/95]
To unlock the other doors, press the UNLOCK
button a second time within five (5) seconds of
unlocking the driver's door.
*
[FV16300(BEF )02/95]
Locking the doors with the remote entry
system
*
[FV16401( E )04/95]
To lock all the doors, press the LOCK button.
This will also arm the optional factory installed
Anti-Theft system.
%*
[FV16800(BEF )02/95]
Remote entry personal alarm
*
[FV16900(BEF )04/95]
If you wish to activate the remote entry system
personal alarm, press the PANIC button. This
will honk the horn and flash the lights for
approximately 2 minutes 45 seconds. You can
turn it OFF by pressing the PANIC button again
from the same transmitter or by turning the
ignition to the ON or ACCESSORY position.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

118
*
[FV17000(BEF )02/95]
When you use the remote entry UNLOCK or
PANIC buttons, the illuminated entry system
turns on the vehicle's interior lights for 25
seconds. You can turn these lights off with the
remote entry LOCK button or by turning the
ignition to the ON or ACCESSORY position.
*
[FV17100(BEF )04/94]
quarter page art:0060566-B
%*
[FV17200( E )04/95]
Arming and Disarming the Alarm System
with Remote Entry
*
[FV17300( E )04/95]
Your Remote Entry System will automatically
arm the factory installed Anti-Theft System when
the doors are locked, and automatically disarm it
when the doors are unlocked. The remote will
also reset the anti-theft alarm (when the driver's
door is unlocked) if it was triggered.
*
[FV17400( E )04/95]
The remote entry system may not arm and
disarm non-factory installed anti-theft systems.
%*
[FV17501(BEF )02/95]
Replacing the batteries
*
[FV17601(BEF )02/95]
The remote entry transmitter is powered by two
coin type three-volt lithium 2016
batteries (included) that should last for several
years of normal use. If you notice a significant
decrease in operating range, the batteries should
be replaced. Replacement batteries can be
purchased at most pharmacies, watch stores or
at your Ford or Lincoln-Mercury dealer.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

120 %
*
[FV18101(BEF )02/95]
Replacing lost transmitters
*
[FV18200(BEF )06/95]
In the event a transmitter is lost, you should
take all your vehicle's transmitters to your
dealer to have the remote entry system
deprogrammed for the lost transmitter. This is
necessary to prevent further unauthorized use of
the lost transmitter.
*
[FV18301(BEF )02/95]
You can also purchase additional transmitters
(up to 4 transmitters can be used) from your
dealer. You will need to take all your
transmitters to the dealer so they can program
them to the remote entry system all at the same
time.
*
[FV18400( E )03/94]
Memory lock (sliding door)
[FV18500( E )05/91]
Your Econoline has a ªMemory Lockº feature
that does not require the sliding door or the
60/40 cargo doors to be closed before using the
power locks. If you lock your doors with the
power lock switch or the Remote Transmitter
while the door is open, the door will
automatically lock after it is closed.
*
[FV18601(BEF )04/95]
Illuminated Entry System (If equipped)
[FV18701(BEF )04/95]
This system will provide illumination of the
vehicle's interior courtesy lamps when either
outside front door handle is pulled or when the
Remote Entry System is used to unlock the door
or sound the Personal Alarm. The system will
automatically turn off after approximately 25
seconds or when the ignition is turned to the
START or ACCESSORY position.
*
[FV18801(BEF )04/94]
NOTE: The inside lights will not turn off if
you have turned them on with the
dimmer knob or if any door is open.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

121
% [FV19103( E )04/95]
Anti-theft system (If equipped)
*
[FV19106( E )05/95]
When armed, this system helps protect your
vehicle against break-ins or theft.
%*
[FV19109( E )05/95]
When an unauthorized entry occurs, the system
triggers and will:
*
[FV19112( E )05/95]
q
flash the headlamps, parking lamps, and
alarm indicator lamp
*
[FV19115( E )06/95]
q
honk the horn
*
[FV19118( E )05/95]
q
disable the starting circuit to prevent the
vehicle from being started
%*
[FV19121( E )05/95]
Arming the system
*
[FV19124( E )05/95]
1. Remove the key from the ignition.
*
[FV19130( E )05/95]
2. Open any door. The alarm indicator light
will start flashing to remind you to arm the
system.
*
[FV19133( E )05/95]
3. Lock the doors by using the power door
lock switch. The alarm indicator light will
now glow steadily.
*
[FV19134( E )04/95]
NOTE: The system can also be armed by
pressing the LOCK button on the
remote transmitter after the doors have
been closed.
*
[FV19136( E )04/95]
4. Close all doors. The alarm indicator light
will then remain on steadily for
approximately 30 more seconds and then go
out. When the light goes out the system is
armed.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

122
*
[FV19139( E )06/95]
NOTE: Be sure to close all doors completely. If
not, the alarm indicator light will
remain on. Remember, your anti-theft
system is armed only after the alarm
indicator light remains on steadily for
approximately 30 seconds after the last
door is closed, and then goes out.
*
[FV19154( E )04/95]
The anti-theft system is designed to work with
the factory installed remote entry system. It may
not work with other remote entry systems.
%*
[FV19157( E )05/95]
Disarming an untriggered anti-theft system
[FV19160( E )03/93]
You can disarm the system by unlocking either
front door or the rear door with your door key.
Turn the key all the way to the end of travel or
the system will not disarm.
*
[FV19163( E )04/95]
You can also disarm the system by unlocking
the driver's door by using the UNLOCK button
of the remote entry transmitter.
*
[FV19166( E )04/95]
If the system is armed and you remain in your
vehicle, simply insert the key into the ignition
and turn it to ON. This disarms the system and
allows you to open the door and exit without
triggering the system.
%*
[FV19187( E )05/95]
Disarming a triggered system
*
[FV19190( E )05/95]
The alarm can be disarmed by:
*
[FV19196( E )04/95]
q
unlocking any door with the key, or
*
[FV19199( E )05/95]
q
using the UNLOCK button of the remote
entry transmitter
*
[FV19202( E )05/95]
NOTE: The flashing lights and honking horn
will shut off automatically within 2
minutes 45 seconds after the system is
triggered. It will trigger again if
another intrusion occurs. However, the
starter circuit remains disabled until
the system is disarmed.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

124
*
[FV22901(BEF )03/91]
Using the Power Windows (If equipped)
*
[FV23001(BEF )06/95]
Each door has a power control that opens and
closes the window on that door. The driver's
door has a master control switch that operates
both front door windows. You must place the
ignition switch in the ON or ACC position to
use your power window controls.
*
[FV23501(BEF )05/95]
RWARNING
Do not let children play with the power
windows. They may seriously hurt
themselves. Make sure occupants are clear
of the window(s) before closing.
*
[FV23800(BEF )05/95]
quarter page art:0020203-C
Master control switch
*
[FV24101(BEF )01/95]
Seats
%*
[FV24801(BEF )05/90]
Adjusting the Front Seat Manually
*
[FV24901(BEF )06/95]
To move the front seat forward or rearward:
*
[FV25001(BEF )06/95]
1. Find the adjustment lever at the lower left
corner of the front seat.
*
[FV25101(BEF )06/95]
2. Push the lever to the left to unlatch the seat.
*
[FV25201(BEF )06/95]
3. Move the seat to the desired position.
*
[FV25301(BEF )06/95]
4. Release the lever to latch the seat in its new
position. Make sure the seat locks securely in
place.
File:08ltfve.ex
Update:Wed Apr 17 08:47:13 1996

150
%*
[AS01200(BEF )05/95]
Compact Disc Radio
*
[AS01250(BEF )05/95]
The Compact Disc Radio combines the Electronic
Stereo Radio with the Ford Compact Disc Player.
*
[AS01300(BEF )04/95]
Using the Controls on Your New Radio/CD
Player
*
[AS01400(BEF )04/95]
Most of the features of this unit work for both
radio and CD operation. Also, some of the knobs
and buttons control several different functions,
so be sure to read all of the operating
instructions carefully.
*
[AS01500(BEF )06/95]
How to turn the radio on and off
*
[AS01600(BEF )06/95]
Press the ªPOWERº button to turn the radio on.
Press it again to turn it off.
*
[AS01625(BEF )06/95]
How to adjust the volume
*
[AS01650(BEF )06/95]
Press the +/Sside of the ªVOLº button to
increase/decrease the volume. Bars illuminate in
the display to show the relative volume level.
*
[AS01675(BEF )06/95]
NOTE: If the volume level is set above a
certain listening level when the
ignition switch is turned off, when the
ignition switch is turned back on, the
volume will come back to a ªnominalº
listening level. However, if the radio
power is turned off (with the
ªPOWERº button), the volume will
remain in the position it was set at
when radio power is switched back on.
*
[AS01700(BEF )06/95]
Selecting the AM or FM frequency band
*
[AS01800(BEF )06/95]
Push the ªAM/FMº button to select the desired
frequency band. When in the radio mode,
pushing the button more than once will alternate
between AM, FM1 and FM2. These functions are
used with the station memory buttons described
underHow to tune radio stations.
File:09ltase.ex
Update:Wed Apr 17 08:44:51 1996