1996 FORD CROWN VICTORIA buttons

163
select the station by using the memory buttons,
which you can set to any desired frequency.
These four methods are described below.
*
[AS56660( GV)05/95]
q
Using the ªTUNEº function
*
[AS56700( GV)03/95]
You can change the frequency up or down
one increment at a time by pressing and
releasing either the left (
b) or right (
a) side
of the ªTUNEº button.
*
[AS56750( GV)04/95]
Manual tuning adjusts your radio to any
allowable broadcast frequency, whether or
not a station is present on that frequency.
(SeeAll About Radio Frequenciesin this
section.)
*
[AS56800( GV)04/95]
q
Using the ªSEEKº function
*
[AS56850( GV)04/95]
This feature on your radio allows you to
automatically select listenable stations up or
down the frequency band. Press the right
(
a) side of the ªSEEKº button to select the
next listenable station up the frequency band.
Press the left (
b) side of the button to select
the next listenable station down the
frequency band. By holding the button down,
listenable stations can be passed over to reach
the desired station.
*
[AS56900( GV)01/95]
q
Using the ªSCANº function
*
[AS56950( GV)04/95]
Pressing the ªSCANº button will begin the
scan mode up the frequency band, stopping
on each listenable station for approximately
five seconds.
*
[AS57000( GV)02/95]
To stop the scan mode on the presently
sampled station, press the ªSCANº button
again.
File:rcasv.ex
Update:Thu Feb 15 08:03:35 1996

164
*
[AS57050( GV)04/95]
q
Setting the Station Memory Preset buttons
*
[AS57100( GV)02/95]
Your radio is equipped with 6 station
memory buttons. These buttons can be used
to select up to 6 preset AM stations and 12
FM stations (6 in FM1 and 6 in FM2).
*
[AS57150( GV)02/95]
Follow the easy steps below to set these buttons
to the desired frequencies:
*
[AS57200( GV)04/95]
1. Select a band, then select a frequency.
*
[AS57300( GV)04/95]
2. Press one of the memory buttons and hold
the button until the sound returns. That
station is now held in memory on that
button.
*
[AS57350( GV)04/95]
3. Follow the two steps above for each station
memory preset button you want to set.
[AS57375( GV)05/94]
NOTE: If the vehicle's battery is disconnected
the station memory preset buttons will
need to be reset.
*
[AS57400( GV)02/95]
Adjusting the tone balance and speaker
output of your radio
*
[AS57450( GV)04/95]
q
Increasing or decreasing bass response
*
[AS57500( GV)03/95]
Press the top (
c) of the ªBASSº button to
increase bass; press the bottom (
d) of the
ªBASSº button to decrease bass.
*
[AS57550( GV)04/95]
q
Increasing or decreasing treble response
*
[AS57600( GV)03/95]
Press the top (
c) of the ªTREBLEº button to
increase treble; press the bottom (
d) of the
treble button to decrease treble.
File:rcasv.ex
Update:Thu Feb 15 08:03:35 1996