1996 FORD CONTOUR height

12
[SR06025(ALL)03/95]4.
Pull up on the shoulder belt to remove slack in the lap belt.
*
[SR06050(ALL)05/95]
NOTE: When the combination lap/shoulder belt is unbuckled
and allowed to retract completely, the retractor will
switch to the vehicle sensitive (emergency) locking
mode. See the detailed instructions underSafety Seats
for Childrenin this chapter.
*
[SR06051(ALL)05/95]
Shoulder Belt Height Adjustment
*
[SR06052(ALL)05/95]
Driver and right front passenger
[SR06053(ALL)03/95]
You can adjust the shoulder belt height to one of four (4)
positions.
*
[SR06054(ALL)03/95]
To adjust the belt down, push the release button (see figures 1
and 2). To adjust the belt up, slide the adjuster up. (You do not
have to push the release button.)
[SR06056(ALL)05/95]
17-1/2 pica
art:0001183-C
Figure 1 Ð The shoulder belt height adjuster
File:cdsro.ex
Update:Thu Jan 25 12:13:11 1996

Safety Restraints
13
[SR06057(ALL)05/95]
10-1/2 pica
art:0001184-D
Figure 2 Ð Adjusting the shoulder belt height
[SR06070(ALL)05/95]
Make sure the adjuster is firmly in one of the four positions.
The belt should be adjusted up or down until the belt rests on
your shoulder near your neck.
*
[SR06075(ALL)05/95]
RWARNING
Position the shoulder belt height adjuster so that the belt
rests across the middle of your shoulder. Be sure the
shoulder belt is properly positioned on your shoulder
each time you use the belt. If the shoulder belt is off
your shoulder, on your upper arm or neck, there is a
greater risk of severe injury in a collision.
*
[SR06100(ALL)05/95]
Lap Belts
*
[SR06200(ALL)05/95]
The lap belt in the center of the rear seat does not adjust
automatically. You must adjust it to fit snugly and as low as
possible around your hips. Do not wear it around your waist.
*
[SR06300(ALL)05/95]
Pull the belt across your hips andinsert the tongue into the
correct buckleon your seat until you hear a snap and feel it
lock. Make sure the buckle is securely fastened.
File:cdsro.ex
Update:Thu Jan 25 12:13:11 1996

104
%*
[FV12400(ALL)02/95]
Power Seats (If equipped)
[FV12500(ALL)05/94]
If your vehicle has power seats, you can raise or lower the
whole front seat, move the seat forward or backward and tilt
the front or back of the seat up or down.
[FV12650(ALL)05/94]
13-1/2 pica
art:0001297-B
The seat base controls on the driver's seat
[FV12700(ALL)11/93]
To move the seat forward or back, slide the seat base control
button forward or back. To raise or lower the height of the seat
base, slide the button up or down. To raise or lower the front of
the seat base, slide the front of the button up or down. To raise
or lower the rear of the seat base, slide the back of the button
up or down.
File:cdfvo.ex
Update:Thu Jan 25 12:20:30 1996

Driving Your Contour
151 hazardous driving situations, especially when driving on
hazardous road surfaces. Even with your anti-lock brake system,
you may not have total control of your vehicle when braking on
roads with loose surfaces such as snow or gravel, holes in the
pavement, or alternating patches of slippery and dry surfaces.
*
[DR17500(ALL)05/95]
If the brake pedal is applied while the vehicle is driven over
uneven road surfaces, the ABS may cycle and the driver may
sense a pulsation in the brake pedal, accompanied by a slight
up and down movement of the pedal height and a clicking
sound. This may also happen when driving on an inclined
surface such as a driveway while making a sharp turn. This is a
normal condition.
[DR17600(ALL)05/94]
Your vehicle may have an Anti-lock Brake System feature. If it
does, check the Anti-lock Brake System light each time you start
the engine. If it stays on longer than three (3) seconds, shut off
the engine and restart. If it stays on, that means the Anti-lock
Brake feature is not working and should be serviced
immediately to restore the benefits of the Anti-lock feature.
Normal braking is not affected unless the brake warning light is
also lit.
[DR17650(ALL)05/95]
The Anti-lock Brake System has self-check capabilities. As
described above, the system turns on the anti-lock light each
time you start your engine. After the engine is started and the
anti-lock light turns off, the system performs another test the
first time the vehicle reaches 5 mph (8 km/h) (12 mph
[20 km/h] for vehicles equipped with the traction control
system). The system turns on the ABS pump motor for
approximately 1/2 second. At this time, a mechanical noise may
be heard and felt. This is a normal part of the self-check feature.
If a malfunction is found during this check the anti-lock light
will come on.
*
[DR17700(ALL)12/93]
Ford Motor Company has not found any negative effects of
mobile radio transmitting equipment installed on vehicles with
the ABS system providing that the radio is installed according
File:cddro.ex
Update:Thu Jan 25 12:23:16 1996

Roadside Emergencies
171
*
[RE09250(ALL)05/95]
Removing and Replacing the Tire
[RE09300(ALL)01/95]1.
Place the scissors-type jack under the side of the vehicle and
adjust the jack height with the jack handle. The jack should
fit in the notch in the vertical rocker panel flange which is
nearest to the wheel to be changed. The front and rear
jacking notches on each side of the vehicle are marked by
arrows in the rocker panel.
[RE09401(O )05/94]
On sport models with ªskirts,º you must remove a portion
of the skirt before placing the jack under the vehicle.
Squeeze the removeable portion of the skirt and pull down.
A tether connects it to the rocker panel.
[RE09500(O )05/94]
10-1/2 pica
art:0001300-A
Sports models with skirts
*
[RE09800(ALL)05/95]
RWARNING
To lessen the risk of personal injury, do not put any part
of your body under the vehicle while changing a tire. Do
not start the engine when your vehicle is on the jack.
The jack is only meant for changing the tire.
File:cdreo.ex
Update:Thu Jan 25 12:24:30 1996