1996 FORD AEROSTAR wheel

5
%*
[IN04650(ALL)06/92]
Special Notice
[IN04775(ALL)03/91]
NOTICE TO OWNERS OF
E-4WD VEHICLES
[IN04805(ALL)03/95]
As with other vehicles of this type, failure to
operate this vehicle correctly may result in loss
of control or an accident. Be sure to read the
special driving instructions in the section
Electronic 4-Wheel Drive (E-4WD)in this book.
%
*
[IN05100(ALL)06/95]
Your Vehicle Identification
Number (VIN)
*
[IN05200(ALL)06/95]
Your Vehicle Identification Number (VIN) is the
same as the warranty number that appears on
your owner card. You should include this
number any time you write to Ford Motor
Company about your vehicle.
*
[IN05300(ALL)06/95]
The Vehicle Identification Number is attached to
your vehicle in the following places:
*
[IN05400(ALL)05/95]
q
on the metal tag attached to the top of the
instrument panel on the driver's side Ð you
can see the tag by looking through the
windshield from outside your vehicle.
*
[IN05450(ALL)10/89]
one inch art:0010558-A
Vehicle Identification Number (VIN/Serial Number)
File:02cpina.ex
Update:Tue Aug 29 17:33:02 1995

6 %
*
[IN05500(ALL)06/95]
q
on the Safety Compliance Certification Label
Ð this label is attached to the left front door
lock facing or the door latch post pillar. It is
required by the National Highway Traffic
Safety Administration and is made of special
material. If someone tampers with it, it will
be destroyed and/or a destruction pattern
will appear.
*
[IN05515(ALL)05/95]
The label contains the name of the manufacturer,
the month and year of manufacture, the
certification statement and the Vehicle
Identification Number. The label also contains
Gross Vehicle Weight Rating and Gross Axle
Weight Ratings, wheel and tire data and
information codes for additional vehicle data.
For further information about the Safety
Compliance Certification Label and the
information contained on it, refer to the Index.
%*
[IN05545(ALL)06/95]
Federal Highway Administration
Regulation
*
[IN05560(ALL)06/95]
Regulations such as those issued by the Federal
Highway Administration or issued pursuant to
the Occupational Safety and Health Act (OSHA),
and/or state and local laws and regulations may
require additional equipment for the way you
intend to use the vehicle. It is the responsibility
of the registered owner to determine the
applicability of such laws and regulations to
your intended use for the vehicle, and to
arrange for the installation of required
equipment. Your Ford dealer has information
about the availability of many items of
equipment which may be ordered for your
vehicle.
File:02cpina.ex
Update:Tue Aug 29 17:33:02 1995

7
%*
[IN06000(ALL)01/95]
Breaking Your Vehicle In
*
[IN06100(ALL)03/95]
Your new vehicle goes through an adjustment or
break-in period during the first 1,000 miles
(1,600 km) that you drive it. During the break-in
period, you need to pay careful attention to how
you drive your vehicle.
%*
[IN06300(ALL)01/95]
q
Avoid sudden stops.Because your vehicle
has new brake linings, you should take these
steps:
*
[IN06400(ALL)01/95]
Ð Watch traffic carefully so that you can
anticipate when to stop.
*
[IN06500(ALL)01/95]
Ð Begin braking well in advance.
*
[IN06600(ALL)01/95]
Ð Apply the brakes gradually.
*
[IN06700(ALL)01/95]
The break-in period for new brake linings
lasts for 100 miles (160 km) of city driving or
1,000 miles (1,600 km) of highway driving.
*
[IN06750(ALL)12/93]
q
Wheel lug nuts must be retightened to proper
torque specifications at 500 miles/800 km of
new vehicle operation. Proper torque
specifications are provided in this guide. Also
retighten to proper torque specification at 500
miles/800 km after any wheel change or any
other time the wheel lug nuts have been
loosened.
%*
[IN06800(ALL)01/95]
q
Use only the type of engine oil that Ford
recommends.SeeEngine oil recommendations
in the Index. Do not use special ªbreak-inº
oils.
File:02cpina.ex
Update:Tue Aug 29 17:33:02 1995

28
*
[SR11600(ALL)08/95]
RWARNING
If a passenger is not properly seated and
restrained, an inflating air bag could cause
serious injury.
*
[SR11640(ALL)07/95]
RWARNING
Do not place objects or mount equipment
on or near the air bag cover on the
steering wheel or in front seat areas that
may come in contact with a deploying air
bag. Failure to follow this instruction may
increase the risk of personal injury in the
event of a collision.
*
[SR11650(ALL)07/95]
For further information about the proper
mounting of equipment in the front seat of this
vehicle, please refer to Ford's brochure entitled
Some Important Information About Air Bag
Supplemental Restraint Systemwhich can be
obtained by calling Helm Inc. at 1-800-782-4356.
Ask for brochure FPS-8602.
*
[SR11660(ALL)08/95]
For additional important safety information on
the proper use of seat belts, child seats, and
infant seats, please read the other sections of this
chapter of the Owner Guide, especially sections
entitledSafety Belts for ChildrenandSafety Seats
for Children.
%*
[SR11800(ALL)01/95]
How the Air Bag Supplemental Restraint
System Operates
[SR11850(ALL)05/95]
The Air Bag Supplemental Restraint System
consists of the driver air bag, impact sensor, a
system diagnostic module, a readiness light and
tone, and the electrical wiring which connects
the components.
File:03cpsra.ex
Update:Tue Aug 29 17:35:04 1995

61
Starting Your Aerostar
*
[ST01700(ALL)03/95]
Ignition
%*
[ST01800(ALL)01/95]
Understanding the Positions of the Ignition
*
[ST02000(ALL)05/90]
quarter page art:0020004-B
The positions of the key in the ignition lock cylinder.
%*
[ST02100(ALL)07/95]
ACCESSORY allows some of your vehicle's
electrical accessories such as the radio and the
windshield wipers to operate while the engine is
not running.
*
[ST02500(ALL)08/95]
LOCK locks the steering wheel and gearshift
lever.
*
[ST02700(ALL)01/95]
LOCK is the only position that allows you to
remove the key. The LOCK feature helps to
protect your vehicle from theft.
*
[ST02800(ALL)05/95]
If your key is stuck in the LOCK position and
will not turn, move your steering wheel left or
right until the key turns freely.
*
[ST02850(ALL)03/95]
OFF allows you to shut off the engine and all
accessories without locking the steering wheel or
the automatic transmission gearshift lever.
File:04cpsta.ex
Update:Tue Aug 29 17:35:31 1995

65
*
[ST06475(ALL)02/95]
4. Turn the key to the START position
(cranking) until the engine starts. Allow the
key to return to the ON position after the
engine has started.
*
[ST06501(ALL)02/95]
If you have difficulty in turning the key,
rotate the steering wheel slightly because it
may be binding.
%*
[ST06505(ALL)04/95]
For a cold engine:
*
[ST06510(ALL)06/95]
q
At temperatures10ÊF (-12ÊC) andbelow:If
the engine does not start infifteen (15)
secondson the first try, turn the key to OFF,
wait approximately ten (10) seconds so you
do not flood the engine, then try again.
*
[ST06515(ALL)04/95]
q
At temperaturesabove10ÊF(-12ÊC):If the
engine does not start infive (5) secondson
the first try, turn the key to OFF, wait
approximately ten (10) seconds so you do not
flood the engine, then try again.
%*
[ST06530(ALL)05/95]
For a warm engine:
*
[ST06551(ALL)04/95]
q
Do not hold the key in the START position
for more thanfive (5) secondsat a time. If
the engine does not start within five (5)
seconds on the first try, turn the key to the
OFF position. Wait a few seconds after the
starter stops, then try again.
*
[ST06575(ALL)08/95]
Whenever you start your vehicle, release the key
as soon as the engine starts. Excessive cranking
could damage the starter.
*
[ST06601(ALL)08/95]
After you start the engine let it idle for a few
seconds before driving away. Keep your foot on
the brake pedal and put the gearshift lever in
gear. Release the parking brake. Slowly release
the brake pedal and drive away in the normal
manner.
File:04cpsta.ex
Update:Tue Aug 29 17:35:31 1995

80
*
[LG05300(ALL)05/95]
one inch art:0020048-A
Check engine warning light symbol
[LG05525(ALL)03/94]
Electronic 4-Wheel Drive Warning Light
(If equipped)
[LG05550(ALL)03/95]
The Electronic 4-Wheel Drive Warning Light
turns on when the Electronic 4-Wheel Drive
system is not working properly. This light comes
on briefly when you turn the ignition key to the
ON position, but should turn off when the
engine starts. If the light does not come on when
you turn the ignition to the ON position, or if it
comes on and stays on when you are driving,
have your vehicle serviced as soon as possible.
[LG05560(ALL)03/94]
The 4WD light will go off after a few seconds
and stay off if all systems are operating
correctly. If a problem is detected, the 4WD
warning light will flash a certain number of
times indicating the location of the problem. The
flashing will continue until the problem is
corrected. Each time the ignition key is turned
on the controller will detect the problem and
flash the signal. The 4WD system remains safe to
operate and the vehicle should be returned for
service.
[LG05575(ALL)03/94]
one inch art:0020529-B
Electronic 4-wheel drive warning light
File:05cplga.ex
Update:Tue Aug 29 17:36:50 1995

109
Steering Column Controls
*
[SC00400(ALL)01/95]
The controls on the steering column and wheel
are designed to give you easy access to the
controls while you are driving.
%
*
[SC00500(ALL)01/95]
The Turn Signal Lever
*
[SC00600(ALL)01/95]
You can use the turn signal lever on the left side
of the steering column to:
*
[SC00700(ALL)03/95]
q
operate the turn signals and cornering lamps
*
[SC00800(ALL)01/95]
q
turn the high beams on/off
*
[SC00900(ALL)05/95]
q
flash the lamps
*
[SC01000(ALL)01/95]
q
turn the windshield wipers and washer
on/off
%*
[SC01100(ALL)01/95]
Turn Signals
[SC01700(ALL)05/95]
one third page art:0095013-A
Turn signal operation
File:07cpsca.ex
Update:Tue Aug 29 17:38:34 1995