1996 CHEVROLET TRACKER tow

It can be dangerous to get out of your vehicle if
the shift lever is
not fully in PARK (P) with the
parking brake firmly
set. Your vehicle can roll.
Don’t leave
your vehicle when the engine is
running unless you have to. If you’ve left the
engine running, the vehicle
can move suddenly.
You or others could be injured. To be sure your
vehicle won’t move, even when you’re on fairly
level ground, always set your parking brake and
move the shift lever to PARK (P),
If you have four-wheel drive and your transfer case is in
NEUTRAL (N), your vehicle will be free to roll, even if
your shift lever is in PARK (P). So, be sure the transfer
case is in a drive gear -- not in NEUTRAL (N). Always
set your parking brake. Follow the proper steps to be
sure your vehicle won’t move. See “Shifting Into
PARK (P)” in the Index.
If you’re pulling a trailer, see “Towing a Trailer’’ in
the Index.
2-26
ProCarManuals.com

Lamps Control
Turn the outside part of the lever to control the lamps.
There are three positions for the lamp switch.
OFF: All lamps are off.
-300: : The parking lamps, taillamps, license plate
lamp and
the instrument panel lights come on. The
headlamps are off.
-:g- : The headlamps and all other operating lamps
come on.
Lamps On Reminder
If you turn the ignition off, remove the key, open the
door and leave the lamps
on, a chime will remind you to
turn off your lamps.
Headlamp High/Low Beam Changer
First, you must have the headlamps on. For high beams,
push the turn signal lever away
from you.
When the high beams are
on, a light on the instrument
panel also
will be on. It will
go off when you switch to
low beam.
To switch back to low beams, pull the lever toward you.
2-29
ProCarManuals.com

Flash-to-Pass
With the lever in the low-beam position, pull the lever
towad you to momentarily switch to high beam (to
signal that you are going to pass). When you release the
lever, the headlamps will return
to low-beam operation.
Windshield WipedWasher Lever
The lever on the right side of the steering column
controls the windshield wipers
and washers. Move the wiper switch
to the position
you want:
OFF: The wipers are off.
INT Intermittent wiper operation. In light rain or snow,
you might want to use this position rather than
continuous wiping.
LO: The wipers will run continuously at low speed.
HI: The wipers will run continuously at high speed.
For a single wiping cycle, pull the lever toward
you.
Hold it there until the wipers start, then let go. The
wipers will stop after one cycle. If you want more
cycles, hold the lever longer.
Be sure
to clear ice and snow from the wiper blades
before
using them. If they’re frozen to the windshield,
carefully loosen or thaw them.
If your blades do become
damaged, get new blades
or blade inserts.
Heavy snow or ice
can overload your wipers. A circuit
breaker will stop them until the motor cools. Clear away
snow or ice
to prevent an overload.
2-30
ProCarManuals.com

Windshield Washer
Pull the wiper/washer lever toward you to spray washer
fluid on the windshield. The spray will continue until
you release the lever. This will also turn on the low
speed wipers. See “Windshield Washer Fluid” in
the Index.
A CAUTION:
In freezing weather, don’t use your washer until
the windshield is warmed. Otherwise the washer
fluid can form ice
on the windshield, blocking
your vision.
Rear Window WipedWasher (Option)
{I To turn on your rear wiper,
push the upper button. Push
the same button again to
turn it off.
To spray washer fluid on the rear window, push the
lower button about halfway down. Washer fluid will
spray as long as you hold this button. To wash and wipe
at the same time, push the button all the way in.
The washer
and wiper will run as long as you hold this
button.
To add washer fluid, see “Windshield Washer
Fluid” in the Index.
2-31
ProCarManuals.com

Storage Compartments
Glove Box
To open the glove box, pull the latch toward you. Use
your key to lock and unlock the glove box.
Door Storage
Each door has a storage compartment.
Front Seat Side Pockets
On the outside of each front seat is a storage pocket.
2-39
ProCarManuals.com

Brake System Warning Light
Your Geo’s hydraulic brake system is divided into two
parts.
Xf one part isn’t working, the other part can still
work and stop you. For good braking, though, you need
both parts workmg well.
If the warning light comes on, there could be a brake
problem. Have your brake system inspected right away.
If the light comes on while you are driving, pull off the
road and stop carefully.
You may notice that the pedal is
harder to push. Or, the pedal may go closer to the flow.
It may take longer to stop. If the light is still on, or if the
anti-lock brake system warning light is flashing, have
the vehicle towed for service. (See “Anti-Lock Brake
System Warning Light” and
“Towing Your Vehicle”
in the
Index.)
BRAKE
United States Canada
This light should come on when you turn the ignition
key to
STAFtT. If it doesn’t corne on then, have it fixed
so it will be ready to warn you if there’s a problem.
I
/i CAUTION:
---
Your brake system may not working properly
if the brake system warning light is on. Driving
with the brake system warning light on can lead
to an accident. If the light is still on or if the
anti-lock
brake system warning light is flashing
after you’ve pulled
off the road and stopped
carefully, have the vehicle towed
for service.
When the ignition is on, the brake system warning light
will also come on when you set your parking brake. The
light will stay on if your parking brake doesn’t release
fully. If it stays on after your parking brake is fully
released, it means you have
a brake problem.
2-62
ProCarManuals.com

Anti-Lock Brake System Warning
Light (Option)
ABS
With the anti-lock brake
system, this light will come
on when you start your
engine and it will stay
on for three seconds.
That’s normal.
If the light flashes when you’re driving, you don’t have
anti-lock brakes and there could be a problem with your
regular brakes. Pull off the road and stop carefully.
You
may notice that the pedal is harder to push. Or, the pedal
may go closer to the floor. It may take longer to stop.
Have the vehicle towed for service. (See
“Towing Your
Vehicle” in the Index.)
Your regular brake system may not be working
properly if the anti-lock brake system warning light
is flashing. Driving with the anti-lock brake system
warning light flashing
can lead to an accident. After
you’ve pulled
off the road and stopped caremy,
have the vehicle towed for service.
If the anti-lock brake system warning light stays on
longer than normal after you’ve started your engine, turn
the ignition
off. Or, if the light comes on and stays on
when you’re driving, stop as soon as possible and
turn
the ignition off. Then start the engine again to reset the
system.
If the light still stays on, or comes on again
while you’re driving, your Geo needs service. If the
light
is on but not flashing and the regular brake system
warning light isn’t on,
you still have brakes, but you
don’t have anti-lock brakes.
The anti-lock brake system warning light should come
on briefly when you turn the ignitiorrkey to ON- If the
light doesn’t come on then, have it fixed so it will-be
ready to warn you
if there is a problem.
2-63
ProCarManuals.com

If the Light Is Flashing
The following may prevent more serious damage to
your vehicIe:
Reduce vehicle speed.
Avoid hard accelerations.
@ Avoid steep uphill grades.
If towing a trailer, reduce the amount of cargo being
hauled as soon as it is possible.
If the light stops flashing and remains on steady, see “If
the Light Is On Steady” following.
If the light continues to flash, when it is safe to do so,
stop the vehicle. Put your vehicle in PARK (P). Turn the
key
off, wait at least 10 seconds and restart the engine.
If the light remains on steady, see “If the Light Is On
Steady” following.
If the light is still flashing follow the
previous steps, and drive the vehicle to
your dealer or
qualified service center for service.
If the Light Is On Steady
You may be able to correct the emission system
malfunction
by considering the following:
Did you
just put fuel into your vehicle?
If so, reinstall the fuel cap, making sure to fully install
the cap.
The diagnostic system can determine if the fuel
cap has been left off or improperly installed. This will
allow fuel to evaporate into
the atmosphere. A few
driving trips should
turn the light off.
Did you just drive through a deep puddle of water?
If so, your electrical system may be wet. The condition
will usually be corrected when the electrical system
dries out.
A few driving trips should turn the light off.
Are you low on fuel?
As your engine starts to run out of fuel, your engine may
not run as efficiently as designed since small amounts
of
air are sucked into the fuel line causing a misfire. The
system can detect this. Adding fuel should correct
this
condition. Make sure to install the fuel cap properly. It
will take a few driving trips to turn the light off.
2-66 ProCarManuals.com