1996 CADILLAC SEVILLE belt

Downloaded from www.Manualslib.com manuals search engine r
To unlatch the belt, just push the button on the buckle

Downloaded from www.Manualslib.com manuals search engine Lap Belt
When you sit in the center seating position, you have a
lap safety belt, which has
no retractor. To make the belt
longer, tilt the latch plate and pull
it along the belt.
To make the belt shorter, pull its free end as shown until
the belt is snug.
Buckle, position and release it the same way as the lap
part
of a lap-shoulder belt. If the belt isn't long enough,
see "Safety Belt Extender" at the end
of this section.
Make sure the release button on the buckle is positioned
so you would be able to unbuckle the safety belt quickly
if
you ever had to.
1-31

Downloaded from www.Manualslib.com manuals search engine Children
Everyone in a vehicle needs protection! That includes
infants and all children smaller
than adult size. In fact,
the law in every state in the United States and in every
Canadian province says children up to some age must be
restrained while
in a vehicle.
Smaller Children and Babies
I A CAUTION:
Smaller children and babies should always be
restrained in
a child or infant restraint. The
instructions for the restraint will say whether it is
the right type and size for your child.
A very
young child’s hip bones are
so small that a
regular belt might not stay low on the hips, as it
should. Instead, the belt will likely be over the
child’s abdomen. In
a crash, the belt would apply
force right on the child’s abdomen, which could
cause serious or fatal injuries.
So, be sure that
any child small enough for one is always properly
restrained in
a child or infant restraint.
1-32

Downloaded from www.Manualslib.com manuals search engine Child Restraints
Be sure the child restraint is designed to be used in a
vehicle. If it is, it will have a label saying that it meets
Federal Motor Vehicle Safety Standards.
Then follow the instructions
for the restraint. You may
find these instructions on
the restraint itself or in a
booklet, or both. These restraints use the belt system in
your vehicle, but
the child also has to be secured within
the restraint to help reduce the chance of personal injury.
The instructions
that come with the infant or child
restraint will show you how
to do that.
Where to Put the Restraint
Accident statistics show that children are safer if they
are restrained in the rear rather than the front seat. We at
General Motors, therefore, recommend that you put your
child restraint in the rear seat.
Never put a rear-facing
child restraint in the front passenger seat. Here’s why:
A CAUTION:
~ A child in a rear-facing child restraint can be
seriously injured if the right front passenger’s
air bag inflates. This is because the back of
a
rear-facing child restraint would be very close to
the inflating air bag. Always secure
a rear-facing
child restraint in the rear seat.
You may, however, secure a forward-facing child
restraint in the right front seat. Before
you secure
a forward-facing child restraint, always move the
front passenger seat
as far back as it will go. Or,
secure the child restraint in the rear seat.
Wherever you install it, be sure
to secure the child
restraint properly.
Keep in mind that an unsecured child restraint can move
around in a collision or sudden stop and injure people
in the vehicle. Be sure to properly secure any child
restraint
in your vehicle -- even when no child is in it.
1-34

Downloaded from www.Manualslib.com manuals search engine .-
c
c
Top Strap
Eyour child restraint has a top strap, it should be anchored. If
you need to have an anchor installed, you can ask your
Cadillac dealer to put
it in for you. If you want to install an
anchor yourself, your dealer can tell you how to do it.
For cars first sold in Canada. child restraints with
a top
strap must be anchored according to Canadian
law.
Your dealer can obtain the hardware kit and install it for
you, or you may install
it yourself using the instructions
provided in the kit. Use the tether hardware kit
available from the dealer.
The hardware and installation instructions were
specifically designed for this vehicle.
Securing a Child Restraint in a Rear
Outside Seat
Position
U
You’ll be using the lap-shoulder belt. See the earlier part
about the top strap
if the child restraint has one.
1. Put the restraint on the seat. Follow the instructions
for the child restraint.
2. Secure the child in the child restraint as the
instructions say.
3. Pick up the latch plate, and run the lap and shoulder
portions
of the vehicle’s safety belt through or
around the restraint. The child restraint instructions
will show
you how.
1-35

Downloaded from www.Manualslib.com manuals search engine Tilt the latch plate to adjust the belt if needed.
If the shoulder belt
goes in front of the child's face or
neck, put
it behind the child restraint.
4. Buckle the belt. Make sure the release button is
positioned so you would be able to unbuckle the
safety belt
quickly if you ever had to.
1-36

Downloaded from www.Manualslib.com manuals search engine c
Securing a Child Restraint in the Center
Rear Seat Position
5. To tighten the belt, pull up on the shoulder belt while
you push down on the child restraint.
6. Push and pull the child restraint in different
directions to be sure it
is secure.
To remove the child restraint, just unbuckle the vehicle's
safety belt and let
it go back all the way. The safety belt
will move freely again and
be ready to work for an adult
or larger child passenger.
You'll be using the lap belt.
See the earlier part about the top strap if the child
restraint has one.
1-37

Downloaded from www.Manualslib.com manuals search engine 1.
2.
3.
4.
Make the belt as long as possible by tilting the latch
plate and pulling it along the belt.
Put the restraint on the seat. Follow the instructions
for the child restraint.
Secure the child in the child restraint as the
instructions say.
Run the vehicle's safety belt through or around the
restraint. The child restraint instructions will
show
you how.
5.
6.
7.
Buckle the belt. Make sure the release button is
positioned
so you would be able to unbuckle the
safety belt quickly if
you ever had to.
To tighten the belt, pull its free end while you push
down
on the child restraint.
Push and pull the child restraint
in different
directions to be sure
it is secure. If it isn't, secure the
restraint in a different place in the vehicle and
contact the child restraint maker for their advice
about how
to attach the child restraint properly.
1-38