1996 CADILLAC DEVILLE cruise control

Downloaded from www.Manualslib.com manuals search engine c
c
P
L-
C
t
For .the 1948 model, Cadillac introduced the legendary
tail fin which once more set the trend in automotive
styling for nearly two decades.
This was closely
followed with the two door hardtop Coupe DeVille and the industry's first modern overhead valve, high
compression V8 engine on the 1949 model.
Engineering innovations, conveniences and styling
dominated the
'50s and '60s. Cruise control, automatic
climate control, tilt and telescoping steering wheels,
twilight sentinel and four door hard tops all debuted in
these
years. In 1957 the Eldorado Brougham featured advances such as air suspension, memory seat,
automatic electric door locks, transistor radio, a brushed
stainless steel roof and low profile tires.
1957 Eldorado Brougham
The Eldorado, introduced in 1953, was redesigned for
1967 as the first front wheel drive personal
luxury car.
The 472 cu. in.
V8 engine used in all Cadillacs in 1968
and 1969 was enlarged to
500 cu. in. for all 1970
through 1976 Eldorados. The Track Master
computerized skid control braking system option
debuted on 1970 Eldorados.
A driver and passenger Air Cushion Restraint
system (air bag) was available on all 1974, 1975 and
1976 Cadillacs.
Analog Electronic Fuel Injection was available, on 1975 Cadillacs and standard on
the new international
size 1976 Seville. In 1978, the Trip Computer option
incorporated the first on-board microprocessor.
ix

Downloaded from www.Manualslib.com manuals search engine Cruise Control
With cruise control, you can maintain a speed of about
25 mph (40 b/h) or more without keeping your foot on
the accelerator. This can help on long trips. Cruise
control does not work at speeds below about
25 mph
(40 km/h).
Cruise control shuts off when you apply your brakes.
A CAUTION:
e
e Cruise control can be dangerous where you
can’t drive safely at a steady speed.
So,
don’t use your cruise control on winding
roads
or in heavy traffic.
Cruise control can be dangerous on
slippery
roads. On such roads, fast changes
in tire traction can cause needless wheel
spinning, and
you could lose control. Don’t
use cruise control on slippery roads.
If your vehicle is in cruise control when the traction
control system begins
to limit wheel spin, the cruise
control will automatically disengage. (See “Traction Control System” in
the Index.) When road conditions
allow you to safely use it again, you may turn the cruise
control back on.
2-36
P
P

Downloaded from www.Manualslib.com manuals search engine r
r
r
r
r
r
r
r
" .
Setting Cruise Control
I A CAUTION:
A
If you leave your cruise control switch on when
you're not using cruise, you might hit a button and
go into.cruise when you don't want to. You could
be startied and even lose control. Keep the cruise
control switch OFF until you want to use it.
2. Accelerate to the speed you want.
1. Move the cruise control
switch to
ON. '4. Remove your foot from the accelerator pedal.
2-37

Downloaded from www.Manualslib.com manuals search engine Resuming a Set Speed
Setting the cruise control at
a desired speed and then
applying the brake
will end
the cruise function. Once
you’re going about
25 mph
(40 km/h) or more, you can
move the cruise control
I switch from ON to R/A
(Resume/Accelerate) for
about half a second to reset.
This returns you
to your
desired preset speed.
I
Remember, if you hold the switch at R/A longer than
half a second, the vehicle will accelerate until you
release the switch or apply the brake.
You could be
startled and even lose control.
So unless you want to
go faster, don’t hold the switch at RJA.
Increasing Speed While Using Cruise Control
There are two ways to increase your speed. Here’s
the first:
1. Use the accelerator pedal to go to a higher speed.
2. Push the button at the end of the lever and then
release the button
and the accelerator pedal. You’ll
now cruise at the higher speed.
Here’s
the second way to increase speed:
0 Move the cruise switch from ON to R/A. Hold it
there until you reach
a desired speed and then release
the switch.
0 To increase your speed in very small amounts, move
the switch to R/A. Each time you
do this, your
vehicle will
go about 1 mph (1.6 km/h) faster.
The accelerate feature will only work after you’have set the
cruise control speed by pushing the SET CRUISE button.
0
0
2-38

Downloaded from www.Manualslib.com manuals search engine c
c
c
Reducing Speed While Using Cruise Control
There are two ways to reduce your speed while using
cruise control:
0 Push in the button at the end of the lever until you
reach a desired lower speed, then release
it. A
CRUISE ENGAGED message will then display.
To slow down in very small amounts, push the
button for less than half a second. Each time you do
this, you’ll go
1 mph (1.6 b/h) slower.
Passing Another Vehicle While Using Cruise Control
Use the accelerator pedal to increase your speed. when
you take
your foot off the pedal, your vehicle will slow
down to the cruise control speed you set earlier.
Using Cruise Control on Hills
How well your cruise control will work on hills depends
upon your speed, load and the steepness
of the hills.
When going up steep hills,
you may have to step on the
accelerator pedal to maintain your speed. When going
downhill, you may have to brake or shift to a lower gear
to keep your speed down.
Of course, applying the brake
takes you out
of cruise control. Many drivers find this to
be too much trouble and don’t use cruise control on steep hills.
Ending Cruise Control
There are two ways to end cruise control:
Step lightly on the brake pedal.
Move the CRUISE switch to OFF.
Erasing Speed Memory
The cruise control set speed memory is erased when you
turn off the cruise control
or the ignition.
2-39

Downloaded from www.Manualslib.com manuals search engine CHECK COOLANT LEVEL - 02: This message will
appear when there is a low level
of engine coolant. Have
the cooling system serviced by a Cadillac technician as
soon
as possible.
CHECK FUEL GAGE - 39: This message will appear
when the fuel supply is less than four gallons (15.2
L)
and the display is turned off.
CHECK OIL LEVEL - 36: For correct operation of
the low oil sensing system, your vehicle should be on a
level surface.
A false CHECK OIL LEVEL message
may appear
if the vehicle is parked on grades. The oil
level sensing system does not check for actual oil level
if the engine has been off for a short period of time, and
the oil level is never sensed while the engine is running.
If the CHECK OIL LEVEL message appears, and your
vehicle has been parked on level ground with the engine
off for at least 30 minutes, the oil level should be
checked
by observing the oil dipstick. Prior to checking
the oil level be sure the engine has been off for five
minutes and your vehicle is on a level surface. Then
check the dipstick and add oil
if necessary. See “Engine
Oil”
in the Index.
CHECK WASHER FLUID - 25: This message will
appear for several seconds indicating that
you need
washer solvent.
CRUISE ENGAGED - 43: This message will appear
for a few seconds
when you select a speed at which
to cruise.
DOOR OPEN - 141: The passenger’s door is open or
ajar when this message appears. The vehicle’s engine
must be running and the transaxle not
in.PARK (P) for
this message to display.
A chime will also sound when
the vehicle’s speed is greater than
5 mph
(8.1 km/h).
DRIVER DOOR OPEN - 140: This message
will display when the vehicle is being shifted out
of
PARK (P) with the engine running to signal that
the driver’s door is open or ajar.
A chime will also
sound when the vehicle’s speed is greater than
5 mph
(8.1 W).
ENGINE COOLANT HOT-IDLE ENGINE - 44:
This message will appear when the engine coolant
temperature
is over 248°F (126°C). To avoid added
strain on a hot engine, turn off the climate control
system. Stop and allow your vehicle to idle until
it cools
down
or the message is removed. If it does not cool
down,
turn off the engine and have it serviced before
driving it again. Severe engine damage can result from
an overheated engine. See “Engine Overheating” in
the Index.
2-78

Downloaded from www.Manualslib.com manuals search engine Remember: Anti-lock doesn’t change the time you need
to get your foot
up to the brake pedal or always decrease
stopping distance. If you get too close
to the vehicle in
front of you, you won’t have time to apply your brakes
if that vehicle suddenly slows or stops. Always leave
enough room
up ahead to stop, even though you have
anti-lock brakes.
Using Anti-Lock
Don’t pump the brakes. Just hold the brake pedal down
and let anti-lock work
for you. You may hear the
anti-lock
pump or motor operate, and feel the brake
pedal pulsate, but this is normal.
Traction Control System
Your vehicle has a traction control system that limits
wheel spin. This is especially useful in slippery road
conditions. The system operates only if it senses that one
or both of the front wheels are spinning
or beginning to
lose traction. When this happens, the system works
the
front brakes and reduces engine power to limit wheel
spin.
The
TRACTION ACTIVE message will display on the
Driver Information Center when the traction control system is limiting wheel spin.
See “Driver Information
Center Messages”
in the Index. You may feel or hear
the system working, but this
is normal.
If your vehicle
is in cruise control when the traction
control system begins to limit wheel spin, the cruise
control will automatically disengage. When road conditions allow you
to safely use it again, you may
re-engage the cruise control. (See “Cruise Control”
in the Index.)
1
4-8

Downloaded from www.Manualslib.com manuals search engine , DRL , I I I :NTLPS , I CIG LTRl I , '
L HDLP Lo R HDLP LO L HDLP HI R HDLP HI
, HOLPS , I HAZARD I I STOP I I MIRROR , I FOGlORL ,
IGN O(ENO) CRANK WIPERS
FUSE CENTER IDENTIFICATION
000
OXY SEN2 OXY SEN1 FUEL PUMP
OOEI
CRUISE I RELAY I FUEL PUMP
I DtSTR I ,PCM/IGN)I I ECS ~,
, I ,PCM(BAT)l ]A/C COMP,
FRONT OF VEHICLE 3648830 /
I Fuse I Usage I -
Daytime Running Lamps
Trunk Lamp, Courtesy Lamps,
Front Vanity Lamps, Glove Box
Lamp, Garage Door Opener, Courtesy Lamp Relay
ICIGLrnl I
Front Cigarette Lighter (
Console Only), Rear Lig 'ull
Iter
CIG LTR2 Right and Left Rear
Cigarette Lighters
I Fuse
I L HDLP LO
L HDLP HI
R HDLP HI
SENSE
HDLPS
HAZARD
STOP
Usage
Left Low-Beam Headlamp
Right Low-Beam Headlamp, Light
Emitting Diode
(LED) on
Headlamp Switch
Left High-Beam Headlamp Right High-Beam Headlamp
Heated Windshield Control
(Optional)
Headlamp Switch
and Relay,
High/Low
Beam Control Relay,
Right and
Left Low Beam @-Beam),
Right and Left High Beam
Electronic Flasher Module,
Turn/Hazard Module, Right and
Left
and Left Front Turn Lamps, Right
and Left Repeater Lamps (Export)
Stoplamp Switch, Centered
High-Mounted Stoplamp
(CHMSL), Turn Hazard Switch,
ABS Controller, Stepper Motor
Cruise
Control, Right and Left
Rear Stoplamps
TU^ Lamps, Back-up Lamps, Right
-.
6-56