1996 CADILLAC DEVILLE ignition

Downloaded from www.Manualslib.com manuals search engine Theft-Deterrent System (Option)
SECURITY
If your ignition is off and
any door is open, the
SECURITY light will flash
reminding you to activate
the system (the light will
also flash if the battery has
been disconnected or
reconnected).
1. Open the door.
2. Lock the door using the power door lock or the
Keyless Entry system. The
SECURITY light should
come on and stay on.
3. Close all the doors. The SECURITY light should go
off within approximately 30 seconds.
The horn will sound and the lamps will flash for several
minutes when the door or
trunk is opened without the
key or Keyless Entry system. The
horn also sounds if
the locks
are damaged. Remember,
the theft-deterrent system won’t activate
if
you lock the doors with a key or use the manual door
lock. It activates only if
you use a power door lock
switch or the Keyless Entry system.
To avoid activating the alarm by accident: I
0 The vehicle should be locked with the door key after
the doors are closed if you don’t want to activate the
theft-deterrent system.
0 Always unlock a door with a key or use the Keyless
Entry system. (Pressing the unlock button on the
Keyless Entry transmitter disables the theft-deterrent
system.) Unlocking
a door any other way will
activate the alarm. Cycling
the ignition without
disarming the theft-deterrent system will also
activate the alarm.
If you activate the alarm by accident, unlock any door
with your key.
You can also turn off the alarm by using
the Keyless Entry system. The alarm won’t stop
if you
try to unlock a door any other way.
3 13
-,

Downloaded from www.Manualslib.com manuals search engine r-
c
Testing the Alarm
1. From inside the vehicle, roll down the window, then
get
out of the vehicle, keeping the door open.
2. From outside of the vehicle, with the door open, lock
the vehicle using the power door lock or
the Keyless
Entry system
and close the door. Wait 30 seconds.
3. Reach in and unlock the door using the manual lock
and open the door. The horn will sound and the
headlamps will flash.
If the alm does not sound when it should, check to see
if the horn works. The horn fuse may be blown. To
replace the fuse, see “Fuses and Circuit Breakers” in the\

Index.
If the fuse does not need to be replaced, you may
need to have your Cadillac serviced.
To reduce the possibility of theft, always activate the
optional theft-deterrent system when leaving your vehicle.
PASS-Key%
I Your vehicle is equipped
with the PASS-Key
I1
theft-deterrent system. PASS-Key
I1 is a passive
system. The system is
armed when the key is
removed from the ignition.
PASS-Key
11 uses a resistor pellet in the ignition key that
is read by a decoder module-in your vehicle. If the key
resistor matches the code stored
in the vehicle module, the
vehicle’s fuel and starting systems will
be enabled. If an
incorrect key is used, the vehicle’s fuel and starting
systems are disabled for three minutes. Additional attempts
during
this lockout period will not start the car.
If the engine does not start and the STARTING
DISABLED DUE TO THEFT SYSTEM, REMOVE
IGNITION KEY message is displayed in the Driver
Information Center, your
key should be checked for
damage.
Starting may be attempted with an undamaged
2-13

Downloaded from www.Manualslib.com manuals search engine key immediately. See your Cadillac dealer or a
locksmith for
key service.
If the STARTING DISABLED DUE TO THEFT
SYSTEM, REMOVE IGNITION KEY and WAIT
3 MINUTES messages are displayed, the key should
be cleaned and dried. After three minutes,
try again.
A START CAR message will appear at this time. If
the engine still does not start, wait 3 minutes and try a
duplicate key.
At this time, fuses should be checked (see
“Fuses and Circuit Breakers”
in the Index). If the engine
does not start with the duplicate key, your vehicle needs
service. See your Cadillac dealer
for service.
If the THEFT SYSTEM PROBLEM message is
displayed during vehicle operation,
your vehicle needs
servicing. Your vehicle will restart
if you turn it off;
however, your vehicle may be unprotected. See your
Cadillac dealer for service.
If an ignition key is lost or damaged, see your Cadillac
dealer
or a locksmith to have a new key made.
New Vehicle CLBreak-In’’
NOTICE:
Your modern Cadillac doesn’t need an elaborate
“break-in.” But it
will perform better in the long
run if
you follow these guidelines:
Don’t drive at any one speed -- fast or
slow
-- for the first 500 miles (804 km).
Don’t make full-throttle starts.
200 miles (322 km) or so. During this time
your new brake linings aren’t yet broken
in. Hard stops with new linings can mean
premature wear and earlier replacement.
Follow this breaking-in guideline every
time
you get new brake linings.
0 Don’t tow a trailer during break-in. See
“Towing
a ’Ilrailer” in the Index for more
information.
0 Avoid making hard stops for the first
2-14
3.

Downloaded from www.Manualslib.com manuals search engine I_
c
Ignition Positions
I NOTICE:
If your key seems stuck in LOCK and you can’t
turn it,
be sure it is all the way in. If it is, then
turn the steering wheel left and right while you
turn the key
hard. But turn the key only with
your hand. Using
a tool to force it could break
the key
or the ignition switch. If none of this
works, then your vehicle needs service. With the ignition key in the ignition switch, you
can turn
the switch to five different positions:
ACCESSORY (A): This position lets you use things
like the radio and the windshield wipers when the
engine
is off. To get into ACCESSORY, push in the key
and
turn it toward you. The steering wheel will remain
locked, just as it was before you inserted the key.
LOCK
(B): Before you put the key in, the ignition will
be in the
LOCK position. This is the only position in
which you can remove the key. This position locks the
ignition, steering wheel
and transaxle. It’s a
theft-deterrent feature.
OFF (C): This position lets you turn off the engine but
still
turn the steering wheel. It doesn’t lock the steering
wheel like
LOCK. Use OFF if you must have your
vehicle in motion while the engine is off (for example, if
your vehicle is being pushed).
RUN (D): This is the position for driving.
START (E): This starts the engine.
2-15

Downloaded from www.Manualslib.com manuals search engine Retained Accessory Power
The following accessories on your Cadillac may be used
for up to 10 minutes after the ignition key is turned
to om:
Radio
0 Power Windows
Astroroof
Power to these accessories stops after
10 minutes or if any
door is opened.
If you want power for another 10 minutes,
turn the ignition key to RUN and then back to OFF.
Starting Your Engine
Move your shift lever to PARK (P) or NEUTRAL (N).
Your engine won’t start in any other position -- that’s a
safety feature.
To restart when you’re already moving,
use
NEUTRAL (N) only.
NOTICE:
Don’t try to shift to PARK (P) if your Cadillac
is moving. If you do, you could damage the
transaxle. Shift
to PARK (P) only when your
vehicle is stopped.
1. Without pushing the accelerator pedal, turn your
ignition
key to START. When the engine starts, let
go of the key. The idle speed will go down as your
engine gets warm.
NOTICE:
Holding your key in START for longer than
15 seconds at a time will cause your battery to
be drained much sooner. And the excessive heat
can damage your starter
motor.
r’
2. If it doesn’t start right away, hold your key in
START for about three seconds at a time until your
engine
starts. Wait about 15 seconds between each
try to help avoid draining your battery.
3. If your engine still won’t start (or starts but then
stops), it could be
flooded with too much gasoline.
Try pushing your accelerator pedal all the way to the
floor and holding it there as you hold the key in
START for about three seconds.
If the vehicle starts
briefly but then stops
again, do the same thing.
2-16 1

Downloaded from www.Manualslib.com manuals search engine Ensure the shift lever is fully in PARK (P) range before
starting the engine. Your Cadillac has a brake-transaxle
shift interlock. You
have to fully apply your regular
brakes
before you can shift from PARK (P) when the
ignition key is in
the RUN position. If you cannot
shift out of
PARK (P), ease pressure on the shift
lever
-- push the shift lever all the way into PARK (P)
and release the shift lever button on the floor shift
console models as
you maintain brake application. Then
move the shift lever into the gear
you wish. (Press the
shift lever button before moving the shift lever
on floor
shift console models.) See “Shifting Out
of PARK (P)”
in this section.
REVERSE (R): Use this gear to back up.
I NOTICE: 1 ~
Shifting to REVERSE (R) while your vehicle is
moving forward could damage your transaxle.
Shift to REVERSE
(R) only after your vehicle
has stopped.
Also use this gear to rock your vehicle back and forth to
get out of snow, ice
or sand without damaging your
transaxle. See
“If You’re Stuck in Sand, Mud, Ice or
Snow” in the Index for additional information.
2-20

Downloaded from www.Manualslib.com manuals search engine F
c
Parking Brake
Hold the regular brake
pedal down with your right foot and push
down the
parking brake pedal with
your left foot to set the
parking brake. If the
ignition
is on, the PARK
BRAKE indicator light will
come
on.
If you try to drive off with the parking brake on, the
PARK
BRAKE indicator light stays on. See "Parking
Brake Indicator Light" in the Index for more
information.
When you move
out of PARK (P) or NEUTRAL (N), if
the engine is
running, the parking brake should release. If
it doesn't, you can manually release 'the parking brake. Reach under the driver's side
of the instrument panel
and pull on the manual release lever, which is located
above the parking brake pedal.
If the parking brake does
not release, you will have to have your vehicle serviced.
2-23

Downloaded from www.Manualslib.com manuals search engine f
r
r
r
r
Steering Column Shift Lever
1. Hold the brake pedal down with your right foot.
2. Move the shift lever into the PARK (P) position
like this:
Pull the lever toward you.
r
r .
e
3.
4.
5.
Move the lever up as far as it will go.
With your right foot still holding the brake pedal
down, set the parking brake.
Move the ignition key to
LOCK.
Remove the key and take it with you. If you can
leave
your vehicle with the ignition key in your
hand, your vehicle is
in PARK (P).
2-25