1996 CADILLAC DEVILLE Owners Manual

Downloaded from www.Manualslib.com manuals search engine This feature is mounted on the passenger’s interior side
of the windshield behind the rearview mirror and is used
to automatically operate the wipers by monitoring the
amount
of moisture that is on the windshield.
The Rainsense system can be activated by turning the
wiper stalk
to one of the five sensitivity levels within the
AUTO DELAY area. Turn the stalk toward you for
minimum sensitivity and away from you for maximum
sensitivity.
A single wipe will occur each time you turn
the wiper stalk to a higher sensitivity level.
An initial wipe occurs when
you turn the ignition on as a reminder
that Rainsense is active. The windshield wipers
also
remain in a “high park” position, even when the ignition
is turned
OFF.
The Rainsense wipers operate in a delay mode as well
as, a continuous low or high speed depending on the
amount
of moisture and the sensitivity level. The MIST
and “wash” cycles operate as normal and are not
effected by the Rainsense function.
NOTICE: I
- -- -~
The Rainsense feature should be turned off when
going through a car wash
to avoid damage.
It is important to note that the Rainsense wiping feature
(AUTO DELAY) can be overridden at any time
by
manually changing the wiper control to LO or HI speed.
Note that if you ever
need to replace the windshield,
make sure it is Rainsensor compatible.
2-34
-

Downloaded from www.Manualslib.com manuals search engine P
P
c
Windshield Washer
A CAUTION:
In freezing weather, don’t use your washer until
the windshield
is warmed. Otherwise the washer
fluid can form ice on the windshield, blocking
your vision.
NOTICE:
When using concentrated washer fluid,
follow the manufacturer’s instructions for
adding water.
Don’t mix water with ready-to-use washer
fluid. Water can cause the solution to freeze
and damage your washer fluid tank and
other parts of the washer system.
Also,
water doesn’t clean as well as washer fluid.
NOTICE: (Continued)
NOTICE: (Continued)
Fill your washer fluid tank only 314 full
when
it’s very cold. This allows for
expansion, which could damage the tank
if
it is completely full.
windshield washer. It can damage your
washer system and paint.
Don’t use radiator antifreeze in your
Press and hold the
PUSH paddle to wash the windshield.
Release the paddle when you have enough fluid. The
wipers will
clear the windshield and either stop or return
to your preset speed.
LOW WASHER FLUID will be displayed on the DIC
when the washer fluid reaches a low level.
Driving without washer fluid can be dangerous.
A bad
mud splash
can block your vision and you could hit
another
vehicle or go off the road. Check the washer
fluid level often.
2-35 c

Downloaded from www.Manualslib.com manuals search engine Cruise Control
With cruise control, you can maintain a speed of about
25 mph (40 b/h) or more without keeping your foot on
the accelerator. This can help on long trips. Cruise
control does not work at speeds below about
25 mph
(40 km/h).
Cruise control shuts off when you apply your brakes.
A CAUTION:
e
e Cruise control can be dangerous where you
can’t drive safely at a steady speed.
So,
don’t use your cruise control on winding
roads
or in heavy traffic.
Cruise control can be dangerous on
slippery
roads. On such roads, fast changes
in tire traction can cause needless wheel
spinning, and
you could lose control. Don’t
use cruise control on slippery roads.
If your vehicle is in cruise control when the traction
control system begins
to limit wheel spin, the cruise
control will automatically disengage. (See “Traction Control System” in
the Index.) When road conditions
allow you to safely use it again, you may turn the cruise
control back on.
2-36
P
P

Downloaded from www.Manualslib.com manuals search engine r
r
r
r
r
r
r
r
" .
Setting Cruise Control
I A CAUTION:
A
If you leave your cruise control switch on when
you're not using cruise, you might hit a button and
go into.cruise when you don't want to. You could
be startied and even lose control. Keep the cruise
control switch OFF until you want to use it.
2. Accelerate to the speed you want.
1. Move the cruise control
switch to
ON. '4. Remove your foot from the accelerator pedal.
2-37

Downloaded from www.Manualslib.com manuals search engine Resuming a Set Speed
Setting the cruise control at
a desired speed and then
applying the brake
will end
the cruise function. Once
you’re going about
25 mph
(40 km/h) or more, you can
move the cruise control
I switch from ON to R/A
(Resume/Accelerate) for
about half a second to reset.
This returns you
to your
desired preset speed.
I
Remember, if you hold the switch at R/A longer than
half a second, the vehicle will accelerate until you
release the switch or apply the brake.
You could be
startled and even lose control.
So unless you want to
go faster, don’t hold the switch at RJA.
Increasing Speed While Using Cruise Control
There are two ways to increase your speed. Here’s
the first:
1. Use the accelerator pedal to go to a higher speed.
2. Push the button at the end of the lever and then
release the button
and the accelerator pedal. You’ll
now cruise at the higher speed.
Here’s
the second way to increase speed:
0 Move the cruise switch from ON to R/A. Hold it
there until you reach
a desired speed and then release
the switch.
0 To increase your speed in very small amounts, move
the switch to R/A. Each time you
do this, your
vehicle will
go about 1 mph (1.6 km/h) faster.
The accelerate feature will only work after you’have set the
cruise control speed by pushing the SET CRUISE button.
0
0
2-38

Downloaded from www.Manualslib.com manuals search engine c
c
c
Reducing Speed While Using Cruise Control
There are two ways to reduce your speed while using
cruise control:
0 Push in the button at the end of the lever until you
reach a desired lower speed, then release
it. A
CRUISE ENGAGED message will then display.
To slow down in very small amounts, push the
button for less than half a second. Each time you do
this, you’ll go
1 mph (1.6 b/h) slower.
Passing Another Vehicle While Using Cruise Control
Use the accelerator pedal to increase your speed. when
you take
your foot off the pedal, your vehicle will slow
down to the cruise control speed you set earlier.
Using Cruise Control on Hills
How well your cruise control will work on hills depends
upon your speed, load and the steepness
of the hills.
When going up steep hills,
you may have to step on the
accelerator pedal to maintain your speed. When going
downhill, you may have to brake or shift to a lower gear
to keep your speed down.
Of course, applying the brake
takes you out
of cruise control. Many drivers find this to
be too much trouble and don’t use cruise control on steep hills.
Ending Cruise Control
There are two ways to end cruise control:
Step lightly on the brake pedal.
Move the CRUISE switch to OFF.
Erasing Speed Memory
The cruise control set speed memory is erased when you
turn off the cruise control
or the ignition.
2-39

Downloaded from www.Manualslib.com manuals search engine Lamps
1
The control on the left side
of the instrument panel
controls these lamp systems:
e
e
e
e
e
e
e
e
Headlamps
Taillamps
Parking Lamps Sidemarker Lamps
License Plate Lamp
Underhood Lamp
Instrument Panel Lights
Interior Courtesy Lamps
Pull the knob out to the
fist stop to turn on the parking
and taillamps, sidemarker lamps and instrument panel lights. Pull the
knob out all the way to turn on the
headlamps.
You can brighten or dim the instrument
cluster by rotating the headlamp
knob. Press the knob
all the way in to turn them off. The exterior lamps
will automatically turn
on after several seconds of
wiper activation.
Headlamps
Wiper Activated Headlamps
This feature activates the headlamps and parking lamps after the windshield wipers have been in
use for
approximately 20 seconds. ’
In order to operate the wiper activated headlamps, the
twilight sentinel must
be in the on position. This feature
lights the way
in poor weather and it also makes your
vehicle more visible to other drivers. If the wiper activated headlamps are
on, and the ignition switch is
turned
off, the wiper activated headlamps will
immediately
turn off.
The wiper activated headlamps will deactivate
if you
turn off the twilight sentinel or if the windshield wipers
have been turned
off for a period of one or two seconds.
2-40

Downloaded from www.Manualslib.com manuals search engine P
c
21
c
P
c
Lamps on Reminder
You will hear a warning chime if you pull the key from
the ignition while leaving the lamps
on, if the manual
headlamp control is activated. An exception to this is
when you’re using twilight sentinel.
Daytime Running Lamps
Daytime Running Lamps (DRL) can make it easier for
others to see the front of your vehicle during
the day.
DRL can be helpful
in many different driving
conditions, but they can be especially helpful in
the
short periods after dawn and before sunset.
A light sensor on top of the instrument panel makes the
DRL work,
so be sure it isn’t covered.
The
DRL system will make the low-beam headlamps
come
on at reduced brightness when:
the ignition is on,
the headlamp switch is off and
the transaxle is not in PARK (P).
When DRL are on, only the low-beam headlamps (at
reduced brightness) will be
on. No other exterior lamps
such as the parking lamps, taillamps, etc. will be on
when the
DRL are being used. Your instrument panel
won’t be
lit up either. When
it’s dark enough outside, the low-beam
headlamps (at reduced intensity) will change
to normal
low-beam headlamp operation. When it’s bright enough
outside, the regular lamps will go
off, and the low-beam
headlamps change to the reduced brightness
of DRL.
To idle your vehicle with the DRL off, tum off the
twilight sentinel switch and shift the transaxle into
PARK (P). Placing your vehicle in PARK (P) disables
the DRL. The DRL will stay
off until you shift out of
PARK (P).
As with any vehicle, you should turn on the regular
headlamp system when you need it.
Cornering Lamps
The cornering lamps come on when the headlamps or
parking lamps are on and you signal a turn. They
provide more light for cornering.
Underhood Lamp
Turn the parking lamps on to operate the underhood lamp. The underhood
lamp will come on when the hood
is open.
2-41