1996 CADILLAC DEVILLE lock

Downloaded from www.Manualslib.com manuals search engine Checking Coolant
.
The surge tank is located next to the engine block on the
passenger’s side of the engine.
The cooling system when hot is under a lot of pressure.
If the CHECK COOLANT LEVEL message appears on
the
DIC, you will’need to add coolant.
A CAUTION:
I’urning the surge tank pressure cap when the
engine and radiator are hot can allow steam and
scalding liquids to blow out and burn you badly. Never turn the surge tank pressure cap
-- even a
little
-- when the engine and radiator are hot.
When your engine is cold, the coolant level should be
at the full cold mark, which is 2.5 inches (60 mm) below
the
base of the fill neck. Use a flashlight as necessary to
see into the tank.

Downloaded from www.Manualslib.com manuals search engine Headlamp
1. Lift the cover to gain access.
2. Turn the headlamp housing socket counterclockwise
to unlock the socket from the lamp housing.
4. Install the new bulb and socket to the wiring harness
connector. Make sure that the harness
is locked to the
bulb socket.
5. Reinstall the headlamp housing socket back into the headlamp assembly.
3. Disconnect the socket from the harness by separating
the locking clip. Do not touch the glass portion of the new halogen bulb!
The
oil from your fingers will shorten the bulb life.
6-30
c
.I
c*

Downloaded from www.Manualslib.com manuals search engine rc
Cornering Lamp
1. Open the hood to gain access to the mounting screw.
2. Remove the screw
securing the cornering
lamp housing.
~-
,’ a
3. Gently pull out the cornering lamp assembly.
4. Remove the socket by rotating it counterclockwise
slightly, then replace the bulb mid reinstall.
-
6-31

Downloaded from www.Manualslib.com manuals search engine Center High-Mounted Stoplamp
i
1
I,
5. When installing the cornering lamp housing be sure
that the two guide pins are aligned with the holes.
1. Lift the trim cover to remove.
2. Twist the socket counterclockwise and remove the
socket
and bulb from the housing.
6-32

Downloaded from www.Manualslib.com manuals search engine c
L
3. Press the bulb socket' housing lever and rotate the
socket counterclockwise to remove it.
r
4. Replace the bulb by pressing and turning it
counterclockwise.
5. Once you have installed the new bulb and socket into .
the taillamp housing, insert the tab on the lower
portion
of the taillamp housing first, then gently fit
the rest
of the housing in place.
6-34

Downloaded from www.Manualslib.com manuals search engine 7
Fuses and Circuit Breakers
The wiring circuits in your vehicle are protected from
short circuits by a combination
of fuses and circuit
breakers. This greatly reduces the chance
of fires caused
by electrical problems.
Look at the silver-colored band inside the fuse. If the
band
is broken or melted, replace the fuse. Be sure you
replace a bad fuse with a new one of the identical size
and rating.
If you ever have a problem on the road and don’t have a
spare fuse,
you can borrow one that has the same
amperage. Pick some feature of your vehicle that you
can get along without
-- like the radio or cigarette
lighter
-- and use its fuse, if it is the correct amperage.’
Replace
it as soon as you can.
There are three fuse blocks in your vehicle: the engine compartment fuse block, the MaxiFuse relay center
and
the rear compartment fuse block.
Engine Compartment Fuse Block
The fuse block is located next to the air filter on the
driver’s side
of the engine. Lift the cover to gain access.

Downloaded from www.Manualslib.com manuals search engine c
Fuse
MIRROR
FOG/DRL
[GN 0 mG)*
CRANK
ABS
IGN 1
WIPERS
OXY SEN2"
Usage
Inadvertent Power Relay, Outside
Rearview Mirror, Data Line Connector
(DLC), Flash-to-Pass
Module
Daytime Running Lamp
(DRL)
Relay (Domestic Only), Fog Lm
Relay (Optional), Headlamp
Switch, Right and Left Front Fog
Lamps (Optional)
Powertrain Control Module
(PC1
Sensing and Diagnostic Module
(SDM)
Anti-Lock Brake System/Anti-SI
Regulation-5 (ABS/ASR-5) Controller
Rear Ignition-
1 Relay, Front Fog
Lamp Relay, Rear Lamp Relay
(Export), Controlled Power
Back-up Relay,
DRL Relay
(Domestic Only)
Accessory Relay, Wiper Switch,
Cluster, Wiper
Motor, wiper Pump I
02 Sensor Rear, Catalytic
Converter (CAT) Rear
09 Sensor 1
~ ~ ~ ~ ~~~
OXY SENl*
=PUMP*
[NJ*
rnJ*
CRUISE
DISTR"
PCM
(IGN)*
PCM (BAT)*
A/C COMP
Usage
02 Sensor Front, CAT Front 02
Sensor
Engine
Oil Pressure Indicator, PCM,
Fuel Pump Relay, Fuel Pump
Injectors
2,3,5,8
Injectors 1,4,6,7
Stepper Motor Cruise Control,
Park-Neutral Position Switch,
Back-up Lamps, Electrochromatic
Mirror, Brake-Transaxle Shift
Interlock (BTSI)
Electronic Ignition Control
Powertrain Control Module (PCM)
Transaxle Shift Solenoids, Mass Airflow,
Low Refrigerant Cutoff
Switch, Canister Purge, PCM,
Linear Exhaust Gas Recirculation (EGR), Power Steering Press
Switch, Front Ignition-
1 Relay
PCM
AC Compressor Relay, Cooling
Fan Relays
1,2,3, Compressor
BD
11 related fuses or circuit breakers.

Downloaded from www.Manualslib.com manuals search engine MaxiFuse/Relay Center
The MaxiFuses and relays are located next to the engine
compartment fuse block on the driver’s side
of the
engine.
If a MaxiFuse should blow, have your vehicle
serviced
by your Cadillac dealer immediately.
RELAY CENTER IDENTIFICATION
€7
STARTER
Fuse
BODY 1
BODY 2
BODY 3
INADVERT
Usage
Real Tie Dampening (RTD) Fuse,
Convenience
Fuse, BAm Fuse,
Headlamp Wash Fuse (Export),
Antenna Fuse, Park
Lamp Relay,
Right and Left Park Fuse
Defog Relay, Pull-Down Fuse,
Right and Left Heated Seat Fuse,
Electronic Level Control
@LC)
Fuse, Rear Defog Fuse, Heated Mirror Fuse
Controlled Power Relay,
Controlled Power Back-up Relay
Mirror Fuse, Platform Zone
Module
(PZM) Fuse, Radiophone
Fuse, Cluster Fuse, AMP
Fuse
Comfort Fuse
Inadvertent Power Relay,
Brushless Blower Motor, Interior
Lamps Fuse, Cigarette Lighter-
1
Fuse, Cigarette Lighter-2 Fuse
6-58