13-69
6 -
Bearing cap
Bearing cap 1: Pulley endBearing cap 3 with recesses for thrust
washers Bearing shell retaining lugs (cylinder
block/bearing cap) must be on the same
side
7 -
10 Nm +
1/4 turn (90 ) further
Always replaceAfter each removal of the bolts replace
sensor wheel Fig. 1
, Page 13
-71
8 -
Needle bearing
For vehicles with manual transmissionPulling out and driving in Page 13
-73
Pa
ge 3 of 12 Crankshaft, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.3
13-74
Note:
A needle bearing must be installed in the
crankshaft on vehicles with a manual
transmission. Install needle bearing if
necessary.
The needle bearing must not be installed in the
crankshaft on vehicles with an automatic
transmission. Remove needle bearing if
necessary.
Removing
- Pull out needle bearing with Kukko 21/1 and Kukko 22/1.
Pa
ge 8 of 12 Crankshaft, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.3
