Page 3 of 47
13-3
 
  
Removing  
 Repair Manual, Body Exterior, Repair Group 63
    -  Remove sound insulation   Fig.   1
 ,   Page 
13
-6 
-  Remove front bumper:-  Remove lower air duct hose to charge air cooler 
 Fig.   2
 ,   Page 13
-6 
-  Remove air duct between lock carrier and air 
filter  Fig.  3
 ,   Page 13
-7 
-  Remove retaining clips (if installed) for wiring 
harness on left at radiator shroud. 
Pa
ge 3 of 47 En
gine, disassemblin
g and assemblin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.1 
     
        
        Page 5 of 47
13-5
 
  
Installing  
Installation is carried out in the reverse order of 
removal; note the following:  
 Repair Manual, Body Exterior, Repair Group 63
   
 Repair Manual, Electrical Equipment, Repair 
Group 94
    -  When lock carrier has been installed, check that 
wiring next to radiator is correctly routed. 
-  Adjust limit stop for torque reaction support   
Fig.  4 ,   Page 13
-7 . 
-  Install front bumper.- Adjust headlights.
Pa
ge 5 of 47 En
gine, disassemblin
g and assemblin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.1 
     
        
        Page 11 of 47
13-11
 
  
14 - 
Generator 
Removing:
  - Disconnect battery Ground strap
 - Remove air duct hose to charge air 
cooler. 
 - Loosen ribbed belt and take belt off 
Generator  Page 13
-18
 . 
 - Remove viscous fan and put into radiator 
cowl. 
  - Remove electrical wiring from Generator.
 - Loosen connections for Generator from 
top and bottom and remove Generator. 
Installing:
 - To facilitate attachment of Generator 
slightly drive back thread bushing for 
securing bolt at bracket. 
Pa
ge 11 of 47 En
gine, disassemblin
g and assemblin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.1 
     
        
        Page 30 of 47
13-30
 
    
-  To loosen ribbed belt, turn tensioner in direction of arrow.
-  Remove ribbed belt from Generator pulley.
    
-  Secure pulley for viscous fan with pin punch -1- and remove using 
Allen key -2-. 
-  Remove viscous fan from mounting and put in front of radiator cowl.
-  Remove wiring from rear of Generator.
-  Loosen connections for Generator from top and bottom and remove 
Generator. 
Pa
ge 30 of 47 En
gine, disassemblin
g and assemblin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.1