24-186
If you cannot determine a cause for the DTC
"Powertrain CAN-bus malfunction, check
whether the DTC is caused by one of the
control modules.
All control modules that use the CAN-bus are still
disconnected. Ignition is switched off.
- Connect one of the control modules.
- Connect VAG 1551 scan tool. Switch ignition on,
and erase the DTC memory of the control
module you just connected. End scan tool output
using the "End Output" function 06.
- Switch ignition off and on again.
- Leave ignition on for 10 seconds. Then, read the
DTC memory of the control module you just
connected.
- If the DTC "Powertrain CAN-bus malfunction" is
displayed, replace the control module you just
connected.
- If the DTC "Powertrain CAN-bus malfunction" is
not displayed, connect the next control module
and repeat the procedure.
Pa
ge 25 of 25 Additional si
gnals, checkin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU07.24.5
